Users Also Read

MCQ's Search Engine

Electrical Engineering

Mechanical Engineering

Civil Engineering

Automobile Engineering

Chemical Engineering

Computer Engineering

Electronics Engineering

Medical Science Engg

Q1. | In a class C power amplifier |

A. | resonant frequency of tuned circuit is equal to fundamental frequency of pulsed waveform [Correct Answer] |

B. | resonant frequency of tuned circuit is half the fundamental frequency of pulsed waveform [Wrong Answer] |

C. | resonant frequency of tuned circuit has no relation to the fundamental frequency of pulsed waveform [Wrong Answer] |

D. | either (b) or (c) [Wrong Answer] |

View Answer
Explanation:-
Answer : ADiscuss it below :!! OOPS Login [Click here] is required to post your answer/resultHelp other students, write article, leave your comments |

**Also Read Similar Questions Below :**

⇒ To couple a coaxial line to a parallel to wire line it is best to use a

slotted line

balun

directional coupler

quarter wave transformer

⇒ The derivative of unit step function is

unit impulse

ramp with slope 1

impulse

either (a) or (b)

⇒ In the circuit shown, the power supplied by the voltage so

0 W

5 W

10 W

100 W

⇒ The troposphere extends from earth surface to a height of

15 km

90 km

150 km

200 km

⇒ Which device has internal positive feedback?

Two cavity klystron amplifier

Multi-cavity klystron amplifier

Reflex klystron amplifier

All of the above

⇒ The percentage limiting error in an instrument reading 8.3 V and having guaranteed accuracy of 1% of the full scale reading and range of 0-150 V is

0.0181

0.00181

0.181

0.000018

⇒

Match the following:

List I (Set operation) | List II (Set operator) | ||
---|---|---|---|

A. | Set equality | 1. | - |

B. | Set inclusion | 2. | = |

C. | Set intersection | 3. | < = |

D. | Set difference | 4. | ∗ |

A-2, B-3, C-4, D-1

A-3, B-2, C-4, D-1

A-1, B-2, C-3, D-4

A-4, B-2, C-3, D-1

⇒ To convert JK flip flop to D flip flop

connect D to both J and K

connect D to J directly and D to K through inverter

connect D to K directly and D to J through inverter

connect D to K and leave J open

⇒ If D is diameter of circular waveguide the cutoff wave-length for TE

_{11}mode is equal to

1.706 D

2.11 D

0.82 D

0.41 D

⇒ The dielectric losses do not depend on frequency.

TRUE

FALSE

⇒ Digital circuits mostly use

Diodes

Bipolar transistors

Diodes and bipolar transistors

Bipolar transistors and FETs

⇒ In the network shown in figure, the voltage drops across R

_{2}and R

_{3}are 10 V and 16 V with polarities as shown. The current in R

_{1is 9 A and directed towards node 0is 9 A and directed away from node 0is 9 A but directed of current cannot be foundis impossible to be found}

⇒ The no. of comparators required in a 3 bit comparator type ADC is

2

3

7

8

⇒ In an hydrogen atom, an electron moves in the field of a proton. The stability of orbit requires equilibrium between coulomb's force and centrifugal force.

TRUE

FALSE

⇒ A lossless transmission line is 50 cm long and operates at a frequency of 500 MHz. Inductance and capacitances present in a line are 0.5 μH/m and 200 pF/m. Phase constant and phase velocity are respectively.

5p, 2p x 10

^{8}m/sec

5p, 10

^{8}m/sec

31.4, 10

^{8}m/sec

31.4, 2p x 10

^{8}m/sec

⇒ A system is said to be static system, when present output depend upon

present I/P

presrent and past

present and future

past and future

⇒ The circuit shown in the figure is tha

non-inverting amplifier

Inverting amplifier

an oscillator

Schmitt trigger

⇒ The number of select lines in a 16 : 1 multiplexer are

4

3

2

1

⇒ Which of the following figures is an ideal equivalent circuit of a n-p-n transis

figure A

figure B

figure C

none

⇒ The device having highest photo sensitivity is

photoconductive cell

photovoltaic cell

photodiode

phototransistor

⇒ Consider the following statements about PCM

- PCM is not noise resistant
- PCM requires complex encoding and quantizing circuitry
- PCM requires large bandwidth

1 only

1, 2, 3

2, 3

1 and 3

⇒ The PCM signal shown below uses amplitude level of +1 volt and -1 volt to represent binary symbol 0 and 1 respectively. Each code word consists of 4 bits. The sampled version of analog signal from which this PCM signal is derived

EB596

CD231

DA495

25B6A

⇒ The hexadecimal number given below represent decimal numbers which are multiples of DC, C8, BE, 46, IE

2

6

7

10

⇒ The RC network of wein bridge oscillator consists of resistors and capacitors of values R = 220 kΩ and C = 250 PF Determine the frequency of oscillation

2.98 kHz

3 kHz

2 kHz

10 kHz

⇒ Silicon and germanium are elements in the

second column of periodic table

third column of periodic table

fourth column of periodic table

fifth column of periodic table

⇒ The input impedance for a half dipole if radii of both the antenna is 4 and 8 meter respectively

600 Ω

100 Ω

657 Ω

650 Ω

⇒ If the number of ways an event may result ins analysed into

*m*successes and

*n*failures, each equally likely to occur, the probability of success in a single trial is

*m*(

*m*+

*n*)

TRUE

FALSE

⇒ Which of the following is correct for a driving point functions?

The real parts of all poles must be negative

The real parts of all poles and zeros must be negative

The real parts of all poles and zeros must be negative or zero

The real parts of all zeros must be negative

⇒

**Assertion (A):** Standard deviation is the abscissa of a point of inflection on the probability curve.

**Reason (R):** The equation for probability curv

Both A and R are correct and R is correct explanation of A

Both A and R are correct but R is not correct explanation of A

A is true, R is false

A is false, R is true

⇒ The double energy transients occur in the

pure inductive coil

R-L circuit

R-C circuit

R-L-C circuit