Question is ⇒ In a CE amplifier it is desired that the signal should be able to swing equally in both directions. Then the Q point should be, Options are ⇒ (A) at the centre of ac load line, (B) at the centre of dc load line, (C) at the centre of collector voltage, (D) at the centre of collector current, (E) , Leave your comments or Download question paper.

Question is ⇒ In a CE amplifier it is desired that the signal should be able to swing equally in both directions. Then the Q point should be, Options are ⇒ (A) at the centre of ac load line, (B) at the centre of dc load line, (C) at the centre of collector voltage, (D) at the centre of collector current, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a CE amplifier it is desired that the signal should be able to swing equally in both directions. Then the Q point should be
A.	at the centre of ac load line [Correct Answer]
B.	at the centre of dc load line [Wrong Answer]
C.	at the centre of collector voltage [Wrong Answer]
D.	at the centre of collector current [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In the wave mechanical theory, the maximum of the charge distribution in the ground state occurs for a distance from the nucleus equal to
first Bohr radius
second Bohr radius
third Bohr radius
either first or second Bohr radius

⇒ A radiation thermometer is suitable for temperatures
below 500°C
below 100°C
above 500°C
above 1400°C

⇒ In a 3 input NOR gate, the number of states in which output is 1 equals
1
2
3
4

⇒ Consider the CMOS circuit shown, where the gate voltage V_G of the n-MOSEFT is increased from zero, while the gate voltage of the p-MOSFET is kept constant at 3 V. Assume that, for both transistor, the magnitude of the threshold voltage is 1 V and the product of the transconductor parameter and the (W/L) ratio, i.e. the quality μC_0x(W/L), is 1mA. V^{-2Both the MOSFET are in saturation region
Both the MOSFET are in triode region
n-MOSFET is in triode and p-MOSFET is in saturation region
n-MOSFET is in saturation and p-MOSFET is in triode region}

⇒ In a dual converter operated in circulating current mode, the circulating current flows
when load current is zero
when load current is non-zero
even when load current is zero
none of the above

⇒ The current due to thermionic emission is proportional to
T
T²
T³
T⁴

⇒ If for a silicon n-p-n transistor, the base to emitter voltage (V_BE) is 0.7 V and the collector to base voltage V_CB is 0.2 Volt, then the transistor is operating in the
normal active mode
saturation mode
inverse active mode
cut off mode

⇒ A microcomputer has a 64 K memory. What is the hexadecimal notation for the first memory location?
0
FFFF
0FFF
3FFF

⇒ In analog signal given below is sampled at such a rate that the samples of signal can be given to a collection of buffers having capacity of either 24 samples/sec. or 25 samples/sec. The sampling rate is minimum such that it fully utilizes the collection of both types of buffers m(t) = 2 sin 480pt + 3 sin 720 pt<
600 Hz
300 Hz
1200 Hz
2400 Hz

⇒ Which of the following is used to provide tracking between RF amplifier and local oscillator stages of receiver?
Variable tuning inductor
Ganged tuning inductor
Variable capacitor
Variable preset

⇒ Rotation of a geosynchronous satellite means its
drift from stationary position
wobbling
three-axis stabilization
three-dimensional stabilization

⇒ A series RLC circuit has a resonant frequency of 2000 Hz. The maximum voltage across C is likely to occur at a frequency of about
1000 Hz
4000 Hz
2025 Hz
1975 Hz

⇒ The measurement of Hall coefficient of a semiconductor with one type of charge carriers gives the information about
sign of charge carrier
density of charge carrier
both sign and density of charge carrier
none of the above

⇒ High frequency waves are
absorbed by F₂ layer
affected by solar cycle
reflected by D layer
none of the above

⇒ A remote control of TV uses a 10 bit word. The maximum number of total commands it can transmit is
64
256
512
1024

⇒ The constant magnitude of G(s) plane are
a family of straight horizontal lines
a family of straight inclined lines with positive slope
a family of straight inclined lines with negative slope
a family of circles

⇒ Due to the formation of Schottky defects the density of the crystal
increases slightly
increases appreciably
decreases slightly
decreases appreciably

⇒ If x_k = a^k and k &l
TRUE
FALSE

⇒ A/D parallel converter is also called flash converter.
TRUE
FALSE

⇒ Read the following statements about sets
If A and B are sets then A + B denotes union of sets A and B.
The union of A and B is that set whose elements are in either A or B or both.
If A and B are sets, then difference of sets A and B is denoted by A - B.
A - B in the set obtained by removing elements of A from B.
Which of the above are true?
All
1, 2 and 3 only
2 and 3 only
1 and 4 only

⇒ The function in the given figure can be writte
u(t - 1) sin p ( t - 1) - u(t - 3) sin p (t - 3) + u(t - 4) sin p (t - 4) - u(t - 6) sin p (t - 6)
u(t - 1) sin p ( t - 1) - u(t - 3) sin p (t - 3) + u(t - 4) sin p (t - 4)
u(t - 1) sin p ( t - 1) + u(t - 4) sin p (t - 4)
u(t - 1) sin 2p ( t - 1) + u(t - 4) sin 2p (t - 4)

⇒ DOS has a command named ' DIRECTORY '.
TRUE
FALSE

⇒ The shot circuit admittance matrix of a two port network is
non-reciprocal and passive
non-reciprocal and active
reciprocal and passive
reciprocal and active

⇒ If the target area is small compared to wavelength of radar the situation is called
resonance region
Rayleigh region
optical region
binomial region

⇒ In a CRO, the time base signal is applied to
X plates
Y plates
either X or Y plates
alternately X and Y plates

⇒ Decade counter has 4 flip flops and skips states 10 to 15.
TRUE
FALSE

⇒ In measurements using CRO, Lissajous patterns are used to
measure magnitude of peak voltage
measure frequency
measure impedance
measure current

⇒ Find R_{TH200 Ω
0 Ω
400 Ω
None of these}

⇒ A transmission line is feeding 1 watt of power to a horn antenna having a gain of 10 dB. The antenna is matched to the transmission line. The total power radiated by the horn antenna into the free space is
10 watts
1 watt
0.1 watt
0.01 watt

⇒ A rectifier circuit has load resistance R. It uses a capacitance filter having capacitance C. For low ripple in the output
RC should be 1
RC should be low
RC should be high
RC should be neither low nor high

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math