Question is ⇒ In a mechanical accelerometer, the steady state displacement is a measure of, Options are ⇒ (A) constant input acceleration, (B) constant input velocity, (C) either (a) or (b), (D) neither (a) nor (b), (E) , Leave your comments or Download question paper.

Question is ⇒ In a mechanical accelerometer, the steady state displacement is a measure of, Options are ⇒ (A) constant input acceleration, (B) constant input velocity, (C) either (a) or (b), (D) neither (a) nor (b), (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a mechanical accelerometer, the steady state displacement is a measure of
A.	constant input acceleration [Correct Answer]
B.	constant input velocity [Wrong Answer]
C.	either (a) or (b) [Wrong Answer]
D.	neither (a) nor (b) [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In following figure find V_GG by assuming gate current is negligible for the p-channel JFET. (if I_DQ = - 6 mA, R_S = 0, V_DD = -18 V, R_D = 2 kΩ, I_DSS = - 10 mA, I_PO = - 3 V)
0.67 V
6.7 V
7 V
0.3 V

⇒ The shunt admittance of a transmission line is given by
γ = R + jωL
γ = R - jωL
γ = G + jωC
γ = jωGC

⇒ The two outputs of RS flip-flop are
always low
always high
either low or high
always complementary

⇒

Match the following:

	List I		List II
A.	LED	1.	Heavy Doping
B.	Avalanche Photodiode	2.	Coherent Radiation
C.	Tunnel diode	3.	Spontaneous Emission
D.	LASER	4.	Current gain

A-2, B-4, C-3
A-2, B-3, C-1, D-4
A-3, B-4, C-1, D-2
A-2, B-1, C-4, D-3

⇒ If the sign bit of mantissa is 0 and the exponent is increased from a positive to a more negative number the result is
a larger floating point number
a smaller floating point number
either (a) or (b) depending on the actual number
a negative floating point number

⇒ The electromagnets of an induction wattmeter
are laminated
are not laminated
may be laminated
must not be laminated

⇒ High IF in a superheat receiver
improves selectivity
increases tracking problems
decreases tracking problems
reduces adjacent channel rejection

⇒ Identify which of the following is not a tree of the graph shown in fi
bcgh
defg
abfg
aegh

⇒ Figure shows the V-i characteristics of a material. The material is likely t
copper
carbon
zinc oxide
rubber

⇒ Dolby system of noise reduction divides the total audio spectrum into
8 frequency bands
4 frequency bands
2 frequency bands
none of the above

⇒ In the analysis of common emitter amplifier we may neglect
h_re
h_oe
h_fe
h_ie

⇒ In MF range, increasing the transmitter power
increases the range of transmitter
does not increase the range of transmitter because propagation is limited by tilt
decreases the range of transmitter because propagation is limited by tilt
increases the range of transmitter because propagation is through space waves

⇒ A junction Field Effect Transistor can operate in
depletion mode only
enhancement mode only
depletion and enhancement modes
neither depletion nor enhancement modes

⇒ A few minutes disturbance in space communications occurs twice a year during Sunblinding when __________ are in line.
Sun and satellite
Sun and Earth station
Satellite and Earth station
Sun, satellite and Earth station

⇒ Which display device resembles vacuum tube?
LED
LCD
VF
None of these

⇒ The minority carrier life time and diffusion constant in a semiconducting material are 100 μs and 100 cm²/s respectively. The diffusion length of carriers is
0.1 cm
0.01 cm
0.0141 cm
1 cm

⇒ The phase difference between them is __________ degrees.
15
50
60
105

⇒ In a plate modulated class C amplifier, the peak supply voltage is V. The maximum plate-cathode voltage can be
1 V
1.5 V
2.5 V
4 V

⇒ In a JFET
gate source cut off voltage is equal to V_DS
gate source cut off voltage is equal to pinch off voltage
gate source cut off voltage is twice the pinch off voltage
gate source cut off voltage is equal to negative pinch off voltage

⇒ If the characteristic equation of a closed loop system is s² + 2s + 2, then the system is :
over damped
critically damped
under damped
undamped

⇒ For an N bit ADC, the percentage resolution is [1/2^N - 1)] 100.
TRUE
FALSE

⇒ A conditionally stable system has
one phase crossover frequency
two phase crossover frequencies
two or more phase crossover frequencies
one or more phase crossover frequencies

⇒ The depletion layer across a P⁺ n junction lies
mostly in the P⁺ region
mostly in n region
equally in both the P⁺ and n-region
entirely in the P⁺ region

⇒ Which junction transistor is preferred for high input and low output impedances?
Common emitter
Common base
Common collector
Any of the above

⇒ Which is not a valid Java variable
lot
c 1t
s $ 2
2 s $

⇒ In a klystron amplifier the transit time of electron passing the gap in the cavity should be
less than one cycle
less than half cycle
less than quarter cycle
more than quarter cycle

⇒ In the schematic representation of bipolar junction transistor, the direction of arrow shows the direction of flow of
holes
electrons
holes in pnp and electrons in npn
electrons in pnp and holes in npn

⇒ Which of the following devices has the 'negative resistance' characteristic?
Reflex klystron
Gunn diode
P-N-P transistor
Magnetron

⇒ In the circuit of figure the switch is open for a long time, At t = 0 the switch is closed. At t = 0⁺ the current supplied by batter
0.25
0.125
3.6 A
1.5 A

⇒ Which of the following characteristic are necessary for a sequential circuit?

It must have 6 gates
It must have feedback
Its output should depend on past value

Which of the above statements are correct?
1, 2, 3
1, 2
2, 3
1, 3