Question is ⇒ In a linear circuit, the superposition principle can be applied to calculate the, Options are ⇒ (A) voltage and power, (B) voltage and current, (C) current and power, (D) voltage, current and power, (E) , Leave your comments or Download question paper.

Question is ⇒ In a linear circuit, the superposition principle can be applied to calculate the, Options are ⇒ (A) voltage and power, (B) voltage and current, (C) current and power, (D) voltage, current and power, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a linear circuit, the superposition principle can be applied to calculate the
A.	voltage and power [Wrong Answer]
B.	voltage and current [Correct Answer]
C.	current and power [Wrong Answer]
D.	voltage, current and power [Wrong Answer]
View Answer 1 -4 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The properties of JFET resemble those of
thermionic values
N-P-N transistors
P-N-P transistors
unijunction transistor

⇒ A 3 phase dual converter consists of
two 3 phase semiconverters connected in parallel
two 3 phase semiconverters connected in antiparallel
two 3 phase full converters connected in antiparallel
two 3 phase full converters connected in parallel

⇒ Shaft encoder is used to measure
angular position
linear position
linear velocity
linear acceleration

⇒ The figure of merit for a logic family is
gain band width product
(propagation delay time) (power dissipation)
(fan out) (power dissipation)
(noise margin) (power dissipation)

⇒ A 1000 kHz carrier is simultaneously modulated with 300 Hz, 800 Hz and 2 kHz audio sine waves. The frequencies present in the output will be
998 kHz and 1002 kHz
998 kHz, 999.2 kHz, 1000.8 kHz, 1002.0 kHz
998 kHz, 999.2 kHz, 999.7 kHz, 1000.3 kHz, 1000.8 kHz and 1000.2 kHz
none of the above

⇒ A bypass capacitor produces
dc ground
ac ground
both dc and ac ground
none of the above

⇒ Which of the following is not an internal DOS command?
VER
COPY
MEM
DATE

⇒ An SBS can conduct is one direction only.
TRUE
FALSE

⇒ A capacitor input filter relies on
average detection
peak detection
both (a) and (b)
neither (a) nor (b)

⇒ A copper atom is neutral. Its core has a net charge of
0
1
-1
2

⇒ The Nyquist plot of a stable, transfer function G(s) is shown in the figure. We are interested in the stability of the closed loop system in the feedback configuration sh
G(s) is an all-pass filter
G(s) has a zero in the right-half plane
G(s) is the impedance of a passive network
G(s) is marginally stable

⇒ An op-amp is fed from a signal source through resistance R₁. If it is to work as sign changer, the feedback resistance R_f should be
equal to R₁
twice R₁
half R₁
either (b) or (c)

⇒ In Maxwell's bridge the unknown inductance is measured by comparing it with a standard capacitor.
TRUE
FALSE

⇒ The rate at which information can be carried through a communication channel depends on
carrier frequency
bandwidth
transmission loss
transmitted power

⇒ In amplitude modulation
the amplitude of carrier varies in accordance with the amplitude of the modulating signal
the modulating frequency lies in the audio range
the amplitude of the carrier remains constant
the amplitude of the carrier varies in accordance with the frequency of the modulating signal

⇒ The dual of the function A(BC + BC + BC) is
A + (B + C) (B + C) (B + C)
A (BC + BC + BC)
C(BA + CA + CA)
ABC + ABC + ABC

⇒ The input to ALU are the contents of accumulator and temporary register.
TRUE
FALSE

⇒ For an RC admittance function
all poles and zeros are simple
all poles and zeros are simple and lie on negative real axis
all poles and zeros lie on imaginary axis
all poles and zeros lie on positive real axis

⇒ Probability of error in DPSK is less than PSK
TRUE
FALSE
equal
depend upon noise

⇒ To increase Q factor of a coil, the wire should be
long
thin
thick
long and thin

⇒ The cut in voltage
is the same for silicon and germanium diodes
is a forward voltage
is a reverse voltage
is a forward voltage below which the current is very small

⇒ Two currents have the same peak value. Wave 1 is sinusoidal and wave 2 is rectangular. The ratio of their heating effects are
0.0423611111111111
1 : 2
0.0430555555555556
0.000711805555555555

⇒ The relative permittivity of the ionosphere at ratio frequencies is
> 1
< 1
1
≥ 1

⇒

Assertion (A): Megger is used to check insulation resistance of cables.

Reason (R): Insulation resistance of cables is very high.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ In the circuit shown below current through the resistor is shown. Voltage across 4 Ω resistor
8 volt
≈ 5.87 V
≈ 6.87 V
None of these

⇒

Assertion (A): In Darlington pair, the overall β is product of individual β_s

Reason (R): The voltage gain of a base driven amplifier is equal to ac collector voltage divided by ac base voltage

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒

LPEPSI
3
9
13
23



⇒ Indicate the false statement: To combat noise
reduce signalling rate
increase transmitted power
use redundancy
increase channel bandwidth

⇒ Parabolic and lens antenna used at
microwave frequency
medium frequency
low frequency
high frequency

⇒ There is no hysteresis phenomenon is any dielectric material.
TRUE
FALSE









Users Also Read
Previous Papers
Aptitude
Reasoning
Gen.Knowledge
Speak English
English / Verbal
Online / Mock Test
Vedic Math







    
	
	




    
	StudySite.org is world's best free online study content provider, Copyright © 2024 by 
StudySite.org All Rights Reserved