Question is ⇒ In a bipolar transistor which current is largest, Options are ⇒ (A) collector current, (B) base current, (C) emitter current, (D) base current or emitter current, (E) , Leave your comments or Download question paper.

Question is ⇒ In a bipolar transistor which current is largest, Options are ⇒ (A) collector current, (B) base current, (C) emitter current, (D) base current or emitter current, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a bipolar transistor which current is largest
A.	collector current [Wrong Answer]
B.	base current [Wrong Answer]
C.	emitter current [Correct Answer]
D.	base current or emitter current [Wrong Answer]
View Answer 4 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The rms voltage measured across each of the circuit element in figure is as shown, when the circuit is excited by a sinusoidal voltage E_s, the rms value of the source voltage e_{s10 volt
2 volt
E_s
5 volt}

⇒ The frequency response of an ideal tuned amplifier should be as represented in figur
A
B
C
D

⇒ In a reverse biased p-n junction, the reverse bias is 4V. The junction capacitance is about
0.1 F
4 μF
10 nF
20 pF

⇒

Assertion (A): The conductivity of p type semiconductor is higher than that of intrinsic semiconductor.

Reason (R): The addition of donor impurity creates additional energy levels below conduction band.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ Filter method and phasing method are the methods for generating
SSB signal
vestigial side band signal
both SSB and vestigial sideband signals
none of the above

⇒ When determining Thevenin's resistance of a circuit
all sources must be open circuited
all sources must be short circuited
all voltages sources must be open circuited and all current sources must be short circuited
all sources must be replaced by their internal resistances

⇒ Whereas resonant antenna is bidirectional, non-resonant antenna is unidirectional.
TRUE
FALSE

⇒ If both the emitter base and the collector base junctions of a bipolar transistor are forward biased, the transistor is in the
active region
saturated region
cut off region
inverse mode

⇒ For a high pass filter, β = p in attenuation band.
TRUE
FALSE

⇒ Choose the correct option
tree does not contain any loop
tree contain all the nodes
tree is always open
all

⇒ Oscillations are obtained from a reflex klystron only for combinations of anode voltage and repeller voltage that give a favourable transit time.
TRUE
FALSE

⇒ Two CE stages are coupled through a capacitor. To calculate the quiescent base current of the two transistors, the capacitor is treated as
open circuit
short circuit
neither (a) nor (b)
either (a) or (b)

⇒

Assertion (A): The regular or irregular stacking of atoms has importanteffect on properties of materials.

Reason (R): The arrangement of atoms in a given material can be studied using X-rays.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ The most commonly used devices for differencing and amplification, in control systems, are
BJT amplifiers
FET amplifiers
operational amplifiers
either (a) or (b)

⇒ A system is said to be static system, when present output depend upon
present I/P
presrent and past
present and future
past and future

⇒ Consider the following statements:

Taking 2's complement is equivalent to sign change.
In the 2's complement representation the most significant bit (MSB) is zero for a positive number.
In a 4 bit binary representation of a binary number A, A + 1's complement of A = 2⁴.

Which of the above statements are correct?
1 and 2 only
1 and 3 only
2 and 3 only
1, 2 and 3

⇒ 100101.1011₂ = __________ .
115.22₈
115.54₈
215.54₈
100.01₈

⇒ For low impedance SAW filter the most suitable material for substrate of SAW filter is
PZT ceramics
ZnO
Lithium titanate
Lithium neobate

⇒ Laplace transform method enables us to find the response in
steady state
transient state
both steady and transient state
transient state provided forcing functions do not exist

⇒ In an AM transmitter after the modulation stage, class C amplifier
can be used
cannot be used
may be used, but it has no use
can't be determine to use

⇒ Mesh analysis is applicable __________ only.
planar network
non planar network
a circuit which contains only current sources
none

⇒ The characteristic impedance of a twin wire feeder used for TV signals is about
1000 ohm
500 ohm
300 ohm
100 ohm

⇒ (100101)₂ is
(37)₁₀
(69)₁₀
(41)₁₀
(5)₁₀

⇒ In figure the diode is ideal (zero cut in voltage zero forward resistance). Then the current through diod
0
0.166666666666667
0.0416666666666667
none of the above

⇒ Dynamic memory cells are constructed using
FETs
MOSFETs
Transistors
Flip flops

⇒ A parity check usually can detect
one-bit error
double-bit error
three-bit error
any-bit error

⇒ The Shannon-Hartley law
refers to noise
defines bandwidth
describes signalling rate
refers to distortion

⇒ Maxwell's curl equation for the static electric field E can be expressed as
Δ x E = 0
Δ x E = constant
Δ - E = constant
Δ . E = 0

⇒ The counter shown in the given figure
Synchronous
Johnson
Ring
None of the above

⇒ The current through a 1 mH inductance is i(t) = 2.56 x 10^-2 - 4 x 10³ t for 2 ≤ t ≤ 20 μ sec. The voltage across the inductor is
4
8
0
8 x 10³