Question is ⇒ In a DM system, the granular noise occurs when modulating signal, Options are ⇒ (A) decrease Rapidly, (B) increase, (C) has high frequency component, (D) change within step size, (E) , Leave your comments or Download question paper.

Question is ⇒ In a DM system, the granular noise occurs when modulating signal, Options are ⇒ (A) decrease Rapidly, (B) increase, (C) has high frequency component, (D) change within step size, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a DM system, the granular noise occurs when modulating signal
A.	decrease Rapidly [Wrong Answer]
B.	increase [Wrong Answer]
C.	has high frequency component [Correct Answer]
D.	change within step size [Wrong Answer]
View Answer 3 -9 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Match the following:

	List I (Antenna)		List II (Communication system)
A.	Turnstile	1.	Radar
B.	Yagi	2.	TV transmission
C.	Dish	3.	MW broadcasting
D.	Vertical mast	4.	TV reception

A-4, B-2, C-3, D-1
A-2, B-4, C-1, D-3
A-2, B-4, C-3, D-1
A-4, B-2, C-1, D-3

⇒ With JFETs cascade means
a common source driving a common gate connection
a common gate driving a common source connection
two FETs connected in parallel
none of the above

⇒ In microwave circuits, a mode transducer is used to
change mode of wave transmission
change direction of wave transmission
change polarization of wave transmission
change mode, direction or polarization wave transmission

⇒ Which of the following does not show non-linear V-I characteristics?
Schottky diode
Tunnel diode
Thermister, at a fixed temperature
p-n junction diode

⇒ The refractive index of E layer, if angle of incidence is 30°
0.5
0.25
0
1

⇒ The D'Arsonval- movement can be converted into audio frequency ac ammeter by adding a
thermocouple
transducer
chopper
rectifier

⇒ In a 3 phase full wave regulator feeding a star connected resistance load the input voltage is 400 V line to line. The firing angle is 160°. The line to line output voltage would be
400 V
about 100 V
about 20 V
zero

⇒ How many zone bits are th
2
4
8
16

⇒ The complement of Boolean expression AB (B C + AC) is
(A + B) + (B + C) + (A + C)
A B + (B + C)(A + C)
(A + B) + (B + C) (A + C)
none of the above

⇒ A quarter wave line open circuited at far end behaves as
inductance
L and C in parallel
capacitance
L and C in series

⇒ A p-n junction diode has
low forward and high reverse resistance
a non-linear v-i characteristics
zero forward current till the forward voltage reaches cut in value
all of the above

⇒ A two winding transformer is feeding a single phase half wave rectifier circuit. The load is purely resistive. The rms value of transformer secondary current is I_s and rms value of load current in I_rms. Then
I_s = I_rms irrespective of the value of firing angle
I_s = 0.5 I_rms irrespective of the value of firing angle
I_s = I_rms if firing angle is less than 30°
I_s = I_rms if firing angle is more than 30°

⇒ In figure, voltage across R₂ = + 10 V. If V_BE = 0.7 V and V_E = 0.7 V and R_E = 10 kΩ, current through R_{E1 mA
0.93 mA
2 mA
1.86 mA}

⇒ An ideal voltage source can not be converted into an equivalent current source.
TRUE
FALSE

⇒ When analysing two port networks in parallel it is more convenient to use
z parameters
h parameters
T parameters
y parameters

⇒ The pole zero plot in the given figure is
non-minimum phase function
minimum phase function
all pass function
either (a) or (b)

⇒ In a resistance loaded, RC coupled amplifier the d.c. component is blocked by
Transistor
C_C
R_B
R_C

⇒ For BJT, under saturation condition
I_C = βI_B
I_C > bI_B
I_C is independent of all other parameters
I_C < βI_B

⇒ In a single phase full wave ac regulator, the firing angles in the two half cycles
are always equal
are sometimes equal
are never equal
may be equal or unequal

⇒ Transit time is considered as significant at
HF
MF
LF
all of the above

⇒ In figure, the switch has been in closed position for a long time. At t = 0, the switch is opened. At t = 0⁺, the current R_{10.333333333333333
0.166666666666667
0.25
0.0833333333333333}

⇒ The number of valence electrons in silicon atom is
4
2
1
zero

⇒ Serial in-serial out shift register can be built using D flip flops.
TRUE
FALSE

⇒ In the circuit shown in the fi
only red will glow
only green will glow
both red and green will glow
none will glow

⇒ Satellite communication uses frequencies in the range of
3 to 6 GHz
3-10 MHZ
10-50 GHz
100-200 GHz

⇒ In floating point number 0110100000010101, the exponent is equal to __________ ₁₀
11
-11
10
-10

⇒ A megger has a hand driven dc generator.
TRUE
FALSE

⇒ In a bridge rectifier circuit the rms value of input ac voltage is 10 V. The PIV across each diode is
7.07 V
14.14 V
10 V
28.28 V

⇒ Consider a system whose input x and output y are related by the equa
Causal, LP
BIBO, LTI
BIBO, Causal, LTI
LP, LTI

⇒ In CE approximately, the active region is where the collector curves are
almost horizontal
almost vertical
inclined at 45°
inclined at 60°