Question is ⇒ In a full wave rectifier circuit using centre tapped transformer, the peak voltage across half the secondary winding is 40 V. If diodes are ideal, the average output voltage is, Options are ⇒ (A) 40 V, (B) 25.5 V, (C) 20 V, (D) 2.55 V, (E) , Leave your comments or Download question paper.

Question is ⇒ In a full wave rectifier circuit using centre tapped transformer, the peak voltage across half the secondary winding is 40 V. If diodes are ideal, the average output voltage is, Options are ⇒ (A) 40 V, (B) 25.5 V, (C) 20 V, (D) 2.55 V, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a full wave rectifier circuit using centre tapped transformer, the peak voltage across half the secondary winding is 40 V. If diodes are ideal, the average output voltage is
A.	40 V [Wrong Answer]
B.	25.5 V [Correct Answer]
C.	20 V [Wrong Answer]
D.	2.55 V [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Match the following:

	List I		List II
A.	Zener diode	1.	used in seven segment display
B.	Tunnel diode	2.	used in voltage regulator circuits
C.	LED	3.	used is solar energy utilization
D.	Photovoltaic cell	4.	used in digital circuits

A-1, B-3, C-2, D-4
A-2, B-3, C-1, D-4
A-2, B-4, C-1, D-3
A-3, B-2, C-4, D-1

⇒ The open loop gain of an amplifier is 50 but is likely to change by 20%. If negative feedback with β = 0.1 is used, the change in gain will be about
0.2
0.1
0.04
0.0005

⇒ If reflection coefficient is 1/5, then corresponding VSWR is given by
1
2
3
42796

⇒ In the circuit shown in the given figure, switch k is closed at t = 0. The circuit was initially relaxed then which one of the following sources of v(t) will produce maximum current at t = 0^{+Unit step
Unit impulse
Unit ramp
Unit step plus unit ramp}

⇒ Which of the following statements is incorrect regarding Balun transformer?
It changes impedance like current transformer
It changes balanced to unbalanced line
It is used to couple a co-axial line to a parallel line wire
Any of the above

⇒ In the expression a = 5 * 2 / 3.2 + 4 / 8 - 2 + 5 / 9 which operation will have the first priority in C?
5*2
2 / 3.2
5 * 2 / 3.2
42833

⇒ Thu advantage of using a dual stop ADC in a digital voltmeter is that
its conversion time is small
its accuracy high
output is in BCD format
it does not require a comparator

⇒ An RC series circuit has R = 20 Ω and X_C = 20 Ω. Then Z =
40 Ω
28.28 Ω
20 Ω
1 Ω

⇒ In a CRO, the time base signal is applied to
X plates
Y plates
either X or Y plates
alternately X and Y plates

⇒ Which of the following statement about JFET is true?
In a JFET, gate and source have opposite polarity with respect to drain irrespective of the type of FET
In its schematic symbol for JFET, the arrow always points to p-type material
In an n-channel JFET, the channel is the narrowest under zero gate bias condition
In JFET, gate source cut off voltage is numerically equal to the pinch off voltage

⇒ Electromagnetic waves transport
energy only
momentum only
energy as well as momentum
neither energy nor momentum

⇒ In a uniformly doped BJT, assume that N_E, N_B and N_C are the emitter, base and collector dopings in atoms/cm³, respectively. If the emitter injection efficiency of the BJT is close unity, which one of the following conditions is TRUE?
N_E = N_B = N_C
N_E >> N_B and N_B > N_C
N_E = N_B and N_B < N_C
N_E < N_B < N_C

⇒ The function A e^st where s = s + jω represents
A phasor whose magnitude changes with time
A phasor whose frequency is ω
A phasor rotating in counterclockwise direction at angular frequency ω and whose magnitude increases with t
A phasor rotating in clockwise direction at angular frequency ω and whose magnitude increases with t

⇒ In 8085 the instruction MOV A, B is an example of
Direct addressing
Immediate addressing
Register addressing
Register indirect addressing

⇒ The effect of lead resistance is important in measurement of
resistance of shunt
resistance of shunt winding
resistance of ammeter
both (a) and (c)

⇒ Integral control action
removes offset
may lead to oscillatory response
both (a) and (b)
neither (a) nor (b)

⇒ In p type semiconductor, the hole concentration
is nearly equal to density of acceptor atoms
is much greater than density of acceptor atoms
is much less than density of acceptor atoms
may be equal to or more or less than density of acceptor atoms

⇒ The emission of light is LED due to
emission of holes
emission of electrons
generation of electromagnetic radiations
conversion of heat energy into illumination

⇒ A half bridge inverter
needs a 3 wire dc supply
may use a two wire or 3 wire dc supply
has higher output voltage if fed from 3 wire dc supply
has higher efficiency if fed from 3 wire dc supply

⇒

Assertion (A): A backward wave oscillator can be used as a sweep generator.

Reason (R): The frequency of oscillation of a backward wave oscillator can be changed by varying the voltage which controls the beam velocity.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Audio and video signals are called modulating waves.
TRUE
FALSE

⇒ In the circuit shown in the given figure, R_L will absorb maximum power when its valu
2.75 Ω
7.5 Ω
25 Ω
27 Ω

⇒ Fourier transform is defined for
periodic
non-periodic
finite duration
all

⇒ Consider the signal S(t) shown bel
8
12
16
18

⇒ The useful operational life of INSAT-IB (launched in 1983) is expected to end by
1992-93
1991-92
1989-90
1993-94

⇒ For a short dipole having an effective length less than half the wavelength the radiation resistance is
proportional to length
proportional to square root of length
proportional to square of length
none of the above

⇒

Match the following:

	List I (Component)		List II (Dominant TE mode)
A.	Rectangular wave guide	1.	TE₁₀₁
B.	Circular waveguide	2.	TE₁₀
C.	Rectangular cavity	3.	TE₁₁₁
		4.	TE₁₁

A-4, B-2, C-1
A-2, B-1, C-3
A-3, B-4, C-1
A-2, B-3, C-1

⇒ If f(t) is in volts, then F(jω) is in
volts
volt seconds
volts/sec
volt-sec²

⇒ A p-n junction diode has
low forward and high reverse resistance
a non-linear v-i characteristics
zero forward current till the forward voltage reaches cut in value
all of the above

⇒ For the high-pass circuit to act as a differentiator, the time constant must be
small
very small in comparison to the time period of the input signal
very high in comparison to the time period of the input signal (that is low pass circuit)
moderate value