Question is ⇒ In a RL circuit, the angle, θ by which the current lags the voltage is, Options are ⇒ (A) 0 > θ > - 90°, (B) 90°, (C) 0°, (D) 0 < θ < 90°, (E) , Leave your comments or Download question paper.

Question is ⇒ In a RL circuit, the angle, θ by which the current lags the voltage is, Options are ⇒ (A) 0 > θ > - 90°, (B) 90°, (C) 0°, (D) 0 < θ < 90°, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a RL circuit, the angle, θ by which the current lags the voltage is
A.	0 > θ > - 90° [Wrong Answer]
B.	90° [Wrong Answer]
C.	0° [Wrong Answer]
D.	0 < θ < 90° [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The minimum step size required for a Delta modulator operating at 36 samples/sec to track the signal (here u(t) is the unit step function) x(t) = 125t (u(t) - u(t - 1)) + (250 - 125t) (u(t - 1) - u(t - 2)) So that slope overload is avoided, would be
2^-10
2^-8
2^-6
2^-4

⇒ In an AM wave the carrier and one of the side bands is suppressed. If m = 1, the percentage saving in power is
0.25
0.5
0.666
0.833

⇒ The h parameter h₁₁ is the same in CE and CC circuit.
TRUE
FALSE

⇒ The disturbance from adjacent power lines is known as
cross talk
cross fire
inductive disturbance
none of the above

⇒ The material used for the magnet of moving coil cone type loudspeaker is
steel alloy
soft iron
hard steel
Alnico

⇒

Assertion (A): A JFET can be used as a current source.

Reason (R): In beyond pinch off region the current in JFET is nearly constant.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ The function f(x - v_ot) represent which of the following?
A stationary wave
A wave motion in forward direction
A wave motion in reverse direction
None of the above

⇒ The value of a in a transistor
is always equal to 1
is less than 1 but more than 0.9
is about 0.4
is about 0.1

⇒ The primary colours are
blue and green
blue and red
red and green
blue, red and green

⇒ Two coils X and Y have self inductances of 5 mH and 10 mH and mutual inductance of 3 mH. If the current in coils X change at a steady rate of 100 A/s, the emf induced in coil Y is
0.3 V
0.5 V
1 V
1.5 V

⇒ Absolute permeability (μ) is given by __________ henry/metre
4p x 10^-12
4p x 10^-7
8.854 x 10^-12
8.854 x 10^-7

⇒ An inverting voltage feedback is a
voltage amplifier
current amplifier
current to voltage converter
voltage to current converter

⇒ Full duplex operation-permits transmission in both directions at the same time.
TRUE
FALSE

⇒ A square corner reflector is used in
radio astronomy
tv broadcast
point to point communication
all of the above

⇒ The density of dynamic RAM is
the same as static RAM
less than that of static RAM
more than that of static RAM
either equal or less than that of static RAM

⇒ In the following non-planar graph no.of independent loop equations
8
12
7
5

⇒ In figure, i(t) is a unit step current. The steady state value of v(t
2 V
3 V
6 V
9 V

⇒ The sum of positive real functions
is a positive real function
may be a positive real function or not
can not be a positive real function
either (b) or (c)

⇒ For a transfer function the coefficients of the numerator and denominator polynomials in s must be real.
TRUE
FALSE

⇒ An RC circuit initially at rest has a step signal. The response V(t) across C is V(t) = 1 - e^-at, If now there is an initial voltage on C of 2 volts for the same step signal, V(t) is now
1 + e ^-at
1 + 2e ^-at
2 - e ^-at
3 - e ^-at

⇒

Assertion (A): A transducer needs an output measuring or display device for measuring a non electrical quantity.

Reason (R): In some transducers the output voltage is too small and needs amplification before it can be measured.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ EEPROM permits
read operation only
read and byte erase operations
read, byte erase and byte write operations
read, byte erase, byte write and chip erase operations

⇒ A JK flip flop has t_pd= 12 ns. The largest modulus of a ripple counter using these flip flops and operating at 10 MHz is
16
64
128
256

⇒ A coil has a resistance of 2 Ω and inductance of 0.1 mH. The applied voltages is suddenly increased from 10 V to 20 V. After steady state condition have reached, the current is
0.0833333333333333
more than 2 A but less than 4 A
0.166666666666667
more than 4 A

⇒ A peak responding ac voltmeter using a half wave rectifier has been calibrated to read 1 V for 1 V rms sine wave input. If input is 1 V dc the reading will be
0.707 V
0.707 or 0 V
1.414 V
1.414 or 0 V

⇒ In figure, the value of R shoul
5 kΩ
50 kΩ
20 kΩ
10 kΩ

⇒ Consider the following functions

It detects the AM video carrier IF so as to produce the video signal
It produces and separates out the inter carrier sound IF of 5.5 MHz
It amplifies the video signal
It amplifies the audio signal

The video detector in a colour TV performs which of the above functions
1, 2 and 3
1, 2, 3 and 4
1 and 2
1, 2 and 4

⇒ In a cable with ∈_r = 4, the wave velocity is
3 x 10⁸ m/s
0.75 x 10⁸ m/s
1.5 x 10⁸ m/s
10⁸ m/s

⇒ In N channel MOSFET with gate reverse biased, the gate current is of the order
10^-3 amp
10^-6 amp
10^-9 amp
10^-12 amp

⇒ Which one of following is correct for broadside array?
Direction of radiation is perpendicular to axis
Also perpendicular to the plane
Current is fed of equal amplitude equal phase
All