Question is ⇒ In a loss-free R-L-C circuit the transient current is, Options are ⇒ (A) oscillating, (B) square wave, (C) sinusoidal, (D) non-oscillating, (E) , Leave your comments or Download question paper.

Question is ⇒ In a loss-free R-L-C circuit the transient current is, Options are ⇒ (A) oscillating, (B) square wave, (C) sinusoidal, (D) non-oscillating, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a loss-free R-L-C circuit the transient current is
A.	oscillating [Wrong Answer]
B.	square wave [Wrong Answer]
C.	sinusoidal [Correct Answer]
D.	non-oscillating [Wrong Answer]
View Answer 9 -9 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ For the K map in the given figure, the simplified expressio
x_l x₂ x₄ + x₂ x₄ + x₁ x₃
x₂ x₄ + x₂ x₄ + x₁ x₃
x₁ x₂ x₄ + x_l x₂ + x₃ x₄ + x₂x₄
x₁ x₂ + x₂ x₃ + x₃x₄

⇒ Which of the following plot can be directly used to determine β?
V_CE versus i_C for constant I_B
V_BE versus i_B for constant V_CE
V_CB versus i_C for constant I_B
All of the above

⇒

Assertion (A): FET has characteristics very similar to that of pentode.

Reason (R): Both FET and pentode are voltage controlled devices.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ The derivative of unit step function is
unit impulse
ramp with slope 1
impulse
either (a) or (b)

⇒ If the number of information bits is m, the number of parity bits p in the Hamming code is given by equation
2^p = m + p + 1
2^p ≥ m + p + 1
2^P = m + p
2^p ≥ m + p

⇒ Power gain of antenna equals directive gain in VHF and UHF range if and only if efficiency of the antenna is
0.25
0.5
0.75
1

⇒

Assertion (A): A high junction temperature may destroy a diode.

Reason (R): As temperature increases the reverse saturation current increases.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ X and Y are two random variables and Z = X + Y . Letmz, m_z, m_x, m_y represent mean of Z, X and Y. Then
m_z = m_x + m_y
m_z ≤ m_x + m_y
m_z< m_x + m_y
m_z > m_x + m_y

⇒ For determining the network functions of a two-port network, it is required to consider that
all initial conditions remain same
all initial conditions are zero
part of initial conditions are equal to zero
initial conditions vary depending on nature of network

⇒ A junction FET, can be used as a voltage variable resistor
at pinch-off condition
beyond pinch-off voltage
well below pinch-off condition
for any value of V_DS

⇒ Which of the following transducers requires a high input impedance preamplifier for proper measurements?
Thermocouple
Piezoelectric
Thermistor
L.V.D.T

⇒ A dielectric should have poor heat conductivity.
TRUE
FALSE

⇒ In the figure shows the circuits symbo
FET
PMOSFET
CMOSFET
NMOSFET

⇒ Piezoelectric materials serves as a source of
microwaves
ultrasonic waves
musical waves
resonant waves

⇒ Which memory has read operation, byte erase, byte write and chip erase?
RAM
UVEPROM
EEPROM
both (b) and (c)

⇒ For checking the parity of a digital word, it is preferable to use
AND gates
NAND gates
EX-OR gates
NOR gates

⇒ A waveguide section in a microwave circuit acts as
LP filter
Bandpass filter
HP filter
Band stop filter

⇒

Assertion (A): When cathode temperature is increased from 2500 K to 2550 K, thermionic emission current may increase by about 50%.

Reason (R): Thermionic emission current ∝ T² e^-Ew/kT.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ One of the advantages of base modulation over collector modulation of a transistor class C amplifier is
improved efficiency
better linearity
high power output per transistor
the lower modulating power requirement

⇒ Consider the following statements about ultrasonic flow meters:

The measurement in insensitive to viscosity, pressure and temperature variations.
It has bidirectional measuring capability and can be used for any pipe size.
It has a relatively lower cost.
It has good accuracy, fast response and wide frequency range.

Which of the above statements is/are correct?
1 only
1 and 2 only
1, 2 and 4
3 and 4 only

⇒

Match the following:

	List I		List II
A.	Resistance	1.	Current noise
B.	Diode	2.	Partition noise
C.	Triode	3.	Shot noise
D.	p-n junction	4.	Atmospheric noise
		5.	Johnson noise

A-5, B-3, C-2, D-1
A-1, B-2, C-3, D-5
A-3, B-5, C-1, D-2
A-3, B-5, C-2, D-1

⇒ A sinusoidal signal with peak to peak amplitude of 1.536 volt is quantized into 128 levels using a mid-rise uniform quantizer. The quantization noise power is
0.768 V
48 x 10^-6 V
12 x 10^-6 V
3.072 Volt

⇒ The primary colours are
blue and green
blue and red
red and green
blue, red and green

⇒ A buffer amplifier should have
high output impedance and high input impedance
high output impedance and low input impedance
low output impedance an low input impedance
low output impedance and high input impedance

⇒ A capacitor is considered to be completely charged in __________ time constant.
one
three
five
eight

⇒ Trinitron is a monochrome picture tube.
TRUE
FALSE

⇒ In 8085 microprocessor, even after a Reset operation which of the following interrupts remains enabled?
INTR
RST 5.5
RST 7.5
TRAP

⇒ The inputs to logic gate are 0. The output is 1. The gate is
NAND or XOR
OR or XOR
AND or XOR
NOR or Ex-NOR

⇒ A half bridge inverter
needs a 3 wire dc supply
may use a two wire or 3 wire dc supply
has higher output voltage if fed from 3 wire dc supply
has higher efficiency if fed from 3 wire dc supply

⇒ A voltage v = 100 sin (100 pt + 45°) V is applied to an impedance 10 + j10 ohm. The current is
10 ∠45° A
7.07 ∠45° A
5 ∠45° A
5 ∠0 A