Question is ⇒ In a colour TV receiver, the sound intercarrier IF is generated in, Options are ⇒ (A) video detector, (B) video IF amplifier, (C) tuner mixer stage, (D) limiter stage, (E) , Leave your comments or Download question paper.

Question is ⇒ In a colour TV receiver, the sound intercarrier IF is generated in, Options are ⇒ (A) video detector, (B) video IF amplifier, (C) tuner mixer stage, (D) limiter stage, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a colour TV receiver, the sound intercarrier IF is generated in
A.	video detector [Correct Answer]
B.	video IF amplifier [Wrong Answer]
C.	tuner mixer stage [Wrong Answer]
D.	limiter stage [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The speed at which axial electric field due to signal advances in a TWT is equal to
speed of light
(speed of light) (helix pitch helix circumference)
(speed of light) (helix circumference helix pitch)
(speed of light) (helix pitch) (helix circumference)

⇒ A signal having uniformly distributed amplitude in the interval (- V to + V) is to be encoded using PCM with uniform quantization. The signal to quantization noise ratio is determined by
dynamic range of signal
sampling rate
number of quantizing levels
power spectrum of signal

⇒ Find R_L for maximum power trans
3 Ω
1.125 Ω
4.1785 Ω
None of these

⇒ In the given figure shows a 4 bit serial in parallel out right shift register. The initial contents as shown are 0110. After 3 clock pulses the contents wil
0
101
1010
1111

⇒

Assertion (A): In 8085, the zero flag is set when ALU operation results in 0. If the result is not 0, this flag is reset.

Reason (R): In 8085 the S flag is set when the contents of accumulator become negative during execution of an instruction.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ To neglect a current source the terminals across the source are
replaced by some resistance
replaced by capacitance
open-circuited
short-circuited

⇒ Secondary emission occurs in
diode
triode
tetrode
pentode

⇒ An RLC series circuit is excited by a step voltage E. The circuit current at t = 0 is
E/R
E/LC
zero
infinity

⇒ Indium, aluminium, arsenic are all p type impurities.
TRUE
FALSE

⇒ For the K map in the given figure the simplified Boolean expressio
A C + A D + ABC
A C + A D + ABC
A C + A D + ACD
A C + A D + AB C

⇒ Push pull amplifier is
voltage amplifier
current amplifier
power amplifier
none of the above

⇒ In the figure shown, A₁, A₂, A₃ are identical Ammeters. If A₁ and A₃ read 5 and 13 A respectively, reading of A₂ wil
8
13 A
18
0

⇒ When satellite radio beam is aimed towards earth, it illuminates on the earth for an oval shaped area called
foot print
beam area
satellite service area
radiated area

⇒ Flash ADC is
serial ADC
parallel ADC
series-parallel ADC
successive approximation ADC

⇒ The main use of JFET with a
frequency mixer
source follower
voltage doubler
trigger

⇒ For a level input sequential circuit
output in a level only
output is in the pulse form
output may be a pulse or a level form
none of these

⇒ Electrostatic voltmeter is suitable only for low voltages.
TRUE
FALSE

⇒ The effective height of an antenna is slightly greater than physical height because
wave velocity in conductor is less than its velocity in free space
wave velocity in conductor is more than its velocity in free space
resistance of conductor is less than that of free space
none of the above

⇒ Which inverter circuit uses coupled inductors?
Modified McMurray full bridge inverter
McMurray Bedford half bridge inverter
Modified McMurray Bedford half bridge inverter
Both (b) and (c)

⇒

Assertion (A): In KVL equations involving mutually coupled circuits the sign of M terms can be positive or negative.

Reason (R): Dot convention helps in determining sign of M terms in KVL equations.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Commercial Frequency deviation of FM is
70 kHz
75 kHz
80 kHz
65 kHz

⇒ The symbol ! in Java means
logical NOT
logical OR
AND
logical XOR

⇒ A sinusoidal voltage has peak to peak value of 100 V. The rms value is
50 V
70.7 V
35.35 V
141.41 V

⇒ In 8085 microprocessor, what is the memory word addressing capability?
32 K
64 K
256 K
512 K

⇒ An ac tachometer has a drag cup construction so that
rotor inertia is low
rotor body is conducting
rotor is easy to fabricate
both (a) and (b)

⇒ In an Anderson bridge the unknown inductance is measured in terms of
known inductance and resistance
known inductance
known capacitance and resistance
known capacitance

⇒ The disadvantage of direct coupled amplifiers is
drift
large size of transistor
low voltage gain
both (b) and (c)

⇒ Drain feedback bias is often used with
D MOSFETs
E MOSFETs
both D and E MOSFETs
neither D nor E MOSFETs

⇒ A battery charger can drive a current of 5A with 1Ω resistance connected at its output. If it can charge 2 V battery at 7 A rate, its Thevenin's equivalent circuit will be
7.5 in series with 0.5 Ω resistance
1.25 V in series with 1.5 Ω resistance
7.5 V in parallel with 0.5 Ω resistance
12.5 V in parallel with 1.5 Ω resistance

⇒

Assertion (A): McMurray Bredford half bridge inverter uses complementary commutation

Reason (R): Three phase inverter can have two modes of operation.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct