Question is ⇒ In a colour TV receiver, which of the following incorporates colour saturation control?, Options are ⇒ (A) Chroma detector, (B) Colour killer circuit, (C) SAW filter, (D) Chroma amplifier, (E) , Leave your comments or Download question paper.

Question is ⇒ In a colour TV receiver, which of the following incorporates colour saturation control?, Options are ⇒ (A) Chroma detector, (B) Colour killer circuit, (C) SAW filter, (D) Chroma amplifier, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a colour TV receiver, which of the following incorporates colour saturation control?
A.	Chroma detector [Wrong Answer]
B.	Colour killer circuit [Wrong Answer]
C.	SAW filter [Wrong Answer]
D.	Chroma amplifier [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ If a two port network is represented by an equivalent T network the admittance of series arm in term of ABCD parameter is equal to
C
1/C
(A - 1)/B
1/B

⇒ In a rare gas, the molecules of some atoms have an excess positive or negative charge. The electric field tends to shift positive ions relative to negative ions. This is known as ionic polarization.
TRUE
FALSE

⇒ In amplitude modulation
the amplitude of carrier varies in accordance with the amplitude of the modulating signal.
the modulating frequency lies in the audio range
the amplitude of the carrier remains constant
the amplitude of the carrier varies in accordance with the frequency of the modulating signal.

⇒ When a current flows through a coil of insulated wire, the coil shows the properties of a magnet.
TRUE
FALSE

⇒ Which of the following is not a valid variable name in C?
p_ce1
1p_ce
p1_ce
p _ced

⇒ If two mutually exclusive events A and B can happen in m and n ways, then either A or B can happen in (m + n) ways.
TRUE
FALSE

⇒ The maximum range of a transmitter depends on
its frequency
its power
both its frequency and power
none of the above

⇒ A Ge diode operated at a junction temperature of 27°C. For a forward current of 10 mA, V_D is found to be 0.3 V. If V_D = 0.4 V then forward current will be
400 mA
475 mA
477 mA
480 mA

⇒ For an antenna of height h_t metres, the radio horizon is equal to
4h_t metres
4h_t km
2.5h_t km
2.5h_t metres

⇒

Assertion (A): FM requires more bandwidth than AM

Reason (R): Wide band FM is used for broadcast transmissions.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The frame of electric motor is connected to three plates having earthing resistance of 10 Ω, 20 Ω and 30 Ω respectively. The materials of the three plates are copper, aluminium and iron respectively. The percentage of energy dissipated by 10 Ω earthing plate
is more than 50% of total energy
is less than 50% of total energy
depends on the materials of the three plates
may be more or less than 50% of total energy

⇒

Match the following:

	List I (Digital circuit)		List II (Circuit type)
A.	BCD to 7 segment decoder	1.	sequential circuit
B.	4-to-1 MUX	2.	combinational circuit
C.	4 bit shift register	3.	neither sequential nor combinational circuit

A-2, B-1, C-2, D-1
A-3, B-2, C-1, D-3
A-2, B-2, C-1, D-1
A-3, B-1, C-2, D-3

⇒ The system with given pole-zero diagra
casual
non-casual
both sided
not-possible

⇒ If B = 4 + j3, (B)^1/3 =
2 ∠30°
2 ∠36.87°
1.71 ∠12.3°
1.71 ∠30°

⇒

Assertion (A): In C a character constant is either a single alphabet or digit or special symbol enclosed within single inverted commas.

Reason (R): In C the maximum length of a character constant can be 2 characters.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ In the NMOS inverter
the driver and achieve load are enhancement type
the driver is enhancement type and load depletion type
both driver and load are depletion type
the driver and load are depletion type

⇒ In bridge circuit of figure, equivalent resistance between A and B
1 Ω
0.5 Ω
2 Ω
1.5 Ω

⇒ The system in the given figur
type 0 system
type 1 system
type 2 system
type 3 system

⇒ In a BJT CE amplifier circuit the value of coupling capacitor should be such that
its reactance is small for the lowest frequency in the input and output
its reactance is high for the lowest frequency in the input and output
its reactance is zero for the lowest frequency in the input and output
its reactance is infinite for the lowest frequency in the input and output

⇒ The value of parameter r_e used in r_e transistor model
increases with increase in temperature
decreases with increase in temperature
is not affected by increase in temperature
either (b) or (c)

⇒ A difference amplifier using op-amp has closed loop gain = 50. If input is 2 V to each of inverting and non-inverting terminals, output is 5 mA. Then CMRR =
20000
2000
200
20

⇒ The frequency at which phase angle is 180° is called
phase crossover frequency
stability limit frequency
frequency of limited stability
gain margin frequency

⇒ Friction forces acts in a direction
opposite to that of velocity
same as that of velocity
at right angle to that of velocity
partly opposite and partly at right angle to the direction of velocity

⇒ Many circles are drawn in a Smith chart used for transmission line calculations. The circle shown in the figure represe
unit circles
constant resistance circles
constant reactance circles
constant reflection coefficient circles

⇒ The time required for horizontal blanking is 16% of that for each horizontal line. If horizontal time is 63.5 μs, the horizontal blanking time for each line is about
1 μs
10 μs
100 μs
none of the above

⇒ Consider the instructions

MOV M, B
OUT 4
LDA X

Which of the above uses IO/W cycle?
1 only
1 and 2 only
2 only
3 only

⇒ If the carrier modulated by a digital bit stream has one of the possible phases of 0°, 90°, 180° and 270°. Then the modulation is called
BPSK
QPSK
QAM
MSK

⇒ Maximum usable frequency is [f_muf]
f_c sec i
f_c cos i
f_c sin i
f_c sec i

⇒ Ferroelectric materials are those which
cannot be polarized
have a permanent polarization
have a_e equal to zero
have μ_p = 0

⇒ Gain stability in an oscillator can bs achieved by
providing negative feedback
providing positive feedback
using low Q circuits
controlling the gain