Question is ⇒ In a common emitter BJT amplifier, the maximum usable supply voltage is limited by, Options are ⇒ (A) avalanche Beakdown of Base-Emitter junction, (B) collector emitter breakdown voltage with base open(βVCEO), (C) collector emitter breakdown voltage with emitter open(βVCEO), (D) zener break down voltage of the emitter base junction, (E) , Leave your comments or Download question paper.

Question is ⇒ In a common emitter BJT amplifier, the maximum usable supply voltage is limited by, Options are ⇒ (A) avalanche Beakdown of Base-Emitter junction, (B) collector emitter breakdown voltage with base open(βVCEO), (C) collector emitter breakdown voltage with emitter open(βVCEO), (D) zener break down voltage of the emitter base junction, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a common emitter BJT amplifier, the maximum usable supply voltage is limited by
A.	avalanche Beakdown of Base-Emitter junction [Wrong Answer]
B.	collector emitter breakdown voltage with base open(βV_CEO) [Wrong Answer]
C.	collector emitter breakdown voltage with emitter open(βV_CEO) [Correct Answer]
D.	zener break down voltage of the emitter base junction [Wrong Answer]
View Answer 1 -6 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The hexadecimal number 5 F is equal to binary number
1010011
1011001
1010101
1011111

⇒ The radiation pattern of a parabola antenna is
omnidirectional
a figure of directional
highly directional
none of the above

⇒ There is no hysteresis phenomenon is any dielectric material.
TRUE
FALSE

⇒ The EHT voltage in a picture tube of TV is
about 1000 kV
about 100 kV
about 15 kV
about 1 kV

⇒ In a rectangular waveguide if operating frequency is greater than cut off frequency then propagation constant is
purely real
purely imaginary
equal to unit
a complex number

⇒ For overdamped systems a quadratic factor in transfer function can be replaced by two first order factors with real poles
TRUE
FALSE

⇒ If the iron core of a coil is removed so that it becomes an air cored coil, its inductance
will increase
will decrease
will remain the same
may increase or decrease

⇒ A high pulse repetition frequency in a radar
increases the maximum range
decreases the maximum range
has no effect on the maximum range
either (a) or (b) depending on other factors

⇒ If low pressure of 10^-6 mm of Hg is required to be measured, we should use
compound pressure gauge
thermocouple vacuum gauge
Pirani gauge
ionization type vacuum gauge

⇒ If e is the charge of an electron, R is the radius of its orbit and ω is the angular velocity of electron, the magnetic dipole moment μ_m of the orbit is |μ_m| = eωR².
TRUE
FALSE

⇒ India's Polar Satellite Launch vehicle (PSLV) to be ready in 1991 is designed to launch 1000 kg spacecraft into __________ orbit.
geostationary
equatorial
polar
sun-synchronous polar

⇒ If sequence y(n) = x(-n) then it is
Causal
Non-Causal
Depends on x(-n)
None

⇒ The impedance 3.2 - j 12 in polar form is given as
6.4 ∠ - 75°
8.4 ∠ - 75°
10.4 ∠ - 75°
12.4 ∠ - 75°

⇒ A boot strap generally incorporates
CB configuration
CE configuration
emitter follower
none of the above

⇒ In a Vidicon camera tube, the beam current is controlled by
grid G₁
grid G₂
grids G₁, G₂, G₃
grid G₂, G₃

⇒ Consider the following

A signal f(t) and its Hilbert transform f_h(t) have the same energy density spectrum
A signal f(t) and its Hilbert transform, f_h(t) have the same auto correlation function
A signal f(t) and its Hilbert transform are mutually orthogonal

Which of the above are true?
1, 2 and 3
1 and 2 only
1 only
2 and 3 only

⇒ Semiconductor ROM's are sometimes preferred to semiconductor RAM's because
ROM's are cheaper than RAMs
ROMs are faster
ROMs do not require power supply for their operations
Programs stored in ROMs cannot be altered either by the power failure or by the user

⇒ In a pulsed RADAR typical value of pulse duration and pulse frequency respectively are
1 μs and 50 Hz
1 μs and 500 Hz
4 μs and 50 Hz
4 μs and 500 Hz

⇒ Which of the following refers to SSB suppressed carrier amplitude modulated system?
A3E
H3E
J3E
C3F

⇒ Which of the following is not a valid variable name in C?
1 a
a 1 2
a b 123
a b c 123

⇒

Match the following:

	List I (Modes)		List II (Characteristic)
A.	Evanescent	1.	Rectangular waveguide does not support
B.	Dominant mode	2.	No wave propagation
C.	TM₁₀ and TM₀₁	3.	Lowest cut-off frequency

A-1, B-2, C-3
A-2, B-3, C-1
A-1, B-3, C-2
A-2, B-1, C-3

⇒ Thermistors are made of
pure metals
pure insulators
tintered mixture of metallic oxides
pure semiconductors

⇒ The Y plates of a CRO are excited by a voltage 2 sin 100 t and the X plates are not connected. The display would be
a vertical line
a horizontal line
sine wave
slant line

⇒ The number of distinct Boolean expression of 4 variables is
16
256
1024
65536

⇒

Assertion (A): A RAM with access time of the order of hundreds of nano seconds is suitable for a control memory.

Reason (R): The time taken to execute an operation in a microcomputer is critically de pendent on access time of control memory.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ In a metal, the valence electrons
are not shared
are shared only between neighbouring atoms
are shared by all atoms
either (b) or (c)

⇒ A Schottky diode clamp is used along with switching BJT for
reducing the power dissipation
reducing the switching time
increasing the value of β
reducing the base current

⇒ The sum of 1110101₂ and 11011₂ in decimal form will be
65
75
85
95

⇒ (SI - A)^-1 = adj(sI - A)/det (sI - A)
TRUE
FALSE

⇒

Assertion (A): In Figure, the intercept of the line on y-axis is equal to N (a_e + a_i), where N is number of atoms/m³, a_e is electronic polarizability and a_i is ionic polarizability.

Reason (R): a_e and a_i are independent of temperatu
Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true