Question is ⇒ In a Darlington pair, Options are ⇒ (A) the emitter of first transistor drives the base of the second, (B) the base of the first transistor drives the emitter of the second, (C) emitters of the two transistors are connected through a resistor, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ In a Darlington pair, Options are ⇒ (A) the emitter of first transistor drives the base of the second, (B) the base of the first transistor drives the emitter of the second, (C) emitters of the two transistors are connected through a resistor, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a Darlington pair
A.	the emitter of first transistor drives the base of the second [Correct Answer]
B.	the base of the first transistor drives the emitter of the second [Wrong Answer]
C.	emitters of the two transistors are connected through a resistor [Wrong Answer]
D.	none of the above [Wrong Answer]
View Answer 3 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ For the transport lag G(jω) = e^-jωT, the polar plot is
a semi circle
a circle
a unit circle
none of the above

⇒ An RLC series circuit is excited by a step voltage E. The units of roots of characteristic equation are
seconds
1/seconds
tesla
henry

⇒ Single parity check is not reliable in case of
paper tape
magnetic tape
magnetic drum
cores

⇒

Assertion (A): A half wavelength line can be used as a 1 : 1 transformer.

Reason (R): The input impedance of a half wavelength line is equal to load impedance.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ High frequency oscillations can be caused by
electric coupling
magnetic coupling
ground loop
all of the above

⇒ When transistor is used as a switch __________ is defined as the interval which elapses between the transition of input waveform and the time when to transition to 90% of I_c(sat).
storage time
fall time
turn-on time
turn-off time

⇒ For measurement of high voltage capacitors the suitable bridge is
Wien bridge
modified De Sauty bridge
Schering bridge
either (a) or (b)

⇒ A function of one of more variables which conveys information on the nature of physical phenomenon is called
Noise
Interference
System
Signal

⇒ The relation between thermal conductivity K (W/m/°C), heat flow density Q (watt/m²) and dT/dx (°C per metre) is
Q = K(dT/dx)
Q = - K(dT/dx)
K = Q(dT/dx)
dT/dx = - QK

⇒ Substitution theorem applies to
Linear network
Non linear network
Linear time invariant network
Any network

⇒ e^-3^t is a
energy signal
power signal
Both (a) and (b)
none

⇒ Which of the following measurements can be done using a counter?

Pulse duration
Interval between two pulses
Amplitude of the pulse
Rise time of a pulse

Select the correct answer from the codes given below:
1 and 2
2 and 3
1 and 4
2 and 4

⇒ The number of operator to accomplish basic arithmetic in Java is
4
5
6
7

⇒ In a series RLC high Q circuit the current peaks at a frequency.
equal to the resonant frequency
greater than the resonant frequency
less than the resonant frequency
none

⇒ A class B amplifier

is biased just at cutoff
has a high theoretical efficiency of 78.5% because its quiescent current is low
is biased at midpoint of load line

Of the above statements
2 and 3 are correct
1 alone is correct
1 and 2 are correct
2 alone is correct

⇒ The frequency tolerance for the RF carrier in the standard AM radio broadcast band is
zero
+20 Hz
+1000 Hz
+25 Hz

⇒ In a JFET the width of channel is controlled by
gate voltage
drain current
source current
all of the above

⇒ The number of product terms in the minimized sum of product expression obtained through the following k map is (where "d" denotes don't care states)
2
3
4
5

⇒ In audio cassettes the width of each recording track is
5 mm
2.5 mm
1.5 mm
1 mm

⇒ In a megger the controlling torque is provided by
spring
gravity
coil
eddy current

⇒ In a 4 bit weighted resistor D/A converter, the resistor value corresponding to LSB is 32 kΩ. The resistor value corresponding to MSB will be
32 KΩ
16 KΩ
8 KΩ
4 KΩ

⇒

Assertion (A): When performance specifications are given in term of transient response characteristics, root locus method is a suitable method.

Reason (R): When performance specifications in terms of state variables are given, modern control methods can be used.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ If the oscillator output is modulated by audio frequencies upto 10 kHz, the frequency range occupied by the side bands will be
711.9 kHz to 712.1 kHz
702 kHz to 722 kHz
692 kHz to 732 kHz
71.2 kHz to 71.20 kHz

⇒ The circuit in figur
rectifier
voltage to frequency converter
frequency to voltage converter
logarithmic amplifier

⇒ In metals, the average drift velocity of electron per unit field is called mobility.
TRUE
FALSE

⇒ An SCR has a turn on time of 4 μs. The gate pulse should have a duration of about
2 μs
5 μs
20 μs
50 μs

⇒ The v-i characteristic of an element is shown in below figure the elemen
non-linear, active, non-bilateral
linear, active, non-bilateral
non-linear, passive, non-bilateral
non-linear, active, bilateral

⇒ Compared to coaxial lines, the advantages of wave guides are
higher power handling capacity
lower loss per unit length
cheaper and simple mechanical structure
all of the above

⇒ Hall's effect can be used to measure
magnetic field intensity
average number of holes
carriers concentration
electrostatic field intensity

⇒ A current of 1 A in the coil of an iron cored electromagnet causes B = 0.5T. If current is 2A, B =
0.5 T
1 T
1 T or more
1 T or less