Question is ⇒ In a flip flop which input determines the state to which output will transistion?, Options are ⇒ (A) Control input, (B) Clock input, (C) Both control and clock input, (D) Either control or clock input, (E) , Leave your comments or Download question paper.

Question is ⇒ In a flip flop which input determines the state to which output will transistion?, Options are ⇒ (A) Control input, (B) Clock input, (C) Both control and clock input, (D) Either control or clock input, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a flip flop which input determines the state to which output will transistion?
A.	Control input [Correct Answer]
B.	Clock input [Wrong Answer]
C.	Both control and clock input [Wrong Answer]
D.	Either control or clock input [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A circular waveguide carries TE₁₁ mode whose radial electric-field is given
10 cm
3p cm
2p cm
8 cm

⇒ Diffraction of EM waves
arises only with spherical wave front
may occur around the edge of an obstacle
occurs when waves pass through a big slot
none of the above

⇒ The phase angle corresponding to λ/4 in a standing-wave pattern is
30°
90°
135°
180°

⇒ A single phase semiconverter is feeding a highly inductive load. The circuit has a freewheeling diode across the load and firing angle is a. During one cycle of input voltage, the total duration of conduction of freewheeling diode is
a
2 a
4 a
0.5 a

⇒ A series RLC circuit is at resonance at 200 Hz. If capacitance is increased to four times, the circuit will be in resonance at
200 Hz
400 Hz
100 Hz
800 Hz

⇒ At present, the radio-frequency band mainly used by most satellites is
EHF
UHF
VHF
SHF

⇒ Which of the following capabilities are available in a Universal Shift Register?

Shift left
Shift right
Parallel load
Serial add

Select the correct answer from the codes given below:
2 and 4 only
1, 2 and 3
1, 2 and 4
1, 3 and 4

⇒ In Pascal the repeat and while loops will terminate
only when the logical expression controlling the loop becomes true for both repeat and while loops
only when the logical expression controlling the loop becomes false for both repeat and while loops
only when the logical expression controlling the loop becomes true for repeat loop and false for while loop
only when the logical expression controlling the loop becomes false for repeat loop and true for while loop

⇒ In a feedback series regular circuit, the output voltage is regulated by controlling the
magnitude of the I/P voltage
gain of the feed back BJT
reference Voltage
voltage drop across the series pass transistor

⇒ In a lead acid cell the density of the acid gives an indication of
the level of the acid
the eventual damages caused to the plates
the charge of the battery
the e.m.f. of the battery

⇒ A coil has a designed for high Q performance at a rated voltage and a specified frequency. If the frequency of operation is doubled, and the coil is operated at the same rated voltage, then the Q factor and the active power P consumed by the coil will be affected as follows.
P is doubled, Q is halved
P is halved, Q is doubled
P remains constant, Q is doubled
P decreases 4 times, Q is doubled

⇒ The first column of a Routh arra
2
3
4
5

⇒ A magnetic field exists around
moving charges
static charges
iron
copper

⇒ What is the frequency of audio modulation?
1000 Hz
2000 Hz
3000 Hz
2000 kHz

⇒ The number of lobes on each side of a 31 resonant antenna will be
2
3
4
6

⇒ In the given figure reflection coefficient at loa
0.6
-0.6
0.4
-0.4

⇒ Which of the following is not between F₂ layer and D layer?
E layer
F₁ layer
G region
All of the above

⇒ An RLC series circuit has a variable inductance. The value of L for resonance conditions at fundamental frequency is 0.18 H. For resonance conditions at third harmonic frequency the value of inductance is
0.54 H
0.06 H
0.02 H
1.62 H

⇒ PAL system was proposed first in
USA
Japan
England
Germany

⇒ Which one of the following circuits is most suitable as an oscillator at a frequency of 100Hz?
Hartley oscillator
Colpitts oscillator
Crystal oscillator
Twin-T oscillator

⇒ Choose the correct option

Mesh is the smallest loop of circuit
Loop is smallest path of circuit
Loop does not contain any mesh
Loop may have one or more than one mesh

1, 2, 3, 4
3, 4, 2
1, 4
3, 2

⇒ A binary with a digits, all of which are unity has the value
n² - 1
2ⁿ
2(^{n - 1})
2ⁿ - 1

⇒ The read and write cycle times of cache memory are in the range of
1 - 3 ns
25 ns - 45 ns
200 ns - 300 ns
1 μs

⇒ As regards BCH code, Hamming code and Reed-Solomon code
BCH and Hamming code are special cases of Reed-Solomon code
Reed-Solomon and Hamming code are special cases of BCH code
BCH and Reed-Solomon code are special case of Hamming code
none of the above

⇒ The complement of exclusive OR function is
AB + A B
AB + A B
A B + A
AB + A B

⇒ A dc amplifier can operate
at zero frequency
only at low frequency
only at high frequencies
both at low and high frequencies

⇒ The sensitivity of a superheterodyne receiver is determined by
the gain IF amplifier
the gain of RF amplifier
the noise figure
all of the above

⇒ VSWR can have any value between
0 and 1
- 1 to + 1
0 to ∞
1 to ∞

⇒ The Ebers-moll equation for I_E in CB configuration is given by
I_E = a_nI_CI_EC0
I_E = a_II_C + I_C0
I_E = a_nI_C + I_C0(e^qVEB/KT-1)
I_E = a_II_C + I_E0(e^qV_EB/KT - 1)

⇒ An encoder converts decimal numbers to binary and other codes.
TRUE
FALSE