Question is ⇒ In a bridge rectifier circuit the rms value of input ac voltage is 10 V. The PIV across each diode is, Options are ⇒ (A) 7.07 V, (B) 14.14 V, (C) 10 V, (D) 28.28 V, (E) , Leave your comments or Download question paper.

Question is ⇒ In a bridge rectifier circuit the rms value of input ac voltage is 10 V. The PIV across each diode is, Options are ⇒ (A) 7.07 V, (B) 14.14 V, (C) 10 V, (D) 28.28 V, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a bridge rectifier circuit the rms value of input ac voltage is 10 V. The PIV across each diode is
A.	7.07 V [Wrong Answer]
B.	14.14 V [Correct Answer]
C.	10 V [Wrong Answer]
D.	28.28 V [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of these has highly doped p and n region?
PIN diode
Tunnel diode
Schottky diode
Photodiode

⇒ A Charge Couple Device (CCD) is a
RAM
sequential accessed memory
content addressable memory
read only memory

⇒ A 10 km long line has a characteristic impedance of 400 ohms. If line length is 100 km, the characteristic impedance is
4000 Ω
400 Ω
40 Ω
4 Ω

⇒ The spectral component of noise associated with k^th frequency is given, in the limit as Δf → 0 by n_k(t) written as n_k(t) = C_k cos (2pk Δft + θ_{k1, 2 only
1, 3 only
1, 2, 3
2, 3 only}

⇒ Which of the following statement is false?
A half-wave dipole is a resonant antenna
A horizontal antenna transmits radio signal with horizontal polarization
The field strength of 200 mV/m will produced 200 μV of signal in an antenna 2 m long
All of the above

⇒ In a multicavity klystron amplifier the electron velocity of the order of
10 m/s
10³ m/s
10⁶ m/s
10¹² m/s

⇒ If poles lie in first quadrant, damping ratio is
1
more than 1
less than 1
zero

⇒ Consider the following amplifier with negative feed
-9 x 10^-3
9 x 10^-3
-11 x 10^-3
11 x 10^-3

⇒ A radio frequency choke permits an easy flow of __________ current and at the same time it offers a very impedance to __________ currents.
A.C., low frequency
A.C., high frequency
D.C., low frequency
D.C. high frequency

⇒ It is found that in a telephone system 60 subscribers initiate calls during a 30 minute interval and the total duration of all the calls is 100 minutes. The load is
2
3 erlang
3.333 erlang
0.333 erlang

⇒ A speech signal, band limited to 4kHz and peak voltage varying between + 5V and - 5V is sampled at the Nyquist rate. Each sample is quantized and represented by 8 bits. The number of quantization levels required to reduce the quantization noise by a factor of 4 would be
1024
512
256
64

⇒ The output of a Piezoelectric crystal has
low amplitude and low impedance
high amplitude and low impedance
low amplitude and high impedance
high amplitude and high impedance

⇒ Crompton potentiometer has
14 coils and a slide wire all having the same resistance
14 coils and a slide wire but the resistance of slide wire is half that of each coil
14 coils each of different resistance
14 coils out of which 7 coils have resistance which is twice that of remaining 7 coils

⇒ If A = 10 + j then log_eA is
14.14 ∠45°
200 ∠45°
2.65 + j45°
2.65 + j0.785

⇒ The SID data received is
LSB first
LSB last
1
none of these

⇒ Find the value of i_x if each resistance is of 3 Ω and each battery is of
1.1428 V
1.432 A
0.2892 A
O A

⇒ Determine the transistor capacitance of a diffused junction varicap diode of a reverse potential of 4.2 V if C(0) = 80 pf and V_T = 0.7 V
42 pf
153.03 pf
13.33 pf
Data inadequate

⇒ Which of the following is non-saturating?
TTL
CMOS
ECL
Both (a) and (b)

⇒ Which of the following terms is not applicable to Yagi-Uda array?
High gain
Folded dipole
Parasitic elements
Good bandwidth

⇒ In a D latch
a high D sets the latch and low D resets it
a low D sets the latch and high D resets it
race can occur
none of the above

⇒ In figure, S is closed at t = 0. At t = t₁, I = 1 A and di/dt = 1 A/s. Then the value of
1 H
2 H
3 H
4 H

⇒ Which one is true for writing array variable in Pascal?
The general form of an array variable is an integer or a real variable name followed by subscripts enclosed within square brackets. The subscripts are separated by commas
The general form of an array variable must be an integer name followed by subscripts enclosed within square brackets. The subscripts are separated by commas
The subscripts in array variable must be separated by dots
The subscripts must be enclosed within parenthesis

⇒ Quantization error occurs in
D/A converter
A/D converter
both D/A and A/D converter
neither D/A nor A/D converter

⇒ As compared to full wave rectifier, a half wave rectifier
has higher ripple factor
has lower ripple factor
may have higher or lower ripple factor
has same ripple factor

⇒ Which of the following is true?
A silicon wafer heavily doped boron is a p⁺ substrate
A silicon wafer lightly doped boron is a p⁺ substrate
A silicon wafer heavily doped arsenic is a p⁺ substrate
A silicon wafer lightly doped arsenic is a p⁺ substrate

⇒ The concentration of minority carriers in an extrinsic semiconductor under equilibrium is
directly proportional to the doping concentration
inversely proportional to doping concentration
directly proportional to intrinsic concentration
inversely proportional to the intrinsic concentration

⇒ In a dual converter both converters work as rectifiers.
TRUE
FALSE

⇒ The maximum counting range of a four stage counter using IC 74193 is
0 to 1023
0 to 4093
0 to 65535
0 to 131071

⇒ Which of the following microphones has maximum distortion?
Ribbon
Condenser
Crystal
Carbon

⇒

Match the following:

	List I		List II
A.	Wein bridge oscillator	1.	Low output impedance
B.	Voltage shunt feedback amplifier	2.	RF frequency range
C.	Crystal oscillator	3.	Audio frequency range
D.	Current shunt feedback amplifier	4.	High input impedance
		5.	High output impedance

A-3, B-1, C-2, D-5
A-3, B-5, C-1, D-2
A-4, B-3, C-1, D-2
A-5, B-1, C-2, D-1