Users Also Read
MCQ's Search Engine
Electrical Engineering
Mechanical Engineering
Civil Engineering
Automobile Engineering
Chemical Engineering
Computer Engineering
Electronics Engineering
Medical Science Engg
In a phase discriminator f_{c}, is the IF to which primary circuit is tuned. Consider the following statements: The primary and secondary voltages are
| |
A. | 1 only [Correct Answer] |
B. | 1 and 2 [Wrong Answer] |
C. | 1, 2 and 3 [Wrong Answer] |
D. | 2 and 3 [Wrong Answer] |
View Answer
Explanation:-
Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result |
Also Read Similar Questions Below :
⇒ In a single phase power factor meter the phase difference between currents in the two pressure coils is
exactly 0°
approximate 0°
exactly 90°
approximate 90°
⇒ Dual slope ADC uses an op amp comparator.
TRUE
FALSE
⇒ A receiver has poor selectivity. It will also have poor
sensitivity
double spotting
blocking
diversity reception
⇒ Which display device resembles vacuum tube?
LED
LCD
VF
None of these
⇒ The Boolean function A + BC is a reduced form of
AB + BC
(A + B) . (A + C)
AB + ABC
(A + C) . B
⇒ The electric energy required to raise the temperature of a given amount of water is 1000 kWh. If heat losses are 25%, the total heating energy required is __________ kWh.
1500
1250
1333
1000
⇒ In 8085
all operations are on 8 bit data
majority of operations are on 8 bit data
all operations are on 8 bit or 4 bit data
either (a) or (c)
⇒ A sinusoidal carrier voltage, having frequency 1000 Hz is amplitude modulated by a sinusoidal voltage of frequency 15 kHz. The frequency of upper and lower sidebands will be
1015 kHz and 985 kHz
1030 kHz and 970 kHz
13 kHz and 17 kHz
14 kHz and 16 kHz
⇒ For wired AND connection we should use
TTL gates with active pull up
TTL gates with open collector
TTL gates without active pull up and with open collector
any of the above
⇒
Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true
⇒ Maxterm designation for A + B + C is
M_{0}
M_{1}
M_{3}
M_{4}
⇒ In a radio receiver, the local oscillator is tuned to a frequency
lower than the incoming frequency
higher than the incoming frequency
equal to incoming frequency
any of the above
⇒ The minority carrier life time and diffusion constant in a semiconductor material are respectively 100 microsecond and 100 cm^{2}/sec. The diffusion length is
0.1 cm
0.01 cm
0.0141 cm
1 cm
⇒ In a series circuit with X_{L} constant and R variable the current locus lies in the third quadrant.
TRUE
FALSE
⇒ The number of logic or arithmetic operations with
4
8
16
32
⇒ The household energy meter is
indicating instrument
recording instrument
integrating instrument
none of the above
⇒ A delta connection contains three impedances of 60 Ω each. The impedances of equivalent star connection will be
15 Ω
20 Ω
30 Ω
40 Ω
⇒ The symbol in figure is
SUS
SBS
SCS
None of the above
⇒ The mean life time of the minority carriers is in the range of a few
seconds
milli seconds
micro seconds
nano seconds
⇒ Each cell of a static Random Access memory contains
6 MOS transistor
4 MOS transistor, 2 capacitor
2 MOS transistor, 4 capacitor
1 MOS transistor and 1 capacitor
⇒ T-flip-flop is commonly used as
a delay switch
a digital counter only
a digital counter and frequency divider
any of the above
⇒ Given two numbers A and B in sign magnitude representation in an eight bit format A = 00011110 and B = 10011100 then A ⊕ B gives
10000010
11111
10011101
11100001
⇒ In a waveguide the dielectric region is generally
air
magnetic material
brass
mica
⇒ For circuit in figure, which combination of V_{TH} and R_{TH} represents the circuit as seen from ab<
1 V, 10 Ω
1 V, 1000 Ω
1 mV, 1000 Ω
1 mV, 10 Ω
⇒ Which of these commutation methods is used in AC-DC converters?
Class A
Class C
Class D
Class F
⇒ The minimum permissible size of aluminium cable for lighting circuit is
1.2 sq. mm
1.5 sq. mm
2.2 sq. mm
3.5 sq. mm
⇒ Drain feedback bias is often used with
D MOSFETs
E MOSFETs
both D and E MOSFETs
neither D nor E MOSFETs
⇒ An RLC series circuit has R = 7.07 Ω, L = .707 H and C = 7.07 μF. At Half power frequencies the circuit impedance is likely to be
7.07 Ω
10 Ω
14.14 Ω
20 Ω
⇒ The dimensions of EMF are
ML^{2}I^{-1}T^{-3}
M^{-1}T^{-3}
ML^{2}I^{-2}T^{-3}
ML^{3}I^{-1}T^{-3}
⇒ Form factor for a sine wave is
1.414
0.707
1.11
0.637
⇒ In a single phase power factor meter the phase difference between currents in the two pressure coils is
exactly 0°
approximate 0°
exactly 90°
approximate 90°
⇒ Dual slope ADC uses an op amp comparator.
