Question is ⇒ In a full wave rectifier circuit using centre tapped transformer, the peak voltage across half of the secondary winding is 30 V. Then PIV is, Options are ⇒ (A) 30 V, (B) 60 V, (C) 15 V, (D) 10 V, (E) , Leave your comments or Download question paper.

Question is ⇒ In a full wave rectifier circuit using centre tapped transformer, the peak voltage across half of the secondary winding is 30 V. Then PIV is, Options are ⇒ (A) 30 V, (B) 60 V, (C) 15 V, (D) 10 V, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a full wave rectifier circuit using centre tapped transformer, the peak voltage across half of the secondary winding is 30 V. Then PIV is
A.	30 V [Wrong Answer]
B.	60 V [Correct Answer]
C.	15 V [Wrong Answer]
D.	10 V [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The main reason why Ni-Zn ferrites are used for audio and T.V. transformers is that
they have large saturation magnetization
they are easy to fabricate by rolling
they are totally free from pores and voids
they have a high electrical resistivity

⇒ The electrical power to a megger is provided by
battery
inverter
permanent magnet dc generator
ac generator

⇒

Assertion (A): As the length of the resonant antenna is increased, the number of lobes increases and the direction of the major lobes is closer and closer to the direction of the diode.

Reason (R): As the length increases, the current distribution along the wire becomes more and more uniform.

Both A and R are individually true and R is the correct explanation of A
Both A and R are individually true but R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ In a metal the probability of a state 0.1 eV below Fermi level being occupied
is more than the probability of state 0.1 eV above Fermi level being occupied
is the same as the probability of state 0.1 eV above Fermi level being occupied
is less than the probability of state 0.1 eV above Fermi level being occupied
may be equal to or more or less than the probability of state 0.1 eV above Fermi level being occupied

⇒ In a reverse biased p-n junction, the reverse bias is 4V. The junction capacitance is about
0.1 F
4 μF
10 nF
20 pF

⇒ In following circuit, R_B will be if V_CC = 10 V, V_S = 2 V, R_C = 5 kΩ, R_S = 90 kΩ, β = 50, I_CE = 0, V_CEsat = 0
230 K
235 K
240 K
250 K

⇒ In an integrated circuit the SiO₂layers provide
electrical connection to external Ckt.
physical strength
isolation
conducting path.

⇒ A single phase half wave converter is used to charge a battery of 50 V. The thyristor is continuously fired by dc signal. Input voltage is v = V_m sin ωt. The thyristor will conduct
from 0 to 180°
when v > 50 V
from 0 to 90°
When v < 50 V

⇒ Magnetic effect of current is used in
ammeters
voltmeters
wattmeters
ammeters, voltmeters, wattmeters and energy meters

⇒ In a two stage cascade amplifier, each stage has a gain of 10 dB and noise figure of 10 dB. The overall noise factor is
10
1.09
1
10.9

⇒ A signal with ± 10 V ranged and 1 KHz band width is being digitized using a sample and hold circuit and a 10 bit quantizer. The quantization step is :
1 x 10^-9 V
5 x 10^-9 V
2.5 x 10^-9 V
0.5 x 10^-9 V

⇒ In a 3 phase full converter, the instantaneous output voltage can have negative part if
firing angle is less than 60°
firing angle is less than 90°
firing angle is more than 60°
firing angle is more than 90°

⇒ The classes of solid dielectrics are
A, B, C, D, E, F, H
A E B F H C D
Y A E B F H C
A E B F H C

⇒ In energy band diagram of n type semiconductor, the donor energy level is
in valence band
in conduction band
slightly above valence band
slightly below conduction band

⇒ Which of the following is not an assembler directive in 8085?
D S
D B
D Q
E Q U

⇒ In which of the following 8085 instructions is the 8 bit number in accumulator adjusted to form two four bit BCD numbers
DAD rp
DAA
DCX rp
ADC M

⇒ In figure, a voltmeter of internal resistance 1200 Ω is connected across 600 Ω resistance and it reads 5 V. The value of
1200 Ω
2400 Ω
3600 Ω
7200 Ω

⇒ Huffman code is also known as redundancy code
TRUE
FALSE
in some cases
depend upon efficiency

⇒ The refractive index of E layer, if angle of incidence is 30°
0.5
0.25
0
1

⇒ A MOD - 2 counter, the FF has a t_pd = 60 nsec. The NOR gate has a t_pd of 30 nsec. The clock frequency is
37 MHz
40 MHz
111 MHz
none

⇒ A lens has a hyperfocal distance of 7.5 m. It is focused at 7.5 m. Then
all objects from 7.5 m to infinity will appear in focus
all objects from 3.75 m to infinity will appear in focus
all objects from 0 to 7.5 m will appear in focus
all objects from 0 to 3.75 m will appear in focus

⇒

Assertion (A): KCL is dual of KVL.

Reason (R): Node is dual of mesh.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Magnitude Plot of a Composite signal x(t) = e^2jt + e^3jt is
half wave rectified sinusoidal
full wave rectified sinusoidal
exponentially increasing sinusoidal
exponentially decreasing sinusoidal

⇒ Intrinsic or characteristic impedance of free space has a value of
120 ohm
73 ohm
73 ε ohm
120 ε ohm

⇒ For a system to work, as oscillator the total phase shift of the loop gain must be equal to
90°
45°
270°
360°

⇒ In floating point representation the number of bits in exponent is
8
7
6
5

⇒ In a bipolar junction transistor the base region is made very thin so that
recombination in base region is minimum
electric field gradient in base is high
base can be easily fabricated
base can be easily biased

⇒ Which of the following is invalid in Basic?
A ** B - C
5.2 ** 4.3
5.2 ** (- 4.3)
(- 5.2) ** (4.3)

⇒ A monostable multivibrator is used to generate PWM because it can
differentiator
integrator
voltage-to-frequency converter
generate pulses

⇒ Narrow band FM signal can be represented as
A cos (2pf_ct) - βA sin (2pf_ct) sin (2pf_mt)
A cos (2pf_mt) - βA sin (2pf_ct) sin (2pf_mt)
A cos (2pf_ct) + βA sin (2pf_ct) sin (2pf_mt)
A cos (2pf_mt) + βA sin (2pf_mt) sin (2pf_ct)