Question is ⇒ In a centre tap full wave rectifier, 50 V is the peak voltage between the centre tap and one of the ends of the secondary. The maximum voltage across the reverse biased diode will be, Options are ⇒ (A) 100 V, (B) 72 V, (C) 50 V, (D) 38 V, (E) , Leave your comments or Download question paper.

Question is ⇒ In a centre tap full wave rectifier, 50 V is the peak voltage between the centre tap and one of the ends of the secondary. The maximum voltage across the reverse biased diode will be, Options are ⇒ (A) 100 V, (B) 72 V, (C) 50 V, (D) 38 V, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a centre tap full wave rectifier, 50 V is the peak voltage between the centre tap and one of the ends of the secondary. The maximum voltage across the reverse biased diode will be
A.	100 V [Correct Answer]
B.	72 V [Wrong Answer]
C.	50 V [Wrong Answer]
D.	38 V [Wrong Answer]
View Answer 4 -2 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The gain of an antenna with a circular aperture of diameter 3 metres at a frequency of 5 GHz, will be
2.4674
24.674
246.74
24674

⇒ A time varying magnetic field produces
electric field only
magnetic field only
both magnetic and electric fields
none of the above

⇒ The typical squelch circuit
cuts off an IF amplifier when the AGC is maximum
cuts off an IF amplifier when the AGC is minimum
cuts off an audio amplifier when the carrier is absent
eliminates the RF interference when the signal is weak

⇒ In a N-type semi-conductor, the concentration of minority carriers is mainly depends on
the number of acceptor atoms
the number of donor atoms
the extent of doping
the temperature of the material

⇒ Which of the following is used as a passive component in electronic circuits?
Tunnel diode
Capacitor
Transistor
Vacuum tube

⇒ In a sine wave, maximum rate of change of voltage occurs at
ascent of the waveform
+ ve maximum
- ve maximum
between maximum and minimum

⇒ In a Gunn diode oscillator drift velocity of electron is 10⁷ cm/s and active region length is 10 x 10^-4 cm. The natural frequency of oscillation is
1 MHz
10 MHz
1 GHz
10 GHz

⇒ A dipole antenna of λ/8 length has an equivalent total loss resistance of 1.5 Ω. The efficiency of the antenna is
0.0089159
0.089159
0.89159
8.9159

⇒ An infinite ladder is constructed with 1 Ω and 2 Ω resistors as shown below. Find i
8.1818 A
0
0.375
cannot be determined

⇒ A sine wave is passed through an amplifier which severely limits it symmetrically. If then passes to a second amplifier which is narrow band and tuned to the frequency of the original sine wave. What will be the output wave from this second amplifier?
A square wave of the same frequency as that of the original sine wave
A square wave of double the frequency of that of original sine wave
A sine wave of constant amplitude at the frequency of the original sine wave
A sine wave of constant amplitude at double frequency of the original sine wave

⇒ Strip lines are used at
microwave frequency
low frequency
High frequency
at any frequency

⇒ A 4 bit synchronous counter uses flip flops with a delay time of 15 ns each. The time required for change of state is
15 ns
30 ns
45 ns
60 ns

⇒
Match the following:
List I List II
A. DMA controller 1. Interface between computer and video display adapter
B. CKT controller 2. Used to read data directly from disk into directly memory
C. Interrupt controller 3. Supervises the operation of control signal

A-1, B-2, C-3
A-2, B-3, C-1
A-3, B-2, C-1
A-2, B-1, C-3

⇒ In every practical oscillator, the loop gain is slightly larger than unity and the amplitude of the oscillations is limited by the
magnitude of the loop gain
onset if non-linearity
magnitude of gain of the amplifier
feedback transmission factor

⇒ A network has two branches in parallel. One branch contains impedance Z₁ and the other branch has impedance Z₂. If it is fed from an ac voltage V of frequency f, the current through Z₁ depends, on
V, Z₁, Z₂
V, Z₁
Z₁, Z₂
V, Z₁, f

⇒
Assertion (A): In p type semiconductor conduction is mainly due to holes.
Reason (R): In p type material the holes are majority carriers.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ In a modulator it is found that the amplitude spectrum consists a component at f_c, the carrier frequency and one component each at f_c - f_s and f_c + f_s where f_s is the modulating signal frequency. Then the modulator used is
AM
AM or MBFM with modulation index 0.5
FM
PAM

⇒ 25 persons are in a room. 15 of them play hockey, 17 of them play football and 10 of them play both hockey and football. Then the number of persons playing neither hockey nor football is:
2
17
13
3

⇒ The quantum numbers associated with electron motion are designed as
a, b, c
h, k, l
n, m, l
h, n, l

⇒ The mobile unit of a mobile telephone is generally in
vehicles
pocket
office
vehicle or pocket

⇒ If all other parameters are the same, a capacitor with mica as dielectric has higher capacitance than air capacitor.
TRUE
FALSE

⇒ With negative feedback the closed loop gain is always less than open loop gain.
TRUE
FALSE

⇒ Power factor of the following circuit will be unity
inductance
capacitance
resistance
both (a) and (b)

⇒ Signal flow graph is used to find :
stability of the system
controllability of the system
transfer function of the system
poles of the system

⇒ 10 in BCD code represent
10100
1100
10111
None of the above

⇒ A XOR gate has inputs A and B and output Y. Then the output equation is
Y = AB
Y = AB + A B
Y = A B + A B
Y = A B + A B

⇒ For making a capacitor it is better to have a dielectric having
high permittivity
low permittivity
permittivity same as that of air
permittivity which is neither high nor low

⇒ Stability factor for S is given by for a fixed bias
1 + β
1 - β
1/β
β - 1

⇒ In 2's complement addition, the carry generated in the last stage is
added to LSB
neglected
added to bit next to MSB
added to the bit next to LSB

⇒
Assertion (A): For Diamond, μ_r = 1
Reason (R): Diamond is a diamagnetic material.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

	List I		List II
A.	DMA controller	1.	Interface between computer and video display adapter
B.	CKT controller	2.	Used to read data directly from disk into directly memory
C.	Interrupt controller	3.	Supervises the operation of control signal

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math