Question is ⇒ In a driving point function, the degrees of numerator and denominator polynomials in <i>s</i> may differ by either zero or one only., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper.

Question is ⇒ In a driving point function, the degrees of numerator and denominator polynomials in <i>s</i> may differ by either zero or one only., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a driving point function, the degrees of numerator and denominator polynomials in s may differ by either zero or one only.
A.	TRUE [Correct Answer]
B.	FALSE [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which liquid crystal is used for LCD display?
Mercury
Pneumatic fluid
Aqua regia
Liquid boron

⇒ A transmission line is feeding 1 watt of power to a horn antenna having a gain of 10 dB. The antenna is matched to the transmission line. The total power radiated by the horn antenna into the free space is
10 watts
1 watt
0.1 watt
0.01 watt

⇒ A peak responding ac voltmeter using a half wave rectifier has been calibrated to read 1 V for 1 V rms sine wave input. If input is 1 V dc the reading will be
0.707 V
0.707 or 0 V
1.414 V
1.414 or 0 V

⇒ Zero suppression is not used in actual practice.
TRUE
FALSE

⇒ In the television system in India, each channel is allowed a bandwidth of
20 MHz
12 MHz
7 MHz
3 MHz

⇒ A colour television signal having bandwidth of 4.6 MHz is digitised using 10 bits sample. The digital bit rate used for its transmission with PCM would be __________ kilobits/second.
92000
920
23000
230

⇒ The emitter bias largely depends on
gain
signal input
I_E
none of the above

⇒ The input to a parity detector is 1001. The output is
0
1
0 or 1
indeterminate

⇒ For AM receivers the standard IF frequency is
106 kHz
455 kHz
1.07 MHz
10.7 MHz

⇒ In a JFET the width of channel is controlled by
gate voltage
drain current
source current
all of the above

⇒ Read the following statements: Dual slope ADC provides

higher speed as compared to other ADC
very good accuracy
good rejection of power supply
better resolutions compared to other ADC for the same number of bits

Which of the above are correct?
1 and 2
2 and 3
1, 2, 3
1, 2, 3, 4

⇒ Which of the following parameters is not specified for digital ICs?
Gate dissipation
Propagation delay
Noise margin
Bandwidth

⇒ Frequency response approach is a simple approach to control system design.
TRUE
FALSE

⇒ In the graphical analysis of CE amplifier circuit, the upper end of load line is called
saturation point
cut off point
Q point
none of the above

⇒ What is the minimum value of VSWR that may exist on a transmission line?
Less than zero
Zero
One
10

⇒ A single phase semiconverter is feeding a highly inductive load and has a freewheeling diode across the load. The waveshape of input current is
sinusoidal
rectangular
sinusoidal or rectangular
triangular

⇒ Some of MOS families are PMOS, NMOS, CMOS. The family dominating the LSI field where low power consumption is necessary is
NMOS
CMOS
PMOS
both NMOS and CMOS

⇒ MEWS stands for
Missile Early Warning System
Moving Target Early warning System
Missile Early Warning Signal
Moving Target Early Warning Signal

⇒ A two port network is symmetrical if
z₁₁ z₁₂ - z₁₂ z₂₁ = 1
AD - BC = 1
h₁₁ h₂₂ - h₁₂ h₄₁ = 1
y₁₁ y₂₂ = y₁₂ y₂₁ = 1

⇒ A (0.75 - j50) ohm load is connected to a coaxial transmission line of Z₀ = 75 ohms at a frequency of 10 GHz Which of the following will be the best method of matching?
Connecting an inductance at the end
Connecting a short circuited stub at the load
Connecting a capacitance at some distance from the load
Connecting a short circuited stub at some specified distance from the load

⇒ The peak factor is
rms value/peak value
rms value/average value
peak value/rms value
peak to peak value/rms value

⇒ Ferrites have
low copper loss
low eddy current loss
low resistivity
higher specific gravity compared to iron

⇒ The voltage gains of an amplifier without feedback and with negative feedback respectively are 100 and 20. The percentage of negative feedback would be.
0.4
0.05
0.2
0.8

⇒ In a radio receiver with simple AGC
the highest AGC voltage is produced between stations
the faster the AGC time constant, the more accurate the output
an increase in signal strength produces more AGC
the audio stage gain is normally controlled by AGC

⇒ Epitaxial growth is used in IC_s
because it produces low parasitic capacitance
because it yields back to back isolating pn Junction
to grow single crystal n doped silicon on a single crystal P-type substrate
to grow Selectivity single crystal P doped silicon of one resistivity on a P type substrate of a different resistivity

⇒ Quantization error occurs in
D/A converter
A/D converter
both D/A and A/D converter
neither D/A nor A/D converter

⇒ As compared to a p-n junction diode
a schottky diode has lower cut in voltage and lower reverse saturation current
a schottky diode has higher cut in voltage and higher reverse saturation current
a Schottky diode has lower cut in voltage and higher reverse saturation current
a schottky diode has higher cut in voltage and lower reverse saturation current

⇒ In figure the coordinates of Q point on the load line are (Neglect V_{BEI_C = 10 mA, V_CE = 15 V
I_C = 5 mA, V_CE = 22.5 V
I_C = 5 mA, V_CE = 15 V
I_C = 10 mA, V_CE = 22.5 V}

⇒ If transfer function of a system is H(z) = 6 + z^-1 + z^-2 then system is
minimun phase
maximum phase
mixed phase
none

⇒ Consider the following statements

An iron cored choke is non linear and passive device.
A carbon resistor kept in sunlight is a time invariant and passive device.
A dry cell is a time varying and active device.
An air capacitor is time invariant and passive device.

Of these statements
1, 2, 3 and 4 are correct
1, 2, 3 are correct
1, 2, 4 are correct
2 and 4 are correct