Question is ⇒ In a NAND SR latch S = 0, R = 1 then, Options are ⇒ (A) Q = 0, (B) Q = 1, <span style="text-decoration:overline;">Q</span> = 0, (C) it is race condition, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ In a NAND SR latch S = 0, R = 1 then, Options are ⇒ (A) Q = 0, (B) Q = 1, <span style="text-decoration:overline;">Q</span> = 0, (C) it is race condition, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a NAND SR latch S = 0, R = 1 then
A.	Q = 0 [Wrong Answer]
B.	Q = 1, Q = 0 [Correct Answer]
C.	it is race condition [Wrong Answer]
D.	none of the above [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a digital voltmeter the oscillator frequency is 400 kHz and the ramp voltage falls from 8 V to 0 V in 20 ms. What is the number of pulses counted by the counter?
800
2000
4000
8000

⇒ A transistor in CE mode is in saturation region. Then the collector is almost at
ground potential
a potential equal to V_CC
a potential equal to 0.5 V_CC
a potential equal to 2 V_CC

⇒ An increase in junction temperature of a semiconductor diode
causes a small increase in reverse saturation current
causes a large increase in reverse saturation current
does not affect reverse saturation current
may cause an increase or decrease in reverse saturation current depending on rating of diode

⇒ A line is excited by a 100 V dc source. If reflection coefficients at both ends are 1 each then
there will be no oscillations on line
there will be only 1 or 2 oscillations on line
there will be a finite number of oscillations on line
the oscillations will continue indefinitely

⇒ In a broadcast superheterodyne receiver
the local oscillator operates below the signal frequency
local oscillator frequency is normally double the IF
RF amplifier normally works at kHz above the carrier frequency
mixer input must be tuned to the signal frequency

⇒ Fourier transform F(jω) of an arbitrary signal has the property
F(jω) = F(- jω)
F(jω) = - F(- jω)
F(jω) = F*(- jω)
F(jω) = - F*(jω)

⇒ Which of the following is a computer language?
MS WORD
Page maker
MS EXCEL
LISP

⇒ An RL impedance function can also be realized as
RC impedance function
RC admittance function
LC impedance function
LC admittance function

⇒ If V = 4 in the figure, the value of I_S is given
0.25
5/2 A
0
None of these

⇒

Assertion (A): TWT uses a focussing mechanism to prevent the electron beam from spreading.

Reason (R): In a TWT the electron beam has to travel a much longer distance than in klystron.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In a mod-12 counter the input clock frequency is 10 kHz. The output frequency is
0.833 kHz
1.0 kHz
0.91 kHz
0.77 kHz

⇒ The coil of a moving coil meter has 100 turns, is 40 mm long and 30 mm wide. The control torque is 240 x 10^-6 N-m on full scale. If B = 1 Wb/m², range of meter is
1 mA
2 mA
3 mA
4 mA

⇒ The skip distance does not depends upon
the power transmitted
type of wave propagation
angle of beaming of the wave
frequency of the signal transmitted

⇒ Noise generated in a resistor is also known as
partition noise
white noise
thermal noise
shot noise

⇒ Leakage current approximately doubles for every 10°C increase in the temperature of a transistor has I_CBO = 400 nA at 25°C, then its leakage current at 80°C
10 μA
18 μA
20 μA
15 μA

⇒ A machine cycle has one clock cycle.
TRUE
FALSE

⇒ Which of the following instructions have only one operand?
Multiply
Add
Shift
Subtract

⇒ For formation of state equations, resistance of the circuit
should be in tree
should be in cotree
may be in tree or cotree
none of the above

⇒ The interface chip for 8086 and 16 bit ADC is
8259
8255
8253
8251

⇒ The total inductance of two coils is 60 mH in series aiding connection and 40 mH in series opposing connection. The mutual inductance between coils is
20 mH
10 mH
5 mH
2.5 mH

⇒ The currents fed to the two dipoles of turnstile antenna are
in phase
in quadrature
in phase opposition
either (a) or (c)

⇒ In a degenerate n type semiconductor material, the Fermi level,
is in valence band
is in conduction band
is at the centre in between valence and conduction bands
is very near valence band

⇒ For a stable system having two or more gain crossover frequencies the phase margin is measured
at lowest gain crossover frequency
at highest gain crossover frequency
at the gain crossover frequencies
none of the above

⇒ The current gain of a BJT is
g_m r₀
g_m/r₀
g_m r_p
g_m/r_p

⇒

Assertion (A): In totem pole output the output impedance is low.

Reason (R): TTL gate with active pull up should not be used in wired AND connection.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒

Assertion (A): 2's complement arithmetic is preferred in digital computers

Reason (R): The hardware required to obtain 2's complement is simple.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ An amplifier without feedback has a voltage gain of 50, input resistance of 1 kΩ and output resistance of 2.5 kΩ. The input resistance of the current shunt -ve feedback amplifier using the above amplifier with a feedback factor of 0.2 is
1/11 kΩ
1/5 kΩ
5 kW
11 kW

⇒ The Hilbert transform of cos ω₁t + sin ω₂t is
sin ω₁t + cos ω₂t
sin ω₁t - cos ω₂t
cos ω₁t - cos ω₂t
- sin ω₁t + cos ω₂t

⇒

Assertion (A): Mnemonics are used in assembly level program.

Reason (R): Computer cannot understand mnemonics.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ An 8-bit microprocessor has 16 bit address bus A₀ - A₁₅. The processor addresses a 1-K byte memory chip as shown. The address range for the chi
(F00F)_H TO (F40E)_H
(F000)_H TO (F3FF)_H
(F100)_H TO (F4FF)_H
(F700)_H TO (FAFF)_H