TRUE
FALSE
⇒ A receiver has poor selectivity. It will also have poor
sensitivity
double spotting
blocking
diversity reception
⇒ Which display device resembles vacuum tube?
LED
LCD
VF
None of these
⇒ The Boolean function A + BC is a reduced form of
AB + BC
(A + B) . (A + C)
AB + ABC
(A + C) . B
⇒ The electric energy required to raise the temperature of a given amount of water is 1000 kWh. If heat losses are 25%, the total heating energy required is __________ kWh.
1500
1250
1333
1000
⇒ In 8085
all operations are on 8 bit data
majority of operations are on 8 bit data
all operations are on 8 bit or 4 bit data
either (a) or (c)
⇒ A sinusoidal carrier voltage, having frequency 1000 Hz is amplitude modulated by a sinusoidal voltage of frequency 15 kHz. The frequency of upper and lower sidebands will be
1015 kHz and 985 kHz
1030 kHz and 970 kHz
13 kHz and 17 kHz
14 kHz and 16 kHz
⇒ For wired AND connection we should use
TTL gates with active pull up
TTL gates with open collector
TTL gates without active pull up and with open collector
any of the above
⇒
Assertion (A): In a CRT, grid is kept at negative potential with respect to cathode.
Reason (R): The function of grid in an electronic tube is to control the number of electrons.
Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true
⇒ Maxterm designation for A + B + C is
M_{0}
M_{1}
M_{3}
M_{4}
⇒ In a radio receiver, the local oscillator is tuned to a frequency
lower than the incoming frequency
higher than the incoming frequency
equal to incoming frequency
any of the above
⇒ The minority carrier life time and diffusion constant in a semiconductor material are respectively 100 microsecond and 100 cm^{2}/sec. The diffusion length is
0.1 cm
0.01 cm
0.0141 cm
1 cm
⇒ In a series circuit with X_{L} constant and R variable the current locus lies in the third quadrant.
TRUE
FALSE
⇒ The number of logic or arithmetic operations with
ALU 1C 74181
can carry out is4
8
16
32
⇒ The household energy meter is
indicating instrument
recording instrument
integrating instrument
none of the above
⇒ A delta connection contains three impedances of 60 Ω each. The impedances of equivalent star connection will be
15 Ω
20 Ω
30 Ω
40 Ω
⇒ The symbol in figure is
SUS
SBS
SCS
None of the above
⇒ The mean life time of the minority carriers is in the range of a few
seconds
milli seconds
micro seconds
nano seconds
⇒ Each cell of a static Random Access memory contains
6 MOS transistor
4 MOS transistor, 2 capacitor
2 MOS transistor, 4 capacitor
1 MOS transistor and 1 capacitor
⇒ T-flip-flop is commonly used as
a delay switch
a digital counter only
a digital counter and frequency divider
any of the above
⇒ Given two numbers A and B in sign magnitude representation in an eight bit format A = 00011110 and B = 10011100 then A ⊕ B gives
10000010
11111
10011101
11100001
⇒ In a waveguide the dielectric region is generally
air
magnetic material
brass
mica
⇒ For circuit in figure, which combination of V_{TH} and R_{TH} represents the circuit as seen from ab<
1 V, 10 Ω
1 V, 1000 Ω
1 mV, 1000 Ω
1 mV, 10 Ω
⇒ Which of these commutation methods is used in AC-DC converters?
Class A
Class C
Class D
Class F
⇒ The minimum permissible size of aluminium cable for lighting circuit is
1.2 sq. mm
1.5 sq. mm
2.2 sq. mm
3.5 sq. mm
⇒ Drain feedback bias is often used with
D MOSFETs
E MOSFETs
both D and E MOSFETs
neither D nor E MOSFETs
⇒ An RLC series circuit has R = 7.07 Ω, L = .707 H and C = 7.07 μF. At Half power frequencies the circuit impedance is likely to be
7.07 Ω
10 Ω
14.14 Ω
20 Ω
⇒ The dimensions of EMF are
ML^{2}I^{-1}T^{-3}
M^{-1}T^{-3}
ML^{2}I^{-2}T^{-3}
ML^{3}I^{-1}T^{-3}
⇒ Form factor for a sine wave is
1.414
0.707
1.11
0.637