Question is ⇒ In a driving point function poles and zeros must be conjugate if complex or imaginary., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper.

Question is ⇒ In a driving point function poles and zeros must be conjugate if complex or imaginary., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a driving point function poles and zeros must be conjugate if complex or imaginary.
A.	TRUE [Correct Answer]
B.	FALSE [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which type of fading causes serious distortion of modulated signal?
Selective fading
Interference fading
Absorption fading
Polarization fading

⇒ Depending on the technique used, digitized television requires a bit rate between __________ millions.
40 and 92.5
25 and 60
30 and 82.5
2

⇒ If the number of atoms per unit volume of a monoatomic gas changes, the dielectric constant still remains constant.
TRUE
FALSE

⇒

Assertion (A): The sign and magnitude of displacement can be measured by an LVDT.

Reason (R): LVDT is based on the principle of mutual inductance.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ In full wave rectification, if the input frequency is 50 Hz, then frequency at the output of filter is
50 Hz
0 Hz
100 Hz
75 Hz

⇒ In the epitaxial diffused method of fabricating integrating circuits the process involved are __________

Epitaxial growth
Diffusion
Silicon diode growth
Vacuum evaporation of aluminium
Photoetching

The correct order is
1 - 2 - 3 - 4 - 5
1 - 3 - 5 - 2 - 4
3 - 1 - 4 - 5 - 2
1 - 3 - 2 - 4 - 5

⇒ Three Mod-16 counters are connected in cascade. The maximum counting range is
16
256
4096
none of the above

⇒ Which of these has highly doped p and n region?
PIN diode
Tunnel diode
Schottky diode
Photodiode

⇒ Subroutines are used in larger programs not
to increase the programming case
to reduce storage equipment
to reduce program extension time
for ease of program testing at the program development time

⇒ A counter has N flip flops. The total number of states are
N
2 N
2^N
4 N

⇒ The contrast control in colour TV receiver is done by
chroma amplifier
SAW filter
video detector
luminance amplifier

⇒ In figure V is ideal voltmeter having infinite resistance. It will read __________ v
40
60
0
100

⇒ The radiation resistance of a circular loop of one turn is 0.01 ohm. For 5 turn loop the radiation resistance is
0.002 Ω
0.01 Ω
0.05 Ω
0.25 Ω

⇒ In n-well CMOS fabrication substrate is:
heavily doped n-type
heavily doped p-type
lightly doped n-type
lightly doped p-type

⇒ A narrow band noise n(t) has symmetrical spectrum and has power density spectrum 0.2 x 10^-6. The power density of quadrature component is
0.2 x 10^-6
10^-7
4 x 10^-7
5 x 10^-8

⇒ For the binary number 11101000, the equivalent hexadecimal number is
F 9
F 8
E 9
E 8

⇒ Minimum no. of 2 I/P NAND gate required to implement the Boolean function Z = ABC, assuming that A, B and C are available is
2
3
5
6

⇒ In 8085 microprocessor, what is the length of A-register?
6 bits
8 bits
12 bits
16 bits

⇒ The function (s + 2) (s + 4)/[(s + 1)(s + 3)]
is a reactance function
is an RC function
may be a reactance function or an RC function
may be RC function or an RL function

⇒ In the circuit shown in the figure, the current supplied by the sinusoidal current source
28 A
0.166666666666667
20 A
not determinable from the data given

⇒ Silicon diodes have __________ reverse resistance than germanium diodes.
a much smaller
a much larger
an infinite
a negligible

⇒ The circuit shown depic
voltage series negative feedback
voltage shunt negative feedback
current series negative feedback
current shunt negative feedback

⇒ Choose the appropriate turn on and turn off time of a FET
1 ns, 10ns
6 ns, 18ns
4 ns, 8 ns
10 ns, 10 ns

⇒ The first critical frequency nearest the origin of the complex frequency plane for an RL driving point impedance will be
a zero in left half plane
a zero in right half plane
a pole in left half plane
a pole or zero in left half plane

⇒ For the system of the given figure |G(jω)| = 0 dB at &omeg
0
1 rad/sec.
∞
2.38 rad/sec.

⇒ Following figure is a signal conditioning Amplifier, changes gain depending upon the polarity of V_s. What will be circuit voltage gain for + V_s and for - V_s if D₂ is id
A_V = -R₃/R₁
R₃/R₁
R₁/R₃
1 + R₃/R₁

⇒ In the circuit of figure diode will con
from 90 to 180° in the positive half cycle
from 30° to 180° in the positive half cycle
from 50° to 160° in the positive half cycle
from 30° to 150° in the positive half cycle

⇒ TTL XOR gate is very suitable as LCO driver.
TRUE
FALSE

⇒ In 8085, usually the vector location and the next two memory location contain a JMP instruction. This allows the programs to branch to
a longer subroutine
a shorter subroutine
a subroutine free path
none of the above

⇒ The circuit consisting of two transistor connected in series with the d.c. supply voltage is called
push pull
differential pair
stacked V⁺
complementary symmetry