Question is ⇒ In a pure sample of silicon, Options are ⇒ (A) the number of holes and free electrons is always equal, (B) the number of free electrons is more than the number of holes, (C) the number of free electrons and holes is equal at low temperature, (D) the number of free electrons is less than number of holes, (E) , Leave your comments or Download question paper.

Question is ⇒ In a pure sample of silicon, Options are ⇒ (A) the number of holes and free electrons is always equal, (B) the number of free electrons is more than the number of holes, (C) the number of free electrons and holes is equal at low temperature, (D) the number of free electrons is less than number of holes, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a pure sample of silicon
A.	the number of holes and free electrons is always equal [Correct Answer]
B.	the number of free electrons is more than the number of holes [Wrong Answer]
C.	the number of free electrons and holes is equal at low temperature [Wrong Answer]
D.	the number of free electrons is less than number of holes [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Laplacian of a scalar function V is
gradient of V
gradient of the gradient of V
divergence of V
divergence of the gradient of V

⇒ The z transform of sequence x[n] = {2, 4, 3, 2}
2z^-1 + 4z^-2 + 3 + 2z⁺¹
2z^-1 + 3 + 4z⁺¹ + + 2z⁺²
2z⁺¹ + 3z^-1 + 4z^-2 + 2z^-3
3 + 2z^-1 + 4z^-2 + 2z^-1

⇒ Radiation efficiency of an antenna is defined as the ratio of
Total power radiated by an antenna to the net power accepted by the antenna from the connected transmitter
The frequency at which minimum power is radiated to the frequency at which maximum power is radiated
Total power accepted from the transmitter to total power generated by the transmitter
Power in main lobe to that in the side lobe

⇒ In which of the following 8085 instructions is the 8 bit number in accumulator adjusted to form two four bit BCD numbers
DAD rp
DAA
DCX rp
ADC M

⇒ Following state diagram shows clocked sequential circ
6
7
5
4

⇒

Match the following:

	List I (Diode Rectifier)		List II (Efficiency is R_f/R_L = 0.25)
A.	Half wave	1.	0.54
B.	Bridge Rectifier	2.	0.65
C.	Full wave using tapped centre transformer	3.	0.325

A-1, B-2, C-3
A-2, B-1, C-3
A-3, B-2, C-1
A-3, B-1, C-2

⇒ Figure shows the V-i characteristics of a material. The material is likely t
copper
carbon
zinc oxide
rubber

⇒ In an RLC series circuit having finite values of RLC, the phase difference between applied voltage and current is
always 0°
between 0 and 180°
between 0 and 90°
always 90°

⇒ When a P-N junction is unbiased, the junction current at equilibrium is
zero as no charges cross the junction
zero as equal number of carriers cross the barrier
mainly due to diffusion of majority carriers
mainly due to diffusion of minority carriers

⇒ A silicon wafer has 100 nm of oxide it and is inserted in a furnace at a temperature above 1000°C for further oxidation in dry oxygen. The oxidation rate
is independent of current oxide thickness and temperature
is independent of current oxide thickness but depends on temperature
slows down as the oxide grows
is zero as the existing oxide prevents further oxidation

⇒ The value of capacitor C for dynamic equalising circuit of series connected thyristors is determined by
forward characteristics of thyristors
reverse recovery characteristics of thyristors
both forward and reverse recovery characteristics of thyristors
none of the above

⇒ For a periodic waveform, the power spectral density and correlation function form
a Laplace transform pair
a Fourier transform pair
either (a) or (b)
neither (a) nor (b)

⇒ The r.m.s. value of a half-wave rectified current is 100 A. Its value for full-wave rectification would be __________ amperes.
141.4
200
200/p
40/p

⇒

Assertion (A): Damping in a vibration galvanometer is small.

Reason (R): Vibration galvanometer is a PMMC instrument.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒

Assertion (A): Hall effect is observed in all metals but is very appreciable in semiconductors.

Reason (R): Hall effect transducer is very suitable for measurement of magnetic flux density.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ A TV. transmitting aerial is fixed on top of a 150 metre tower located on a mountain 1200 m height. The range of transmitter is
51 km
152 km
152 m
51 m

⇒ The transformer cores operating at microwave frequency ranges are generally made up of
silicon steel
ferrites
albino
super alloy

⇒ A Hartley oscillator is used for generation
very low frequency oscillation
radio frequency oscillation
microwave oscillation
audio-frequency oscillation

⇒ Calculate the conductivity of pure silicon at room temperature when the concentration of carriers is 1.6 x 10¹⁰ per cm³. Take μ_e = 1500 cm²/V-sec, μ_h = 500 cm²/V-sec at room temperature,
5.12 x 10^-16
5 x 10⁺¹⁶
10¹⁶
5 x 10²⁰

⇒ A parallel plate capacitor has its length, width and separation doubled. It fringing effects are neglected, to keep the capacitance same, the dielectric constant must be
halved
kept the same
doubled
made 4 times

⇒

Match the following:

	List I (Instrument)		List II (Parameters)
A.	Moving coil galvanometer	1.	High inertia, soft spring control
B.	Ballistic galvanometer	2.	No control, high damping
C.	Vibration galvanometer	3.	Soft spring control, critical damping
D.	Moving coil flux meter	4.	Low inertia, tuned spring control

A-4, B-2, C-3, D-1
A-1, B-3, C-2, D-4
A-2, B-1, C-4, D-3
A-3, B-1, C-4, D-2

⇒ The linear transistor circuits always operate in the
saturation
cut off
active
inactive

⇒ In control systems the output of sensor usually, is
analog electrical signal
digital electrical signal
mechanical signal
analog or digital electrical signal

⇒ Which of the following features is not associated with Nichols chart?
(0 dB, -180°) point on Nichols chart represent critical Point (-1, 0)
It is symmetric about -180°
M loci are centred about (0 dB, -180°) point
The frequency at intersection of G(jω) locus and M = +3 dB locus gives bandwidth of closed loop system

⇒ A system is highly oscillatory if
gain margin is high
gain margin is close to 1
gain margin is close to 1 or phase margin is zero
gain margin is high and phase margin is 180°

⇒ In a loss line R_L < Z₀, then
Reflection coefficient is zero
Reflection coefficient is ∞
Reflection coefficient is negative
Reflection coefficient is positive

⇒ A n-port network is said to be active if power in the ckt is __________ .
P > 0
P < 0
P = 0
P = ∞

⇒ Piezoelectric effect can be used to measure
force
strain
acceleration
all of the above

⇒ With four Boolean variables, how many Boolean expressions can be performed?
16
256
1024 (1 K)
64K (64 x 1024)

⇒ In a certain inverter circuit each thyristor carries 26.67 A for 60°, 13.33 A for 120° and zero A for 180° of the cycle. The rms current of thyristor is
20 A
13.33 A
6.67 A
3.33 A