Question is ⇒ In a metal, the drift velocity of electrons in the presence of a electric field E is, Options are ⇒ (A) proportional to E, (B) proportional to E, (C) inversely proportional to E, (D) proportional to E2, (E) , Leave your comments or Download question paper.

Question is ⇒ In a metal, the drift velocity of electrons in the presence of a electric field E is, Options are ⇒ (A) proportional to E, (B) proportional to E, (C) inversely proportional to E, (D) proportional to E2, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a metal, the drift velocity of electrons in the presence of a electric field E is
A.	proportional to E [Correct Answer]
B.	proportional to E [Wrong Answer]
C.	inversely proportional to E [Wrong Answer]
D.	proportional to E² [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A single-sideband (SSB) signal contains 3 kW. The power content of the carrier is __________ kW.
2
2
3
0

⇒ Which of the following instruction modes does not exist in microprocessor 8085?
Inherent
Immediate
Absolute
Indirect

⇒ 7BF₁₆ = __________ ₂
0111 1011 1110
0111 1011 1111
0111 1011 0111
0111 1011 0011

⇒ Which of the following is true as regards photo emission?
Velocity of emitted electrons is dependent on light intensity
Rate of photo emission is inversely proportional to light intensity
Maximum velocity of electron increases with decreasing wave length
Both holes and electrons are produced

⇒ In the circuit shown, the steady state is reached with S open S is closed at t = 0, the current I in the 1 Ω resistor connected is to be determined at t = 0⁺ is give
1
2
3
42828

⇒ Consider the following statements about a good power supply:

The a.c. ripple should be high
S_v, (Voltage stability factor) should be low
S_T, (Temperature stability factor) should be low

Which of the above statements are correct?
1, 2 and 3
2 only
3 only
2 and 3 only

⇒ The logic function f(A B, C) = Σm(0, 2, 4, 5, 6) represente
i
i, ii
i, iii
i, ii, iii

⇒ The dimension of flux density is
MT^-1Q^-1
MT^-2
MT¹Q¹
MT^-1Q^-2

⇒ As applied to a flip flop the word edge triggered's means
flip flop can change state when clock transition occurs
flip flop can change state when clock signal goes from LOW to HIGH only
flip flop can change state when clock signal goes from HIGH to LOW only
none of the above

⇒ Java's syntax is based on
C
C + +
Fortran 77
Pascal

⇒ The inputs to a 4 channel MUX have the following bandwidths. Channel 1-50 Hz, channel 2-200 Hz. Channel 3-75 Hz. Channel 4-90 Hz. The theoretical minimum sampling rate of the MUX is
200 Hz
400 Hz
415 Hz
1600 Hz

⇒ The polar plot for positive frequencies is shown below. The gain margi
- 8.02 dB
6.02 dB
5 dB
none of these

⇒ A single phase electric heater uses phase controlled thyristors. The firing angle is 90°. The degree of heating is
25% of maximum
50% of maximum
75% of maximum
none of the above

⇒ Pagemaker is an application software for DTP.
TRUE
FALSE

⇒ 8085 has 6 sign flags.
TRUE
FALSE

⇒ With an ac input from 50 Hz power line, the ripple frequency is
50 Hz in the dc output of half wave as well as full wave rectifier
100 Hz in the dc output of half wave as well as full wave rectifier
50 Hz in the dc output of half wave and 100 Hz in the dc output of full wave
100 Hz in the dc output of half wave and 50 Hz in the dc output of full wave

⇒

Assertion (A): A tree of graph contains all the nodes of the graph.

Reason (R): The number of links is always less than the number of tree branches.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ When the emitter current of a transistor is changed by 1 mA, its collector current changes by 0.990 mA. The common-emitter short-circuit current gain is
1
199
99
9.9

⇒ When P_c is the unmodulated carrier power and P_t is the total power in the modulated wave, then the maximum power in AM wave is
P_t = 1.5 P_c
P_t = 2.5 P_c
P_t = 2
P_t = 22 P_c

⇒ As per Euler's identity e^jωt = cos ωt + j sin ωt
TRUE
FALSE

⇒ For a high pass filter, β = p in attenuation band.
TRUE
FALSE

⇒ At very high temperatures the extrinsic semi conductors become intrinsic because
drive in diffusion of dopants and carriers
band to band transition dominants over impurity ionization
impurity ionization dominants over band to band transition
band to band transition is balanced by impurity ionization

⇒ High IF in a superheat receiver
improves selectivity
increases tracking problems
decreases tracking problems
reduces adjacent channel rejection

⇒ At room temperature the current in an intrinsic semiconductor is due to
holes
electrons
ions
holes and electrons

⇒ The circuit of the given figur
full adder
magnitude comparator
parity detector
none of the above

⇒ A function will have only sine terms if
f(t) = - f(t)
f(-t) = f(t)
f(-t) = -f(t)
none of the above

⇒ If poles lie in first quadrant, damping ratio is
1
more than 1
less than 1
zero

⇒

Assertion (A): In class C amplifier the efficiency is more than that for other classes of amplifiers

Reason (R): In class C amplifier we can get high efficiency over a wideband

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ The inputs to a 3 bit binary adder are 111₂ and 110₂. The output will be
101
1101
1111
1110

⇒ Consider the following statements

The sign of a floating point number depends on the sign of mantissa only.
If the absolute value of a number is less than 1, the sign of exponent is zero or positive.
With sign bit of mantissa as 0, increasing the exponent from a positive to a more positive value gives a larger floating point number.

Which of the above are correct?
All
1 and 2 only
1 and 3 only
2 and 3 only