Question is ⇒ In a ring counter for N clock pulses the scale for the counter is, Options are ⇒ (A) N : 1, (B) N : 2, (C) N : 10, (D) N : 100, (E) , Leave your comments or Download question paper.

Question is ⇒ In a ring counter for N clock pulses the scale for the counter is, Options are ⇒ (A) N : 1, (B) N : 2, (C) N : 10, (D) N : 100, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a ring counter for N clock pulses the scale for the counter is
A.	N : 1 [Correct Answer]
B.	N : 2 [Wrong Answer]
C.	N : 10 [Wrong Answer]
D.	N : 100 [Wrong Answer]
View Answer 1 -5 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Figure represen
Tunnel diode
PNP transistor
Photo sensitive diode
Photo emissive diode

⇒

Assertion (A): A power factor meter operates on dynamometer principle.

Reason (R): A power factor meter does not have a control spring.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ The current through a resistance R is shown in figure. The computed value of power
400 ± 0.42 W
400 ± 4.6 W
400 ± 8.85 W
400 ± 10.65 W

⇒

Assertion (A): A high dv/dt may cause triggering of a thyristor.

Reason (R): A high dv/dt results in charging current in the thyristor.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In monostable multivibrator
has no stable state
has one stable state
has two stable states
switches automatically from one state to other state

⇒ If the network in figure (1), (2) are equivalent at terminals A - B, then voltage V and resistance R
100V and 12 Ω
60V and 12 Ω
100V and 30 Ω
60V and 30 Ω

⇒ The constant M loci on G(s) plane are a family of circles.
TRUE
FALSE

⇒ The most important set of specifications of transformer oil includes
dielectric strength and viscosity
dielectric strength and flash point
flash point and viscosity
dielectric strength, flash point and viscosity

⇒ Point out the wrong statement, Sequential logic circuit is
one that requires a clock to change states
one in which past affects the present states
one whose outputs changes immediately when the inputs change
also called clock logic or synchronous logic

⇒ Due to which of the following reasons, the ground wave eventually disappears, as one moves away from the transmitter?
Tilting
Loss of line-of-eight conditions
Interference from the sky wave
Maximum single hop distance limitation

⇒ DMA stands for
Direct Memory Address
Distributed Memory Address
Direct Memory Accumulator
Decimal Machine Address

⇒ A synchro transmitter receiver unit is a
two phase ac device
3 phase ac device
dc device
1 phase ac device

⇒ Which of the following does not cause losses in optical fibre cables?
Impurities
Microbending
Attenuation in glass
Stepped index operation

⇒ Greatest mobility can be expected in case of
holes
protons
electrons
negative ions

⇒ Which of the following statement regarding the advantages of the phase discriminator over the slope detector is false?
Better linearity
Fewer tuned circuits
Much easier alignment
Greater limiting

⇒ In a p-n-p transistor the main current carriers and the mechanism of flow respectively are
electrons, drift
holes, drift
holes, diffusion
electrons, diffusion

⇒ It is required to measure a low magnitude high frequency current. The proper instrument is
moving iron
dynamometer
thermocouple
induction

⇒ The cut off wavelength λ_c for TE₂₀ mode for a standard rectangles waveguide is
2/a
2a
a
2a²

⇒ It is desired to route data from many registers to one register. The device needed is
decoder
multiplexer
demultiplexer
counter

⇒ In an FM signal, the power
increases as the modulation index increases
reduces as the modulation index increase
increases as the modulation index decreases
remains constant when the modulation index increases

⇒ For stable network, the real part of poles and zeros of driving point function must be
negative
negative or zero
zero
positive

⇒ If F(t) = δ(t - a), F(s)=
0
1
e^-as
e^as

⇒ In voltage amplifiers, the load resistance
should be a small as possible
should be as large as possible
must be equal to output impedance
must be half of output impedance

⇒ The control logic for a binary multiplier is specified by a states diagram. The state diagram has four states and two inputs. To implement it by the sequence register and decoder method.
two flip-flop & 2 x 4 decoder are needed
four flip-flop & 2 x 4 decoder are needed
two flip-flop & 3 x 9 decoder are needed
four flip-flop & 3 x 9 decoder are needed

⇒

Assertion (A): Absolute instruments are used in standard laboratories.

Reason (R): Absolute instruments do not require calibration.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ Consider the following logical IF statement in FORTRAN 77 IF (SALT - PEPPER) 11, 11, 13
IF (SALT - PEPPER) 13, 11, 13
IF (SALT - PEPPER) 13, 11, 11
IF (SALT - PEPPER) 11, 13, 13

⇒ The voltage transfer functions of two port circuits connected in cascade can be easily found from
product of individual ABCD matrices
product of voltage transfer functions of two networks
sum of z matrices
sum of h matrices

⇒ The closing of switch S₁ and S₂ in figure will ligh
lamp L₁ only
lamps L₁ and L₂
none of them
lamp L₂ only

⇒ For oscillations to starts, the loop gain A β of the oscillator must be initially
less than unity
0.5
1
more than unity

⇒ An electron (charge -e) is rotating in a circular orbit of radius R, around a proton with charge +e at a constant angular velocity ω. The orbital magnetic dipole moment is
0.5 eω R²
eω R²
2 eω R²
0.5 eω R³