Question is ⇒ In a push pull circuit the two transistors are, Options are ⇒ (A) both pnp, (B) both npn, (C) one pnp and other npn, (D) either (a) or (b), (E) , Leave your comments or Download question paper.

Question is ⇒ In a push pull circuit the two transistors are, Options are ⇒ (A) both pnp, (B) both npn, (C) one pnp and other npn, (D) either (a) or (b), (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a push pull circuit the two transistors are
A.	both pnp [Wrong Answer]
B.	both npn [Wrong Answer]
C.	one pnp and other npn [Correct Answer]
D.	either (a) or (b) [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In 2's complement form, - 2 is
1011
1110
1100
1010

⇒ The directive gain of λ/2 resonant wire is 1.64.
TRUE
FALSE

⇒ In the circuit shown below, the op-amp is ideal, the transistor has V_BE = 0.6 V and β = 150. Decide whether the feedback in the circuit is positive or negative and determine the voltage V at the output of the op
Positive feedback, V = 10 V
Positive feedback, V = 0 V
Negative feedback, V = 5 V
Negative feedback, V = 2 V

⇒ Consider the following
only statement 1 is correct
only statement 2 is correct
both statements are correct
both the statements 1 and 2 are not correct

⇒ A BJT amplifier has a power gain of 0.5 from source to base. The power gain in dB is
-0.3 dB
-3 dB
-6 dB
-10 dB

⇒ Figure shows the V-i characteristics of a material. The material is likely t
copper
carbon
zinc oxide
rubber

⇒ Which op-amp circuit uses a diode as one of the circuit components?
Integrating amplifier
Differentiating amplifier
Logarithmic amplifier
Summing amplifier

⇒ Four messages band limited to W, W, 2W and 3W respectively are to be multiplex using Time Division Multiplexing (TDM). The minimum bandwidth required for transmission of this TDM signal is
W
3W
6W
7W

⇒ Which of the following is correct for a driving point functions?
The real parts of all poles must be negative
The real parts of all poles and zeros must be negative
The real parts of all poles and zeros must be negative or zero
The real parts of all zeros must be negative

⇒ The figure shown below is designed to act as a constant current source across the load resistor. The β of transistor is 50. What is the value of load curr
1.96 mA
2 mA
2.04 mA
None

⇒ Figure represen
LED
Varistor
SCR
Diac

⇒ At 0 K, silicon and germanium behave like monoatomic crystals.
TRUE
FALSE

⇒ Consider the draw backs

Slope overload
Serration noise
Granular noise

Which of these draw backs does Delta modulation have?
1 and 2 only
2 and 3 only
1 and 3 only
1, 2, 3

⇒ In a series RLC high Q circuit the current peaks at a frequency.
equal to the resonant frequency
greater than the resonant frequency
less than the resonant frequency
none

⇒ For a BJT, avalanche multiplication factor depends on
V_CE
V_CB
V_BE
none

⇒ The inverse Fourier transform of δ(t) is
∪(t)
1
δ(t)
e^j2pt

⇒ Which of the following amplifiers has highest output impedance?
CE
CB
CC
Push pull

⇒ For the wave shown in figure, the average valu
7.07 A
0.208333333333333
2.5 A
0.5 A

⇒ A semi converter operates in two quadrants.
TRUE
FALSE

⇒ Octal 16 is equal to decimal
13
14
15
16

⇒ Which of the following circuits can be used as parallel-to-series converter?
Digital counter
Decoder
Demultiplexer
Multiplexer

⇒ If v(t) = 0 for t < 0 and e^-at for t ≥ 0 V(jω) = 1/(a + jω).
TRUE
FALSE

⇒ Modulated carrier power in FM
increases with modulating signal power
decreases with modulating signal power
is independent of the modulating signal power
none

⇒ RC oscillator can be used upto
1 kHz
10 kHz
50 kHz
100 kHz

⇒ In 8085 microprocessor, how many I/O ports can be accessed by direct method?
8
256
32 K
64 K

⇒ Which layer is least important in high frequency propagation?
D layer
E layer
F₁ layer
F₂ layer

⇒ A multilevel decoder is more costly as compared to single level decoder.
TRUE
FALSE

⇒ When the height of a vertical earthed antenna is less than λ/4
the base input impedance will be capacitive
the base input impedance will be purely resistive
the base input impedance will be inductive
the base input impedance will be negligibly small

⇒

Assertion (A): The small signal analysis of a transistor amplifier is done to obtain the current gain, voltage gain and the conversion efficiency of an amplifier.

Reason (R): The small signal analysis of a transistor amplifier uses the small signal parameters of the transistor.

Both A and R are individually true and R is the correct explanation of A
Both A and R are individually true but R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ The number of categories in which registers are classified in μP are
2
3
4
5