Question is ⇒ In a CE bipolar transistor operating in active region, collector current is independent of, Options are ⇒ (A) VCE, (B) IB, (C) both VCE and IB, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ In a CE bipolar transistor operating in active region, collector current is independent of, Options are ⇒ (A) VCE, (B) IB, (C) both VCE and IB, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a CE bipolar transistor operating in active region, collector current is independent of
A.	V_CE [Correct Answer]
B.	I_B [Wrong Answer]
C.	both V_CE and I_B [Wrong Answer]
D.	none of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The number of operator to accomplish basic arithmetic in Java is
4
5
6
7

⇒ In a bridge inverter
an output transformer is essential
an output transformer is not essential
an output transformer cannot be connected
an output transformer, if used, can improve the efficiency of the circuit

⇒ In the dimension statement DIMENSION A (50, 50), K (100, 100) the total number of locations reserved will be
2500
100000
125000
250000

⇒ The circuit given below
Band stop filter
Band pass filter
Oscillator circuit
All pass filter

⇒ ECL has high switching speed because the transistors are
switching between cutoff and saturation regions
switching between cutoff and active regions
switching between active and saturation regions
none of the above

⇒ Two coils X of 1000 turns and Y of 2000 turns are placed such that 60% of the flux produced by coil X links coil Y. A current of 1 A in coil X produces 0.1 wb flux. The mutual inductance between coils is
0.12 H
0.08 H
0.06 H
0.04 H

⇒ 71₈ = __________ .
111000₂
111001₂
100001₂
110001₂

⇒ Ridge waveguide is essentially a form of capacitively loaded guide.
TRUE
FALSE

⇒ Which class of amplifiers operates with least distortion?
Class A
Class B
Class C
Class AB

⇒ The pole of a reactive function
lie on jω axis only
lie on negative real axis only
may lie anywhere on s plane
lie on jω axis or on negative real axis

⇒ In a class C operation V_CC = 40 V and V_CE(sat) = 0.4 V. The efficiency is
0.9
0.495
0.01
0.005

⇒ In a N-P-N transistor, when emitter junction is forward biased and collector junction is reverse biased, the transistor will operate in
active region
saturation region
cut of region
inverted region

⇒ When a diode is forward biased, the diode current is
high
low
zero
low or zero

⇒ DeMorgan's second theorem is
A . A = 0
A = A
A + B = A . B
AB = A + B

⇒ In a class C operation V_CC = 40 V, R_L = 50 Ω. The maximum load power can be
64 W
32 W
16 W
8 W

⇒ In microwave detector used in laboratory measurements of relative power levels, standing wave ratio is about
0.1
1.25
5
10

⇒ Which one of the following is a cut set of the graph in the given fig
1, 2, 3, and 4
2, 3, 4, and 6
1, 4, 5, and 6
1, 3, 4, and 5

⇒ Which one is a non-causal system?
y(n) = x(2n)
y(n) = x(n/2)
y(n) = x(n/2) + x(n)
all

⇒ A single phase half wave regulator uses
2 diodes and 2 thyristors
2 thyristors
1 diode and 1 thyristor
2 diodes

⇒ A digital system is required to amplify a binary encoded audio signal. The user should be able to control the gain of the amplifier from a minimum to a maximum in 100 increments. The minimum number of bits required to encode, in straight binary is,
8
6
5
7

⇒ In a loss-less transmission line
R << ω L; G << ω C
R = ω L, G = ω C
R >> ω L; G >> ω C
none of the above

⇒ Two identical FETs each having parameters g_m and r_d are connected is parallel. The composite FET has parameters
0.5 g_m and 2 r_d
0.5 g_m and 0.5 r_d
2 g_m and 2 r_d
2 g_m and 0.5 r_d

⇒ When a line short circuited at far end, the minimum voltage occurs at
far end
source end
midway between source and far end
none of the above

⇒ In rectifier circuits, ripple factor RF and form factor FF are related as
RF = (FF² - 1)^0.5
RF = FF
RF = FF - 1
RF = (FF - 1)^0.5

⇒ A discrete random variable X takes values from 1 to 5 with probabilities as shown in the table. A student calculates the mean of X and 3.5 and her teacher calculates the variance of X as 1.5. Which of the following statements is t
Both the student and the teacher are right
Both the student and the teacher are wrong
Both the student is wrong but the teacher is right
The student is right but the teacher is wrong

⇒ In order to achieve good stabilization in potential divider method current I₁ through R₁ and R₂ should be
I₁ > 20 I_B
I₁ > 15 I_B
I₁ < 5 I_B
I₁ > 10 I_B

⇒ As access time is decreased, the cost of memory
remains the same
increases
decreases
may increase or decrease

⇒ The first geostationary satellite launched in 1965 was called
ANIK
EARLY BIRD (Intelsat-I)
WESTAR
MOLNIYA

⇒

Assertion (A): PIN diode is commonly used for microwave control.

Reason (R): A PIN diode uses heavily doped p and n materials.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The internal impedance of a source is 3 + j 7 Ω. For maximum power transfer, load impedance should be
3 + j 7 Ω
3 - j 7 Ω
7 + j 3 Ω
7 - j 3 Ω