Question is ⇒ In a RS flip-flop no change occurs during, Options are ⇒ (A) prohibited mode, (B) set mode, (C) reset mode, (D) disable mode, (E) , Leave your comments or Download question paper.

Question is ⇒ In a RS flip-flop no change occurs during, Options are ⇒ (A) prohibited mode, (B) set mode, (C) reset mode, (D) disable mode, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a RS flip-flop no change occurs during
A.	prohibited mode [Wrong Answer]
B.	set mode [Wrong Answer]
C.	reset mode [Wrong Answer]
D.	disable mode [Correct Answer]
View Answer 2 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following terms is not applicable to Yagi-Uda array?
High gain
Folded dipole
Parasitic elements
Good bandwidth

⇒ SSB stands for
Single Side Band
Suppressed Side Band
Single Sound Band
Single Sky Band

⇒ FM broadcast is done using
medium waves
short waves
VHF and UHF waves
microwaves

⇒

Match the following:

	List I (Processor in C)		List II (Output)
A.	Preprocessor	1.	Source code file
B.	Compiler	2.	Executable code in machine language
C.	Linker	3.	Relocatable object code

A-1, B-2, C-3
A-2, B-3, C-1
A-3, B-2, C-1
A-1, B-3, C-2

⇒ Following state diagram shows clocked sequential circ
6
7
5
4

⇒ The resonant frequency of an R_F amplifier is 1 MHz and its bandwidth is 10 kHz. The Q factor will be
10
100
0.01
0.1

⇒ Which of the following Boolean algebra rules is correct?
A . A = 1
A + AB = A + B
A + A B = A + B
A(A + B) = B

⇒ Find Y in the circuit bel
f₂
f₂
0
∑(0, 1, 2, 3, 5, 6, 9)

⇒ The Fourier transform of f(t) = cos ω₀t is
p[δω₀ + δ(- ω₀)]
p[δ(ω - ω₀) + δ(ω + ω₀)]
p[δω₀ - δ(- ω₀)]
p[δ(ω - ω₀) - δ(ω + ω₀)]

⇒ A signal with ± 10 V ranged and 1 KHz band width is being digitized using a sample and hold circuit and a 10 bit quantizer. The minimum sampling rate is :
62831.9 V/sec
125663.8 V/sec
31415.95 V/sec
None

⇒ The radiation resistance of a resonant long wire antenna of half wavelength (λ/2) is given
73 Ω
120 p
377 Ω
7.3 Ω

⇒ In a dual converter both converters work as rectifiers.
TRUE
FALSE

⇒ Symbol in the given figure is IEEE symbol
AND
OR
NAND
NOR

⇒ If x_k = 2^k for k ≤ 0 and = 0 for k > 0 X(z) = 2/(2 - z).
TRUE
FALSE

⇒ Leak type bias is used in plate modulated class C amplifier to
increase the bandwidth
prevent over modulation
prevent excessive grid current
prevent tuned circuit damping

⇒ In pulse code modulation, if the signal is sampled at the rate of f and the number of pulses in one code group is p, then the number of pulses per second will be
p/f
f/p
1/pf
pf

⇒ Considerable ionization occurs between the range
50 km to 400 km
100 to 400 km
50 km to 250 km
10 to 50 km

⇒ A-P type material has an acceptor ion concentration of 1 x 10¹⁶ per cm³. Its intrinsic carrier concentration is 1.48 x 10¹⁰/ cm. The hole and electron mobilities are 0.05m²/V-sec and 0.13 m²/V-sec respectively calculate the resistivity of the material
12.5 Ω-cm
1.25 Ω-cm
0.125 Ω-cm
125 Ω-cm

⇒ Complex poles give rise to oscillatory terms in the response.
TRUE
FALSE

⇒ The household radio receiver uses
synchronous
envelope detector
radio detector
none of the above

⇒ An audio frequency of 5 kHz is translated to a radio frequency carrier of frequency 1 MHz and transmitted it to space through an antenna. The required height of antenna is
150 m
300 m
75 m
600 m

⇒ Wave guides are pressurised above normal atmospheric pressure for
increasing the power handling capacity
improving conductivity of walls
preventing higher modes from propagation
varying the wave impedance

⇒ As compared to a BJT amplifier circuit, a JFET amplifier circuit
has low input impedance
has high input impedance
has very low input impedance
may have either low or high input impedance

⇒ A JFET
is current controlled device
has low input resistance
has high gate current
is a voltage controlled device

⇒ A JFET behaves as a constant current source when
V_GS = 0
V_GS is less than pinch off voltage
V_GS = V_DS
V_GS is more than pinch off voltage

⇒ A resistance strain gauge has a resistance of about
100 Ω
25 Ω
10 Ω
1 Ω

⇒ In an op-amp a common mode signal is applied to
inverting terminal
non-inverting terminal
both terminals
one or both the terminals

⇒ Which one of the following theorem can be conveniently used to calculate the power consumed by the 10 Ω resistor in the network shown in the above fig
Thevenin's theorem
Maximum power transfer theorem
Millman's theorem
Superposition theorem

⇒ Consider the following in C

Arithmetic operations can be performed on ints.
Arithmetic operations can be performed on floats.
Arithmetic operation can be performed on chars

Which of the above are correct?
All
1 and 2 only
1 and 3 only
2 and 3 only

⇒

Match the following:

	List I		List II
A.	RC coupled amplifier	1.	Very low drift
B.	Tuned amplifier	2.	Flat frequency response from zero frequency onwards
C.	Chopper stabilized amplifier	3.	Flat frequency response with upper and lower cut off frequency
D.	DC amplifier	4.	Peak in gain frequency response

A-4, B-3, C-1, D-2
A-3, B-4, C-2, D-1
A-3, B-4, C-1, D-2
A-4, B-3, C-2, D-1