Question is ⇒ In a klystron amplifier the force on all electrons, Options are ⇒ (A) causes acceleration of all electrons, (B) causes retardation of all electrons, (C) causes acceleration of some electrons and retardation of others, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ In a klystron amplifier the force on all electrons, Options are ⇒ (A) causes acceleration of all electrons, (B) causes retardation of all electrons, (C) causes acceleration of some electrons and retardation of others, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a klystron amplifier the force on all electrons
A.	causes acceleration of all electrons [Wrong Answer]
B.	causes retardation of all electrons [Wrong Answer]
C.	causes acceleration of some electrons and retardation of others [Correct Answer]
D.	none of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Assertion (A): Transient periods are of short duration but can result in dangerously high voltages and currents.

Reason (R): Circuit equations in transient analysis are integral differential equations.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ A proportional controller is basically
an amplifier with adjustable gain
an integrating amplifier
an amplifier with infinite gain
an amplifier with almost zero gain

⇒ An antenna has a gain of 44 dB. Assuming that the main beam of the antenna is circular in cross-section the beamwidth will be
0.4456°
1.4456°
2.4456°
3.4456°

⇒ For most static RAM the maximum access time is about
1 ns
10 ns
100 ns
1 μs

⇒ Current density has the dimensions
IL
IL^-2
IL^-3
I²L^-2

⇒ In admittance parameter set, the dependent variables are the currents at the two ports.
TRUE
FALSE

⇒ To plot frequency spectrum we draw two graphs viz |F_n| versus frequency and φ_n versus frequency.
TRUE
FALSE

⇒ The most commonly used moving iron instruments are
repulsion type
attraction type
a combination of attraction and repulsion type
none of the above

⇒

Assertion (A): Microprocessor 8085 has on-chip oscillator with inbuilt crystal.

Reason (R): For frequency stability crystal oscillator is preferred.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ If two time varying signals of equal magnitude and zero phase displacement are applied to X and Y plates respectively; of CRO, the display will be
a straight line
a circle
an ellipse
a square

⇒ The V_TH at terminals A and B is equa
0 V
5 V
-5 V
none

⇒ The static characteristic of an adequately forward biased p-n junction is a straight line if the plot is of
log I vs log V
log I vs V
I vs log V
I vs V

⇒ In a second order system ω_n = 10 rad/sec and ζ = 0.1, then ω_d =
9.1 rad/sec
9.95 rad/sec
9 rad/sec
1 rad/sec

⇒ The transmitting antennas for lower frequencies (below 500 kHz) are generally
vertical grounded wire type
horizontal suspended wire type
parabolic reflector type
any of the above

⇒ A tweeter should be fed from the input through a
low pass filter
high pass filter
band pass filter
band stop filter

⇒ Values of V_T at 20°C for an ideal P-N diode
25.27 mV
30.3 mV
23 mV
50 mV

⇒ In a P-N-P transistor, with normal bias
the collector junction has negligible resistance
only holes cross the collector junction
the collector-base junction is reverse biased and the emitter base junction is forward biased
only majority carriers cross the collector junction

⇒ In figure, the curre
is 2 A from A to B
is 2 A from B to A
depends on the value of R
none of the above

⇒

Assertion (A): An electronic tuner uses varactor diode

Reason (R): The capacitance of a varactor diode depends on the magnitude of reverse bias.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒

Assertion (A): It is possible that a digital circuit gives the same output for different input voltages

Reason (R): A digital circuit is also called logic circuit.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ To measure a resistance of about 8 ohms we should use
Kelvin's double bridge
Wheatstone bridge
Meggar
Either (b) or (c)

⇒ Armstrong F.M. transmitter performs frequency multiplication in stages
to increase the overall S/N
for convenience
to reduce the bandwidth
to find the desired value of carrier frequency with frequency deviation

⇒ Consider the following statements

Thermistor is more sensitive than platinum resistance thermometer
The resistance of thermistor is solely a function of its absolute temperature whether the source of heat is external or internal
Thermistor has linear temperature-resistance relationship
Thermistor has linear negative temperature coefficient

Of the Statements, the correct statements are
1 and 2
3 and 4
1, 2, 3, 4
1, 2 and 4

⇒ A moving coil instrument has a resistance of 0.5 Ω and a full scale deflection of 0.1 A. To convert it into an ammeter of 0-10 A the shunt resistance should be
0.004 Ω
0.005 Ω
0.05 Ω
0.1 Ω

⇒ Evaluate the value of 2 [u (t - 1) - u (1 - 2t)] (u ( t + 1) + u (t)) at t = 3 sec.
0
4
∞
1

⇒ Figure shows four D type FFs are connected as a shift register using an XOR gate. The initial state and 3 subsequent states for 3 clock pulses are also g
0
1111
1001
1000

⇒ In a 4 input AND gate, the total number of High outputs for 16 input states are
16
8
4
1

⇒ At a given probability of error, binary coherent FSK is interior to binary coherent PSK by
6 dB
3 dB
2 dB
0 dB

⇒ Figure shows the equivalent circuit of resistor. The resistor is non-inductive w
R = L/C
LR = L/C
L = CR²
C = LR²

⇒ In a system an input resistance of 20 kΩ causes a noise voltage of 15μV. If two such input resistances each of 20 kΩ are used in parallel, the total noise voltage will be about
15 μV
30 μV
7.5 μV
10.6 μV