Question is ⇒ In a digital measuring device the input electrical signal is in the frequency range of dc to ac (50) Hz. It must be sampled at a rate of, Options are ⇒ (A) f times/sec, (B) 0.5 f times/sec, (C) 0.25 f times/sec, (D) 2 f times/sec, (E) , Leave your comments or Download question paper.

Question is ⇒ In a digital measuring device the input electrical signal is in the frequency range of dc to ac (50) Hz. It must be sampled at a rate of, Options are ⇒ (A) f times/sec, (B) 0.5 f times/sec, (C) 0.25 f times/sec, (D) 2 f times/sec, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a digital measuring device the input electrical signal is in the frequency range of dc to ac (50) Hz. It must be sampled at a rate of
A.	f times/sec [Wrong Answer]
B.	0.5 f times/sec [Wrong Answer]
C.	0.25 f times/sec [Wrong Answer]
D.	2 f times/sec [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In RLC circuits the state variables generally selected are
voltages across capacitors
currents through resistances and voltages across capacitors
currents through resistances and capacitances
currents through inductances and voltages across capacitances

⇒ In auxiliary commutated chopper, the charging and discharging time of capacitor
are constant
depend on load current
may be constant or may depend on load current
none of the above

⇒ The rms voltage measured across each of the circuit element in figure is as shown, when the circuit is excited by a sinusoidal voltage E_s, the rms value of the source voltage e_{s10 volt
2 volt
E_s
5 volt}

⇒ L/C has the dimension of
time
capacitance
inductance
resistance

⇒ In a single phase full wave ac regulator using two thyristors only, the gate circuits of the two thyristors
must be isolated
may or may not be isolated
should be preferably, isolated
should not be isolated

⇒ The PC contains 0450 H and SP contains 08D 6 H. What will be content of P and SP following a CALL to subroutine at location 02 AFH?
0453 H, 08 D 8 H
0453 H, 08 D 4 H
02 AFH, 08 D 8 H
02 AFH, 08 D 4 H

⇒ An electric heater is controlled by thyristors through on-off control. If a = 0.4, the heating is
16% maximum
40% of maximum
60% of maximum
84% of maximum

⇒ The transition of electron from energy level W₁ to W₂ is associated with emission or absorption of electro magnetic radiation of frequency f such that
hf = |W₁ - W₂|
|W₁ - W₂|f = h
hf = 0.5|W₁ - W₂|
(hf)² = |W₁ - W₂|

⇒ Minimum number of 2-input NAND gates required to implement the function F = (x + y) (Z + W) is
3
4
5
6

⇒ Identification of highest priority interrupt can be achieved in a minimum time by which of the following schemes?
Hardwired polling
Priority encode circuit
Software polling
Subdivision of interrupt register into a number of sub registers which are checked parallely

⇒ The temperature coefficient of resistance for a thermistor is
low and negative
low and positive
high and negative
high and positive

⇒ In a D latch
data bit D is fed to S input and D to R input
data bit D is fed to R input and D to S input
data bit D is fed to both R and S inputs
data bit D is not fed to any input

⇒ The temperature coefficient of copper is 0.00393 at 20° C. At 50° C the temperature coefficient is
0.0042
0.0035
0.0025
0.0015

⇒ Which one of the following gain equations is correct for a MOSFET common-source amplif
A_V = g_m/(1 - R_D)
A_V = g_m/R_D
A_V = g_m/(1 + R_D)
A_V = R_D/g_m

⇒ The storage battery used in power stations and substations is generally
nickel cadmium battery
lead acid battery
zinc carbon battery
zinc carbon or lead acid battery

⇒ In ALU 1C 74181 the addition and subtraction is in
2's complement
1's complement
binary
none of the above

⇒ As applied to a flip flop the word edge triggered's means
flip flop can change state when clock transition occurs
flip flop can change state when clock signal goes from LOW to HIGH only
flip flop can change state when clock signal goes from HIGH to LOW only
none of the above

⇒ The use of microprocessor control in automobiles results in
improved fuel economy
improved car control
advanced information system for driver
all of the above

⇒ In a NAND SR latch S = 0, R = 1 then
Q = 0
Q = 1, Q = 0
it is race condition
none of the above

⇒ Power Point is a presentation software.
TRUE
FALSE

⇒ In the network of figure it is desired that maximum power be supplied to Z₂. The values of Z₁ and Z₂ are fixed. However the transformation ratio 'a' of transformer can be changed. The value of 'a' for maximum power transfe
|Z₂|/|Z₁|
[|Z₂|/|Z₁|]^0.5
[|Z₂|/|Z₁|]²
[|Z₂|/|Z₁|]^0.75

⇒ A zener diode is used in
voltage regulator circuit
amplifier circuits
both voltage regulator and amplifier circuit
none of the above

⇒ A device with input x(t) and y(t) is characterized by y(t) = x²(t). An FM signal with frequency deviation of 90 kHz and modulating signal bandwidth of 5 kHz is applied to this device. The bandwidth of the output signal is
370 kHz
190 kHz
380 kHz
95 kHz

⇒ The counter in the given figur
Mod 3
Mod 6
Mod 8
Mod 7

⇒ The factor which will have least effect on the voltage at the load end of a two-wire supply circuit is
length of the circuit
whether supply frequency is 25 Hz or 50 Hz
amount of load on the circuit
cross-section of the circuit wires

⇒ If C is thermal capacitance, m is mass of liquid and c is specific heat, then
C = mc
c = mC
m = cC
C = (mc)²

⇒ A load commutated chopper circuit has
one thyristor
two thyristors
four thyristors
six thyristors

⇒

Assertion (A): Tunnel diode is used in many pulse and digital circuits.

Reason (R): The v-i curve of a tunnel diode resembles letter 'N'.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ The volt ratio box is basically a
potential divider
current transformer
a high resistance voltmeter
either (a) or (c)

⇒ The direction in a Yagi Uda antenna is longer than the radiating element.
TRUE
FALSE