Question is ⇒ In a receiver, which of the following device has RF input but IF output?, Options are ⇒ (A) Loudspeaker, (B) Frequency changer, (C) Demodulator, (D) Audio amplifier, (E) , Leave your comments or Download question paper.

Question is ⇒ In a receiver, which of the following device has RF input but IF output?, Options are ⇒ (A) Loudspeaker, (B) Frequency changer, (C) Demodulator, (D) Audio amplifier, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a receiver, which of the following device has RF input but IF output?
A.	Loudspeaker [Wrong Answer]
B.	Frequency changer [Correct Answer]
C.	Demodulator [Wrong Answer]
D.	Audio amplifier [Wrong Answer]
View Answer 3 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Match the following:

	List I		List II
A.	Total instantaneous value of emitter current	1.	I_E
B.	Quiescent value of emitter current	2.	i_E
C.	Instantaneous value of as component of emitter current	3.	I_e
D.	RMS value of ac component of emitter current	4.	i_e

A-1, B-2, C-4, D-3
A-2, B-1, C-4, D-3
A-2, B-1, C-3, D-4
A-2, B-3, C-4, D-1

⇒ In INHIBIT operation
output is 1 when both inputs are 0
output is 0 when blocking input is 1
output is 0 when blocking input is 0
output is 1 when blocking input is either 0 or 1

⇒

Assertion (A): PIN diode is used as a fast switch.

Reason (R): PIN diode has very high resistance when reverse biased and very low resistance when forward biased.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ For the K map of the given figure the simplified Boolean expressio
AC + A B
A BC + A B C + A B C + AB C
AC + A B + AC
A C + A B + AB

⇒ Which of these has highly doped p and n region?
PIN diode
Tunnel diode
Schottky diode
Photodiode

⇒ For Bode plot of (1 + jωT) has
slope of 20 dB/decade and phase angle + tan^-1 (ωT)
slope of - 20 dB/decade and phase angle + tan^-1 (ωT)
slope of 20 dB/decade and phase angle - tan^-1 (ωT)
slope of - 40 dB/decade and phase angle - tan^-1(ωT)

⇒ The measure of mismatch between the load and the transmission line is known as
directivity
Gain
standing wave ratio
reflection coefficient

⇒ Current derating may be necessary when thyristors are operating in
series
parallel
series or parallel
none of the above

⇒

Match the following:

	List I (Logic family)		List II (Characteristic)
A.	TTL	1.	Maximum power consumption
B.	ECL	2.	Highest packing density
C.	NMOS	3.	Least power consumption
D.	CMOS	4.	Saturated Logic

A-1, B-4, C-2, D-3
A-1, B-4, C-3, D-2
A-4, B-1, C-2, D-3
A-4, B-1, C-3, D-2

⇒

Assertion (A): Millman's theorem helps in replacing a number of current sources in parallel by a single current source.

Reason (R): Maximum power transfer theorem is applicable only for dc, circuits.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒

Match the following:

	List I (type of controller)		List II (Operation)
A.	Pneumatic controller	1.	Flexible operation
B.	Hydraulic controller	2.	High torque high speed operation
C.	Electronic controller	3.	Fire and explosion proof operation

A-1, B-3, C-2
A-1, B-2, C-3
A-3, B-1, C-2
A-3, B-2, C-1

⇒ An air-filled rectangular waveguide has dimensions 8cm x 10cm . The group velocity is
1.8 x 10⁸ m/s
2.6 x 10⁸ m/s
3 x 10⁸ m/s
0.3 x 10⁸ m/s

⇒ Figure repres
Integrator
Differentiator
High Pass Filter
Band Pass Filter

⇒ Measurement of Hall coefficient enables the determination of
mobility of charge carriers
type of the conductivity and concentration of charge carriers
temperature coefficient and thermal conductivity
fermi level and forbidden energy gap

⇒ The typical squelch circuit
cuts off an IF amplifier when the AGC is maximum
cuts off an IF amplifier when the AGC is minimum
cuts off an audio amplifier when the carrier is absent
eliminates the RF interference when the signal is weak

⇒ When a unit step voltage drives a lag network the output
remains constant at unit step value
increases exponentially from zero to final value
decreases exponentially from 1 to 0
either (b) of (c) depending on values of R and C

⇒ In figure the approximate voltage
base and emitter are - 8 V and - 7.3 V
base and collector are - 8 V and - 5 V
collector and emitter are - 5 V and - 7.3 V
base, emitter and collector are - 8, - 7.3 and - 5 V

⇒ In the given figure, the input frequency is such that R = X_C.
v₀ lags v_i by 45°
v₀ lags v_i by 90°
v₀ leads v_i by 45°
v₀ leads v_i by 90°

⇒ A sine wave of voltage varies from zero to maximum of 200V. How much is the voltage at the instant of 30° of the cycle?
50 V
82.8 V
100 V
173.2 V

⇒ A wavelength of 1 mm could be expected in
VLF
HF
EHF
SHF

⇒ The minterm designation for ABCD is
m₈
m₁₀
m₁₄
m₁₅

⇒ Diffraction of EM waves
arises only with spherical wave front
may occur around the edge of an obstacle
occurs when waves pass through a big slot
none of the above

⇒ A Varactor diode has
a fixed capacitance
a fixed inductance
a voltage variable capacitance
a current variable inductance

⇒ The maximum permissible distance between two samples of a 2 kHz signal is
1000 μ sec
500 μ sec
250 μ sec
2000 sec

⇒ Figure represen
JFET shunt switching circuit
JFET series switching circuit
JFET analog switch
multiplexing

⇒ The function δ' (t-b) is
a step function originating at t = b
an impulse function originating at t = b
a unit doublet originating at = t - b
none of the above

⇒ The noise margin of a TTL gate is about
0.2 V
0.4 V
0.6 V
0.8 V

⇒ A moving coil meter has a shunt of 0.02 Ω resistance. If coil resistance is 1000 Ω and a potential difference of 500 mV is required across it to cause full scale deflection, the current through shunt is
2.5 A
25 A
0.25 A
0.025 A

⇒ A microstrip line has dielectric having relative permittivity ∈_r. The effective dielectric constant is
more than ∈_r
equal to 1
less than ∈_r
either a or b

⇒ In following circuit, steady state is reached with S open, S is closed at t = 0, the current I at t = 0⁺ is give
9 Ω
6 Ω
7 Ω
10 Ω