Question is ⇒ In a PCM system, if we increase the quantization levels from 2 to 8, how do the relative bandwidth requirements vary?, Options are ⇒ (A) Get doubled, (B) Get tripled, (C) Remains same, (D) Become eight times, (E) , Leave your comments or Download question paper.

Question is ⇒ In a PCM system, if we increase the quantization levels from 2 to 8, how do the relative bandwidth requirements vary?, Options are ⇒ (A) Get doubled, (B) Get tripled, (C) Remains same, (D) Become eight times, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a PCM system, if we increase the quantization levels from 2 to 8, how do the relative bandwidth requirements vary?
A.	Get doubled [Wrong Answer]
B.	Get tripled [Correct Answer]
C.	Remains same [Wrong Answer]
D.	Become eight times [Wrong Answer]
View Answer 2 -2 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In an amplifier circuit the emitter is at ac ground potential in a
CB circuit
CC circuit
CE circuit
both CB and CE circuit

⇒ The number of lobes on each side of a 31 resonant antenna will be
2
3
4
6

⇒ ADC 0804 is a
dual slope A/D converter
single slope A/D converter
successive approximation A/D converter
either (a) or (b)

⇒ Quantizing error occurs in
TDM
FDM
PCM
PWD

⇒ A periodic voltage has following values for equal time intervals changing suddenly from one value to next, 0, 5, 10, 20, 50, 60, 50, 20, 10, 5, 0, -5, -10 etc. then rms value of the waveform is
31 volt
32 volt
insufficient data
none

⇒ It is desired to couple a coaxial line to a two parallel wire line. It is best to use
quarter wave transformer
balun
slotted line
directional coupler

⇒ An arbitrary signal m (t) has zero average value and it is bandlimited to 3.2 kHz. It is sampled at the rate of 8 K samples/S. The samples are passed through an ideal bandpass filter with centre frequency of 32 kHz and bandwidth of 6.4 kHz. The output of band pass filter is
AM-DSB signal with suppressed carrier
AM-DSB signal with carrier
AM-SSB signal with carrier
a sequence of exponentially decaying sine waves

⇒ The current i(t) through a 10 Ω resistor in series with an inductance is given by i(t) = 3 + 4 sin (100t + 45°) + 4 sin (300t + 60°) Amperes. The RMS value of the current and the power dissipated in the circuit are
41 A, 410 W respectively
35 A, 350 W respectively
5 A, 250 W respectively
11 A, 1210 W respectively

⇒ In a single stage differential amplifier, the output offset voltage is mainly dependent on the mismatch of
V_BE, I_B and β
V_BE and I_B
I_B and β
V_BE and β

⇒ The peak factor is the ratio of
peak and rms values
peak and average values
rms and average values
none of the above

⇒ An FM transmitter delivers 80W to a load of 30 W when no modulation is present. The carrier is now frequency modulated by a single sinusoidal signal and the peak frequency deviation is so adjusted to make the amplitude of the second sideband is zero in the given out
5.12 W
21.78 W
2.56 W
16.81 W

⇒ Ferrites are
ferromagnetic materials
ferrimagnetic materials
ferroelectric materials
ferri-ferromagnetic materials

⇒ In a 100% amplitude modulated signal, the power in the upper sideband when carrier power is to be 100 W and modulation system SSBSC, is
100 W
66 W
50 W
25 W

⇒ A pre-emphasis circuit
boosts base frequencies
pre amplifies the complete audio band
amplifies higher audio frequencies
converts FM into phase modulation

⇒ Assuming accumulator contain A 64 and the carry is set (1). What will register A and (CY) contain after CMA?
6 AH, 1
6 AH, 0
59 H, 0
9 H, 0

⇒ Industrial heating furnaces such as arc and induction furnaces operate on __________ power factor
low leading
low lagging
high leading
very low lagging

⇒ A direct current can be measured
directly by dc potentiometer
by dc potentiometer in conjunction with a standard resistance
by dc potentiometer in conjunction with volt ratio box
none of the above

⇒ If the operating temperature increases by 10°C, the rate of deterioration of solid dielectric becomes
double
one and a half time
3 times
4 times

⇒ A transmission line of characteristic impedance z₀ = 50 Ω. Phase Velocity = 2 x 10⁸ m/sec, and length l = 1 m is terminated by a load z₁ = (30 - j 40) ohms. The input impedance of the line for a frequency of 100 MHz will be
(30 + j x 40) Ω
(30 - j 40) Ω
(50 + j x 40) Ω
(50 - j 40) Ω

⇒ Trinitron is a monochrome picture tube.
TRUE
FALSE

⇒ Which of the following is not a wideband antenna?
Marconi
Discone
Helical
Folded dipole

⇒ Unit of e is __________ .
coulomb/newton-metre
coulomb²/newton-metre
Farad/metre
Farad²/metre

⇒ In figure what is the base current if V_BE = 0
10 mA
9.3 mA
10 μA
9.3 μA

⇒ __________ will have the least value of relative permeability.
Palladium
Silver
Cobalt
Iron

⇒ Which of the following are useful in comparing the noise performance of receivers?

Input noise voltage
Noise figure
Noise resistance
Noise temperature

Select answer as per the following codes:
1, 2 and 3
1, 3 and 4
2, 3, 4
1, 2, 4

⇒ The charges between a hollow and solid metal spheres reside
through out in both
on outer surface in hollow and through out in solid
on the outer surface in both
none of the above

⇒ The VLF, LF and MF antennas are
horizontally polarized
vertically polarized
non linearly polarized
either (a) or (b)

⇒ The integral of a unit step function is
an impulse function
a ramp function
a ramp function of slope 1
none of these

⇒ In the given figure shows a 3 bit shift register using TTL flip flops. Initially all the flip flops are set to 0 state. After 8 clock pul
A = 1, B = 1, C = 1
A = 1, B = 1, C = 0
A = 0, B = 1, C = 1
A = 0, B = 0, C = 1

⇒ The interface chip for 8086 and 16 bit ADC is
8259
8255
8253
8251