Question is ⇒ In a CE amplifier circuit the load resistance is open circuited. The output voltage will, Options are ⇒ (A) increase, (B) decrease, (C) become zero, (D) increase or decrease, (E) , Leave your comments or Download question paper.

Question is ⇒ In a CE amplifier circuit the load resistance is open circuited. The output voltage will, Options are ⇒ (A) increase, (B) decrease, (C) become zero, (D) increase or decrease, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a CE amplifier circuit the load resistance is open circuited. The output voltage will
A.	increase [Correct Answer]
B.	decrease [Wrong Answer]
C.	become zero [Wrong Answer]
D.	increase or decrease [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The term __________ applies to troposcatter propagation
fading
Faraday rotation
SIDS
atmospheric storms

⇒ In figure, the position of voltmeter and ammeter are exchanged. It may result in damage
both the instruments
ammeter
voltmeter
neither of two

⇒ Digital technologies being used now-a-days are
DTL and EMOS
TTL, ECL, CMOS and RTL
TTL, ECL and CMOS
TTL, ECL. CMOS and DTL

⇒ A two terminal black box contains one of the elements R, L, C. The black box is connected to 220 V as supply. The current is I, when a capacitance of 0.1 F is connected in series between the source and box, the current is 2I. The elements is
resistance
inductance
capacitance of 0.5 F
not identifiable form the given data

⇒ A Hartley oscillator uses
a tapped inductor
a tapped capacitor
both (a) and (b)
neither (a) nor (b)

⇒ Consider the following statements

Impedance of Gunn diode is about tens of ohms.
Impedance of Impatt diode is a few ohms.
Impedance of Impatt diode are of the same order.
Impedance of Impatt diode is more than that of Gunn diode.

Which of the above statement are correct?
all
1 and 2 only
1, 2 and 3
1, 2 and 4

⇒ The colour code on a carbon resistor is green-blue-yellow. The tolerance is
± 5%
± 10%
± 20%
± 30%

⇒ Minimum no. of 2 I/P NAND gate required to implement the Boolean function Z = ABC, assuming that A, B and C are available is
2
3
5
6

⇒ For the network in figure, the correct loop equation for loop
-I₁ + 4I₂ + 11I₃ = 0
I₁ + 4I₂ + 11I₃ = 0
-I₁ - 4I₂ + 11I₃ = 0
I₁ - 4I₂ + 6I₃ = 0

⇒ The z-transform of a particular signal is gi
casual and stable
non-casual and stable
non-casual and unstable
casual and unstable

⇒ If the function A, B are A = R + PQ + RS B = PQRS + PQRS + PQRSA = B
A = B
no direct relation between A and B
insufficient data

⇒ A super heterodyne receiver has a IF of 465 kHz. It is tuned to a station broadcasting at 500 KHz and its oscillator is operating at 965 KHz, then the 1330 KHz frequency would be
adjacent channel frequency
image frequency
gyro frequency
maximum usable frequency

⇒ If σ standard deviation, probable error
σ
± 1.19 σ
± 0.6745 σ
± 0.4125 σ

⇒ What will be minimum conversion rate in 6 bit dual slope A/D converter uses a reference of -6v and a 1 MHz clock. It uses a fixed count of 40 (101000).
9000
9259
1000
1000

⇒ Which of the following statement about JFET is correct?
In an N-channel JFET, the channel is the narrowest under zero gate bias condition
In a JFET the gates are always forward biased
In a JFET, gate-source cut off voltage is numerically equal to the pinch off voltage
It is a voltage controlled device

⇒

Match the following:

	List I		List II
A.	V_OH(min)	1.	2.4 V
B.	V_IH(min)	2.	1.5 V
C.	V_OL(max)	3.	0.4 V
		4.	2.0 V
		5.	0.8 V

A-1, B-3, C-4
A-1, B-4, C-3
A-5, B-4, C-3
A-1, B-5, C-2

⇒ Figure shows an 8-bit LED display. A light circle means that a LED is ON (binary 1) and a dark circle means a LED is OFF (binary 0). What is the decimal equivalent of the binary number displa
100
121
144
172

⇒ The purpose of series quadrature windings in amplidyne is to
neutralize the effect of armature reaction
reduce commutation difficulties
increase the gain
increase response time

⇒ The purpose of using negative feedback in a op-amps is to
stabilize overall gain
increase output
stabilize overall gain and increase output
increase output and decrease input

⇒ The saving of power in DSB-SC modulated at 80% is
NIL
0.8
0.7576
0.5

⇒ If the intrinsic resistivity at 300°K is 0.37 ohm-m and the electron and hole mobilities at 300°K are 0.28 and 0.15 m²/volt-sec, then the intrinsic carrier concentration of Germanium is __________ .
2.92 x 10¹⁹/m³
2.92 x 10^-19/m³
1.92 x 10¹⁹/m³
3.92 x 10¹⁹/m³

⇒ In a television transmitter, the output stage is most likely to be
screen modulated class C amplifier
plate modulated class C amplifier
grid modulated class A amplifier
grid modulated class C amplifier

⇒ A rectifier voltmeter using bridge rectifier and PMMC meter is calibrated to read rms value of sine wave. A triangular wave is applied to it and it reads 6.82 V. The rms value of triangular wave is
about 6.82 V
about 7.1 V
about 6.5 V
about 10 V

⇒ In 3 phase power measurement by two wattmeter method, the reading of one wattmeter is zero. The power factor of load is
1
0.5
0
0.8

⇒ Photo electric emission can occur only if
wave length of incident radiation is equal to threshold value
wave length of incident radiation is less than threshold value
frequency of incident radiation is less than threshold frequency
none of the above

⇒ A BJT is said to be operating in saturation region if
both junctions are reverse biased
both junctions are forward biased
base emitter junction is forward biased and base collector junction is reverse biased
base collector junction is forward biased and base emitter junction is reverse biased

⇒ The slew rate of an ideal op-amp is
very slow
slow
fast
infinitely fast

⇒ The Thevenin equivalent circuit to the left of AB has R_{eq2 Ω
4 Ω
1 Ω
3 Ω}

⇒ An RC impedance function has a constant value at s = 0. The last element in the first cauer synthesis
will be a capacitor
may be R or C
will be R
will depend on the behaviour of function at s = ∞

⇒ With a JK master-slave flip-flop the master is clocked when the clock is __________ , and the slave is triggered when the clock is __________ .
low, low
high, low
low, high
high, high