Question is ⇒ In a radio receiver with simple AGC, Options are ⇒ (A) the highest AGC voltage is produced between stations, (B) the faster the AGC time constant, the more accurate the output, (C) an increase in signal strength produces more AGC, (D) the audio stage gain is normally controlled by AGC, (E) , Leave your comments or Download question paper.

Question is ⇒ In a radio receiver with simple AGC, Options are ⇒ (A) the highest AGC voltage is produced between stations, (B) the faster the AGC time constant, the more accurate the output, (C) an increase in signal strength produces more AGC, (D) the audio stage gain is normally controlled by AGC, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a radio receiver with simple AGC
A.	the highest AGC voltage is produced between stations [Wrong Answer]
B.	the faster the AGC time constant, the more accurate the output [Wrong Answer]
C.	an increase in signal strength produces more AGC [Correct Answer]
D.	the audio stage gain is normally controlled by AGC [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A direct radiating cone type loudspeaker attenuates :
medium range frequencies
very low frequencies
high frequencies
very low and high frequencies

⇒ A 20 Ω resistor, a 1H inductor and 1μF capacitor are connected in parallel the combination is driven by a unit step current. Under the steady state, source current flows through
inductor
capacitor
resistor
all

⇒ Insulation resistance of a cable is directly proportional to its length.
TRUE
FALSE

⇒ Lines of magnetic field attract each other.
TRUE
FALSE

⇒ A copper coil has a resistance of 40 ohm at 20°C. At 100°C the resistance is likely to be
44 Ω
54 Ω
84 Ω
104 Ω

⇒ Transformer coupling is mostly used in
RF amplifier
audio amplifier
both audio and RF amplifier
none of the above

⇒ The input to negative clamper has a peak value of V_p. Then in the output the positive and negative peaks are nearly
0 and -2 V respectively
V_p and -V_p respectively
2 V_p and 0 respectively
none of the above

⇒ Fibers have numerical aperture (NA) in the range of 0.15 to 0.4 Fibers with higher NA value would have
reduced losses
high bandwidth
reduced losses and low bandwidth
more losses and low bandwidth

⇒ The emission of light is LED due to
emission of holes
emission of electrons
generation of electromagnetic radiations
conversion of heat energy into illumination

⇒ The instruction LDA 20 in 8085 means
contents of memory location 20 are fetched into the accumulator
the value 20 is fetched into accumulator
either (a) or (b)
neither (a) nor (b)

⇒ Periodic recharging of the memory cells at regular intervals of 3 to 8 millisecond is required in a
ROM
Static RAM
Dynamic RAM
PLA

⇒ The minor M_ij of an n x n matrix is the determinant of (n - 1) x (n - 1) matrix formed by deleting the ith row and j the column of n x n matrix.
TRUE
FALSE

⇒ In the stabilized reactance modulators AFC system
the discriminator must have a fast time constant to prevent demodulation
the higher discriminator frequency the better the oscillator frequency stability
the discriminator frequency must not be too low, or the system will fail
phase modulation is converted into FM by the equalizer circuit

⇒ In a PCM system, if the code word length is increased from 6 to 8 bits, the signal to quantization noise ratio improves by the factor.
42953
12
16
8

⇒ The resistance of resistance strain gauge is about
5 Ω
50 Ω
120 Ω
0.5 Ω

⇒ The reflection coefficient is generally a
complex number
fraction
imaginary number
none of the above

⇒ The word 'LORAN' means
long range navigation
long range TV transmission
long range cable transmission
either (b) or (c)

⇒ In cell phone antennas are
monopole
loops
helical
lens

⇒ In a ripple counter,
whenever a flip flop sets to 1, the next higher FF toggles
whenever a flip flop sets to 0, the next higher FF remains unchanged
whenever a flip flop sets to 1, the next higher FF faces race condition
whenever a flip flop sets to 0, the next higher FF faces race condition

⇒ Entropy gives
measure of Uncertainty
rate of Information
average information
probability of Information

⇒ An OR gate has 4 inputs. One input is high and the other three are low. The output
is low
is high
is alternately high and low
may be high or low depending on relative magnitude of inputs

⇒ As compared to LED, LASER has

higher emission efficiency
no tuning arrangement
narrow spectral width
provision for confinement

Of these statements
1, 2, 3 are correct
1, 2, 4 are correct
1 and 3 are correct
1, 3, 4 are correct

⇒ As access time is decreased, the cost of memory
remains the same
increases
decreases
may increase or decrease

⇒ Which device can detect the presence of both forward and backward waves in a waveguide?
Filter
Detector
Directional coupler
Magic T

⇒ Out of Metal-film type and Carbon-film type, the one with better tolerance specification is
carbon-film
metal-film type
both have same tolerance
none of these

⇒ For a depletion type NMOS, V_p = - 4 volts. For V_GS = 0, 1_D = 16 mA in the pinch off region of V_DS. For V_GS = - 2, the value of I_D in the pinch off region of V_DS is given by
64 mA
32 mA
16 mA
4 mA

⇒ In a parallel resonant circuit, the circuit current at resonance is maximum.
TRUE
FALSE

⇒ The permanent magnet field system of brushless dc servo- motor is generally on
stator
rotor
partly on stator and partly on rotor
either (a) or (b)

⇒ The block diagram of AM transmitter in which high level modulation is used as shown in figure. The block X could
audio power amplifier
buffer RF amplifier
compressor amplifier
none of the above

⇒ An electron in the conduction band
has higher energy than the electron in the valence band
has lower energy than the electron in the valence band
loses its charge easily
jumps to the top of the crystal