Question is ⇒ In a CD, the depth and width of each pit is, Options are ⇒ (A) 0.5 μm each, (B) 0.5 μm and 1 mm respectively, (C) 1 μm and 0.5 mm respectively, (D) 1 μm each, (E) , Leave your comments or Download question paper.

Question is ⇒ In a CD, the depth and width of each pit is, Options are ⇒ (A) 0.5 μm each, (B) 0.5 μm and 1 mm respectively, (C) 1 μm and 0.5 mm respectively, (D) 1 μm each, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a CD, the depth and width of each pit is
A.	0.5 μm each [Wrong Answer]
B.	0.5 μm and 1 mm respectively [Wrong Answer]
C.	1 μm and 0.5 mm respectively [Correct Answer]
D.	1 μm each [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Assertion (A): In an R-L circuit having high inductance, the rise of current is very slow.

Reason (R): The time constant of R-L circuit is L/R.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ For TV broadcast, picture signal is modulated in
SSB
VSB
FM
AM

⇒ Pagemaker is an application software for DTP.
TRUE
FALSE

⇒ A FET is a __________ controlled device whereas a bipolar transistor is a __________ controlled device.
gate, drain
drain, gate
current, voltage
voltage, current

⇒

Assertion (A): In C it is possible for functions to call themselves.

Reason (R): C makes use of 'Pointers'.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ The minterm designation for ABCD is
m₈
m₁₀
m₁₄
m₁₅

⇒ A rectangular waveguide is a
rectangular conducting wire to propagate electromagnetic waves
hollow rectangular walled room carrying electromagnetic wave
hollow rectangular conducting tube through which electromagnetic waves can be propagated
tube antenna to transmit and receive electromagnetic waves

⇒ Highest resistivity of the following is
nichrome
constantan
metal
manganin

⇒ The range of RTD using platinum is about
-100° C to 700°C
-200°C to 1000°C
100°C to 1000°C
about 500°C

⇒ In ionosphere incidence angle is 60°. The maximum usable frequency f_m is equal to
2f_c
f_c
0.5 f_c
3 f_c

⇒ In the diode circuit shown in figure the diodes are ideal. The impedance seen by source is
1 k ohm
2 k ohm
0.5 k ohm
infinite

⇒ Consider the following

Maximum energy of electrons liberated photoelectrically is independent of light intensity
Maximum energy of electrons liberated photoelectrically varies nonlinearly with frequency of incident light.

(1) is true and (2) is false
(1) and (2) both are true
(1) is false and (2) is true
(1) and (2) both are false

⇒ The code used to reduce the error due to ambiguity in reading of a binary optical encoder is
Octal code
Excess-3 code
gray code
BCD code

⇒ The log magnitude for the system in the given figure is (where T =
20 log (1 + ωT)
-20 log (1 + ωT)
-10 log (1 + ω²T²)
-20 log (1 + ω²T²)

⇒ In a series RLC circuit for lower frequency power factor is ________
leading, Lagging
lagging, Leading
independent of frequency
same

⇒ A transistor with a = 0.9 and I_CBO = 10 μA is biased so that I_BQ = 90 μA. Then I_EQ will be
5.15 mA
5.2 mA
5 mA
990 mA

⇒ For a Gaussian process, auto-correlation sequence also implies that
statistical independence
statistical dependence
ergodic process
all

⇒ Bandwidth for practical PCM system is (where n is no. of channels, N length of PCM codes)
2n N f_m Hz
4n f_m Hz
2n f_m
(N + 1)f_m

⇒ Which of the following characteristic are necessary for a sequential circuit?

It must have 6 gates
It must have feedback
Its output should depend on past value

Which of the above statements are correct?
1, 2, 3
1, 2
2, 3
1, 3

⇒ The purpose of series quadrature windings in amplidyne is to
neutralize the effect of armature reaction
reduce commutation difficulties
increase the gain
increase response time

⇒ A moving coil meter has a shunt of 0.02 Ω resistance. If coil resistance is 1000 Ω and a potential difference of 500 mV is required across it to cause full scale deflection, the current through shunt is
2.5 A
25 A
0.25 A
0.025 A

⇒ An ideal op-amp requires
zero input offset voltage
low input offset voltage
high input offset voltage
infinite input offset voltage

⇒ The thermionic emission current is given by
Fermi-Dirac distribution
Maxwell's equation
Richardson Dushman equation
Langmuir Child law

⇒ 3N 200 is a
semi-conductor diode
P-N-P transistor
dual gate MOSFET
UJT

⇒ BFO stands for
Beat Frequency Oscillator
Broad Frequency Oscillator
Blocking Frequency Oscillator
Ballistic Frequency Oscillator

⇒ The open wired circuit in the given figure works
EX - NOR gate
AND gate
XOR gate
NOR gate

⇒ As compared to AM, FM requires
narrow channel
same channel
2 to 3 times as large channel
7 to 15 times as large channel

⇒ Given figure is the voltage transfer characteristi
an N MOS inverter with enhanced mode transistor as load
an N MOS inverter with depletion mode transistor as load
a CMOS inverter
BJT inverter

⇒ In a voltage regulated power supply the zener operates in the breakdown region when (V_in is input voltage and V_z is zener breakdown voltage)
V_in < V_z
V_in > V_z
V_in = V_z
both (a) or (b)

⇒

Assertion (A): In hybrid digital circuits the problem of logic race can occur.

Reason (R): In two level logic there is no problem of logic race.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true