Question is ⇒ In a half wave diode rectifier circuit the current flows in the load circuit for, Options are ⇒ (A) 90° in each cycle, (B) 180° in each cycle, (C) 270° in each cycle, (D) 360° in each cycle, (E) , Leave your comments or Download question paper.

Question is ⇒ In a half wave diode rectifier circuit the current flows in the load circuit for, Options are ⇒ (A) 90° in each cycle, (B) 180° in each cycle, (C) 270° in each cycle, (D) 360° in each cycle, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a half wave diode rectifier circuit the current flows in the load circuit for
A.	90° in each cycle [Wrong Answer]
B.	180° in each cycle [Correct Answer]
C.	270° in each cycle [Wrong Answer]
D.	360° in each cycle [Wrong Answer]
View Answer 2 -2 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a FM receiver, amplitude limiter
amplifiers low frequency signals
reduces the amplitude of signals
eliminates any change in amplitude of received FM signals
none of the above

⇒ An AC source or RMS voltage 20V with internal impedance Z_s = (1 + 2j) Ω feeds a load of impedance Z_L = (7 + 4j) Ω in the figure below. The reactive power consumed by the loa
8 VAR
16 VAR
28 VAR
32 VAR

⇒ A thyristor is reverse biased. A positive gate pulse is applied. The thyristor
will be turned on
may or may not turn on
will not turn on
will turn on after sometime

⇒ A discrete zero memory information source has 40 symbols and each symbol is equally likely. The minimum number of bits required to code the source with uniform length code and entropy of the source are
5 and 5.03
6 and 5.83
5 and 6.64
6 and 5.32

⇒ In an intrinsic semiconductor, at a given temperature T
the number of electrons-hole pairs generated per second due to thermal motion are equal to the number of electron-hole pairs lost per second due to recombination
the number of electron-hole pairs generated per second due to thermal motion is always less than the number of electron-hole pairs lost per second due to recombination
the number of electron hole pairs generated per second due to thermal motion is always more than the number of electron-hole pairs lost per second due to recombination
any of the above

⇒ If a and b are the dimensions of waveguide then
a = 3b
a = 2b
a = b
a = b/4

⇒

Match the following:

	List I (Devices)		List II (characteristic)
A.	BJT	1.	Voltage controlled negative resistance
B.	MOSFET	2.	High current gain
C.	Tunnel diode	3.	Voltage regulation
D.	Zener diode	4.	High input impedance

A-1, B-4, C-2, D-3
A-2, B-4, C-1, D-3
A-2, B-3, C-1, D-4
A-1, B-3, C-2, D-4

⇒ The internal resistance of a current source used in the model of a BJT while analyzing a circuit using BJT is :
very high
very low
zero
of the order of a few mega ohms

⇒ For a transistor amplifier with self biasing network, the following components are used. R₁ = 4 kΩ, R₂ = 4 kΩ, R_C = 1 kΩ. The approximate value of the stability factor 'S' will be
4
3
2
1.5

⇒ Efficiency of a half wave diode rectifier is less than 40%.
TRUE
FALSE

⇒ The gain of collinear arrays is maximum when the spacing between the elements is
0.1 λ to 0.3 λ
0.3 λ to 0.9 λ
0.5 λ to 0.7 λ
0.7 λ to 0.9 λ

⇒ The amplifier used in bootstrap voltage sweep should have a gain of
1
+∞
-1
-∞

⇒ Find equivalent capacitance if each capacitance is
56 F
6/5 F
6/10 F
5/12 F

⇒ A bit synchronizer regenerates at the receiver a clock waveform which is
synchronous with original clock waveform
out of phase by 180° with original clock waveform
out of phase by 90° with the original clock waveform
none of the above

⇒ High purity copper is obtained by
rolling casting
casting
electrolytic refining
induction heating

⇒

Assertion (A): Many instruments use eddy current damping.

Reason (R): Eddy currents set up a magnetic flux which opposes the original movement which generates them.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ The total number of leads in SUS, SBS and SCS respectively are
3, 3, 4,
3, 3, 3
2, 3, 3
3, 3, 5

⇒ Three resistance of 15 Ω each are connected in delta. The resistance of equivalent star will have a value of
15 Ω
5 Ω
5/3 Ω
45 Ω

⇒ Quartz crystal has
very small Q
small Q
very high Q
Q less than 1

⇒ A 16 x 8 ROM stores these words in its first four locations, as given below. Which of this represents 3 CH in hexadecimal?
R₀ = 1110 0010
R₁ = 0101 0111
R₂ = 0011 1100
R₃ = 1011 1111

⇒ Most of the communication satellites are stationed to the West of their service areas in order to reduce their
eclipse period
loss of power
battery power provision
mass of station-keeping fuel

⇒ The initial state of a Mod-16 counter is 0110. After 37 clock pulses the state of counter will be
1011
110
10
1

⇒ Speech amplifiers are usually operated as
class A
classes AB
class B
class C

⇒ The hexadecimal number (3E8)₁₆ is equal to decimal number
1000
982
768
323

⇒ In a bridge inverter
an output transformer is essential
an output transformer is not essential
an output transformer cannot be connected
an output transformer, if used, can improve the efficiency of the circuit

⇒ Which of the following is not advantage of FM over AM?
Noise immunity
Capture effect
Fidelity
Spluttering effect

⇒ A microwave junction is matched at all ports if the S matrix
has all diagonal elements zero
has all diagonal elements equal but not zero
has all diagonal elements complex
is Hermitian

⇒ Multiplexer can be used as logic function generator.
TRUE
FALSE

⇒ Which of the following computer memories is fastest?
Cache
Primary
Mass storage
Off line back up

⇒ ADC 0804 is a
dual slope A/D converter
single slope A/D converter
successive approximation A/D converter
either (a) or (b)