Question is ⇒ In a class C operation VCC = 40 V and VCE(sat) = 0.4 V. The efficiency is, Options are ⇒ (A) 0.9, (B) 0.495, (C) 0.01, (D) 0.005, (E) , Leave your comments or Download question paper.

Question is ⇒ In a class C operation VCC = 40 V and VCE(sat) = 0.4 V. The efficiency is, Options are ⇒ (A) 0.9, (B) 0.495, (C) 0.01, (D) 0.005, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a class C operation V_CC = 40 V and V_CE(sat) = 0.4 V. The efficiency is
A.	0.9 [Correct Answer]
B.	0.495 [Wrong Answer]
C.	0.01 [Wrong Answer]
D.	0.005 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ For good quality signal transmission all frequency components should have the same transmission delay, t_d and same phase shift-Φ_s. What can be said about the statement?
Correct
True from t_d but not for Φs
Not true for t_d but true for Φ_s
Both t_d and Φ_s are not involved in quality

⇒ It is desired to reduce distortion in an amplifier from 8% to 2% by using 5% negative feedback. The open and closed loop gains respectively are
60 and 15
15 and 60
6 and 1.5
1.5 and 6

⇒ In an R-C series circuit excited by a voltage E, the charge across capacitor at t = 0⁺ is
0
CE
CE (1 - e^-t/RC)
none of the above

⇒ Which mode has the lowest cut off frequency in circular wave guides?
TE₀₁
TE₁₁
TE₂₀
TE₂₁

⇒ The unit of loudness is
phon
sone
decibel
mel

⇒ In figure (A) and
A represents PCM and B represents AM
A represents FM and B represents AM
A represents AM and B represents FM
A represents PCM and B represents FM

⇒ In an FM system, when the AF is 500 Hz and the AF voltage is 2.4 V, the deviation is 4.8 kHz. If the AF voltage is now increased to 7.2 V, the new deviation will be
4.8 kHz
9.6 kHz
14.4 kHz
28.8 kHz

⇒ The electrolyte in a dry cell is completely dry.
TRUE
FALSE

⇒ If the Q of a single stage single tuned amplifier is doubled, the bandwidth will
remain the same
become half
become double
become four times

⇒

Assertion (A): In series R-L-C circuit, the current may lead or lag the voltage depending on the value of R.

Reason (R): Phase angle of an R-L series circuit is tan^-1 (ωL/R).

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ In a tape recorder
both record and erase heads have high permeability core
the record head has high permeability core but the erase head has low permeability core
the record head has low permeability core but the erase head has high permeability core
both record and erase heads have low permeability core

⇒ Generally the gain of a transistor amplifier falls at high frequencies due to the
internal capacitance of device
coupling capacitor at the I/P
skin effect
coupling capacitor at the O/P

⇒ A planar graph has 6 nodes and 7 branches. The number of meshes in the dual graph is
2
3
4
6

⇒ The analog signal given below is sampled at 1200 samples per second. m(t) = 2 sin 120 pt + 3 sin 240 pt + 4 sin 360 pt + 5 sin 480 pt + 6 sin 600 pt + 7 sin 720 pt. The folding (maximum) frequency is __________ .
300 Hz
360 Hz
600 Hz
480 Hz

⇒ In FM reception, amplitude disturbances due to static change
reduce the signal frequencies
increase the signal frequencies
disturb the signal frequencies
do not affect the signal frequencies

⇒ In major diatonic musical scale, an octave is divided into
12 intervals
10 intervals
7 intervals
5 intervals

⇒ Which op-amp circuit uses a resistance in series with input and capacitor in feedback path?
Differentiating amplifier
Integrating amplifier
Logarithmic amplifier
Exponential amplifier

⇒ An n type silicon bar 0.1 cm long and 100 μm² in cross-sectional area has a majority carrier concentration of 5 x 10²⁰/m³ and the carrier mobility is 0.13 m⁰/V-s at 300k. If the charge of an electron is 1.6 x 10^-19 coulomb, then the resistance of the bar is
10⁶ ohm
10⁴ ohm
10^-1 ohm
10^-4 ohm

⇒ A transmission line is feeding 1 watt of power to a horn antenna having a gain of 10 dB. The antenna is matched to the transmission line. The total power radiated by the horn antenna into the free space is
10 watts
1 watt
0.1 watt
0.01 watt

⇒ A thermistor is a
thermocouple
thermometer
miniature resistance
heat sensitive explosive

⇒ The Nyquist plot of a stable, transfer function G(s) is shown in the figure. We are interested in the stability of the closed loop system in the feedback configuration sh
G(s) is an all-pass filter
G(s) has a zero in the right-half plane
G(s) is the impedance of a passive network
G(s) is marginally stable

⇒ Ferrimagnetic materials have anti-parallel orientation of equal moments of permanent dipoles.
TRUE
FALSE

⇒ Fermi level is the amount of energy in which
a hole can have at room temperature
an electron can have at room temperature
must be given to an electron move to conduction band
none of the above

⇒ Which of the following device acts as an N-P-N and a P-N-P transistor connected base to base and emitter to controller?
UJT
SCR
Diac
Triac

⇒ India's first three-axis stabilised geostationary communication satellite is
Rohini
Aryabhatta
Apple
Bhaskara

⇒ A sample of N-type semiconductor has electron density of 6.25 x 10¹⁸/cm³ at 300k. If the intrinsic concentration of carriers in this sample is 2.5 x 10¹³/cm³ at this temperature the hole density works out to be
10⁶/cm³
10⁸/cm³
10¹⁰/cm³
10^l2/cm³

⇒ What are the contents of the accumulator after the RIC has been executed?
40 H
41 H
42 H
43 D

⇒ Current through a charging capacitor exhibits
an exponential growth function
an exponential decay function
a step decay function
a linear decay function

⇒ The radiation pattern of Hertzian dipole in the plane perpendicular to dipole is a
null
circle
figure of eight
none of the above

⇒ The electric breakdown strength is affected by
shape of the waveform of applied voltage
steepness of the wavefront of the applied voltage
composition of the material
all of the above