Question is ⇒ In a P-N-P transistor, electrons flow, Options are ⇒ (A) into the transistor at the collector only, (B) into the transistor at the base and the collector leads, (C) out of the transistor at base and collector leads, (D) out of the transistor at base, collector as well as emitter leads, (E) , Leave your comments or Download question paper.

Question is ⇒ In a P-N-P transistor, electrons flow, Options are ⇒ (A) into the transistor at the collector only, (B) into the transistor at the base and the collector leads, (C) out of the transistor at base and collector leads, (D) out of the transistor at base, collector as well as emitter leads, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a P-N-P transistor, electrons flow
A.	into the transistor at the collector only [Wrong Answer]
B.	into the transistor at the base and the collector leads [Correct Answer]
C.	out of the transistor at base and collector leads [Wrong Answer]
D.	out of the transistor at base, collector as well as emitter leads [Wrong Answer]
View Answer 2 -5 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a stop-and-wait ARQ system, the transmitting terminal
waits for positive or negative acknowled-gement from the receiving terminal after sending a block
sends another block if positive acknowledge is received through ACK character
resends the previous block if negative acknowledgement is received through a NAK character
does not wait for acknowledgement after sending a block

⇒ In a single phase full wave regulator feeding R-L load, the minimum firing angle can be zero.
TRUE
FALSE

⇒ When a plane wave travelling in free space is incident normally on a medium having ε_r = 4.0, then fraction of power transmitted into the medium is given by
42956
42737
42738
42861

⇒ A wire strain gauge has a gauge factor of 2, resistance of 125 Ω and length 1 m. If length of wire changes by .005 m, change in resistance will be
0.25 Ω
0.5 Ω
1.25 Ω
2.5 Ω

⇒ In a transistor the minimum and maximum values of β_dc are 100 and 121. The proper value of β_dc to be used to locate Q point is
100
121
110.5
110

⇒ For real values of x, the minimum value of the function f(x) exp (x) + exp (- x) is
2
1
0.5
0

⇒ In 8085 microprocessor, which of the following interrupts has the lowest priority?
RST 5.5
RST 7.5
TRAP
INTR

⇒ In calculating input impedance, the load impedance is considered to be connected at the output.
TRUE
FALSE

⇒ In figure, the switch is initially open. At t = 0 switch is closed. v_c (0⁺) and i_L (0⁺)
60 V and - 0.3 A
150 V and zero
zero and 0.3 A
90 V and - 0.3 A

⇒ In radar system which of the following is called A scope
deflection modulation of CRT
intensity modulation of CRT
computer display
none of the above

⇒ In a series R-L-C circuit at the resonant frequency the
current is maximum
current is minimum
impedance is maximum
voltage is maximum

⇒ In radar systems PRF stands for
Power Return Factor
Pulse Return Factor
Pulse Repetition Frequency
Pulse Response Factor

⇒ Which of the following statement about receivers is false?
Double conversion is used to improve image rejection
Double conversion is used to improve selectivity
Variable sensitivity is used to improve selectivity
Variable sensitivity is used to eliminate selective fading

⇒ For the network shown, determine z₁ , z₀ and A_{vz_i = 1.067 Ω; z₀ = 3 kΩ; A_v = 280
z_i = 1.067 Ω; z₀ = 3 kΩ; A_v = - 280.37
z_i = 937 Ω; z₀ = 3 Ω; A_v = 281
z_i = 937 Ω; z₀ = 33 kΩ; A_v = - 280.37}

⇒ In the circuit shown in the given figure, the current flowing through resistance of 100 Ω woul
8 mA
10 mA
20 mA
100 mA

⇒ The number of doped regions in PIN diode is
1
2
3
1 or 2

⇒ Human body cannot sustain electric current beyond
1 μA
10 μA
5 μA
35 μA

⇒ MOSFET can be used as a
current controlled capacitor
voltage controlled capacitor
current controlled inductor
voltage controlled inductor

⇒ Saturation region of a JFET is also known as
source region
analog region
pinch off region
ohmic region

⇒ In FM signal with a modulation index m_f is passed through a frequency tripler. The wave in the output of the tripler will have a modulation index of
m_f
3m_f
m_f/3
m_f/9

⇒ In a network
Number of links = Number of branches - number of nodes + 1
Number of links = Number of branches - number of nodes
Number of links = Number of branches - number of nodes - 1
Number of links = Number of branches - number of nodes - 2

⇒ In which of the following frequency bands are the standard AM radio broadcast stations?
MF
HF
VHF
UHF

⇒ Which amplifier has a voltage gain of less than 1?
Common emitter
Common collector
Common base
Both CB and CC

⇒ If A = 10 + j then log_eA is
14.14 ∠45°
200 ∠45°
2.65 + j45°
2.65 + j0.785

⇒ Presently, the worlds's largest and most advanced multi-purpose communication satellite is
INSAT-2
Intelsat-V
INSAT-ID
Olympus-I

⇒ An amplifier of passband 450 kHz to 460 kHz will be named as
video amplifier
audio frequency amplifier
tuned voltage amplifier
wideband amplifier

⇒ A two branch parallel tuned circuit has a coil of resistance 100 Ω and inductance 0.005 H in one branch and 10 nF capacitor in the second branch. At resonance frequency, the dynamic resistance is
1 Ω
10 Ω
100 Ω
more than 100 Ω

⇒ When a circuit is excited by ac sinusoidal source, the admittance is obtained by letting s = jω in Y(s).
TRUE
FALSE

⇒ A CE amplifier has r_e = 6 Ω, β = 100 and a = 0.98. The input impedance is
6 Ω
100 Ω
600 Ω
98 Ω

⇒ An R-L circuit has an initial current of 5 A. In the s-domain equivalent circuit, the voltage source to take into account the initial current has a strength of
5L volts
5/L volts
5L² volts
5/L² volts