Question is ⇒ In a bipolar transistor, the emitter base junction has, Options are ⇒ (A) forward bias, (B) reverse bias, (C) zero bias, (D) zero or reverse bias, (E) , Leave your comments or Download question paper.

Question is ⇒ In a bipolar transistor, the emitter base junction has, Options are ⇒ (A) forward bias, (B) reverse bias, (C) zero bias, (D) zero or reverse bias, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a bipolar transistor, the emitter base junction has
A.	forward bias [Correct Answer]
B.	reverse bias [Wrong Answer]
C.	zero bias [Wrong Answer]
D.	zero or reverse bias [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The concentration of minority carriers in a semiconductor depends mainly on
the extent of doping
temperature
the applied bias
none of the above

⇒ In the figure circuit, V₁ = 40 V. When R is 10 Ω. When R is zero, the value of V₂ wil
40 V
30 V
20 V
10 V

⇒

Assertion (A): Copper is a good conductor of electricity.

Reason (R): Copper has a face centred cubic lattice.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ In directional coupler of the given figure, the terms |S₁₄| and |S₂₃| of scattering matrix are ne
1 each
0.5 each
0.1 each
1 and 0.5 respectively

⇒ Thevenin's theorem is used to find current in a branch of a network. It is now desired to find current in another branch of the network
the same Thevenin's circuit can be used
the same Thevenin's circuit with some modification can be used
it is necessary to find new Thevenin's circuit
either (b) or (c)

⇒ Which of the following transducers requires a high input impedance preamplifier for proper measurements?
Thermocouple
Piezoelectric
Thermistor
L.V.D.T

⇒ Find 'X' in the circuit be
∏(0, 1, 2, 3, 4, 5, 6, 7, 8, 9, 10, 11, 12, 13, 15)
0
Σ(14)
1

⇒ For a 1 cm x 2 cm air filled rectangular waveguide the maximum frequency should be less than about
1000 MHz
5000 MHz
14000 MHz
140000 MHz

⇒

Assertion (A): A rectifier with inductor filter is more efficient for high load current.

Reason (R): In rectifier with inductor filter we can use a larger choke to reduce ripple, larger choke will have higher dc resistance which will result in lower dc output voltage for higher load current.

Both A and R are individually true and R is the correct explanation of A
Both A and R are individually true but R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ If the energy gap of a semiconductor is 1.1 eV, then it would be
opaque to visible light
transparent to visible light
transparent to ultraviolet radiation
transparent to infrared radiation

⇒ For a second order system the damping factor is varied from 0 to 1. The locus of poles is
a straight line on imaginary axis
a straight line on real axis
a semi circle
a circle

⇒ For air filled circular waveguides
the attenuation due to imperfect conducting walls is negligible
the attenuation due to imperfect dielectric is negligible
both the attenuation i.e. due to imperfect conducting walls and due to imperfect dielectric are significant
the total attenuation is almost zero

⇒ ROC of sequence x[n] = δ[n] is
Not exist
z = 0
Entire Plane
Entire Plane expect z = 0, z = ∞

⇒ In a pure sample of silicon
the number of holes and free electrons is always equal
the number of free electrons is more than the number of holes
the number of free electrons and holes is equal at low temperature
the number of free electrons is less than number of holes

⇒ The disadvantage of FET over BJT is
poor high frequency performance
low power-handling ability
low values of voltage gain
all of the above

⇒ A function table is required in very large numbers the memory most switched for this purpose would be
ROM
PROM
EPROM
EAROM

⇒ Virtual height of an ionospheric layer is always greater than its actual height.
TRUE
FALSE

⇒ A two terminal black box contains one of the elements R, L, C. The black box is connected to 220 V as supply. The current is I, when a capacitance of 0.1 F is connected in series between the source and box, the current is 2I. The elements is
resistance
inductance
capacitance of 0.5 F
not identifiable form the given data

⇒ The noise margin of a TTL gate is about
0.2 V
0.4 V
0.6 V
0.8 V

⇒ In colour TV receiver, varactor diode is used for
detection
rectification
tuning
both (a) and (b)

⇒ Operating point signifies that
zero signal I_C and V_BE
zero signal I_C and V_CE
zero signal I_B and V_CE
zero signal I_C, V_CE

⇒ The ripple factor from a capacitor filter __________ as the load resistance __________ .
decreases, decreases
decreases, increases
increases, decreases
increases, increases

⇒ 4 bit ripple counter and 4 bit synchronous counter are made using flip-flop having a propagation delay of 10 ns each. If the worst case delay in the ripple counter and the synchronous counter be R and S respectively, then
R = 10 ns, S = 40 ns
R = 40 ns, S = 10 ns
R = 10 ns, S = 30 ns
R = 30 ns, S = 10 ns

⇒ In a TV receiver there is no raster, no picture and no sound. The most likely defective stage is
power supply unit
video output circuit
horizontal oscillator
balun

⇒ While keeping the down-link frequency constant, the diameter of a satellite antenna is reduced by half. To offer the same EIRP over the increased coverage area, the RF output power has to be increases by a factor of
2
4
8
16

⇒ 1 GHz is equal to
10⁶ Hz
10⁸ Hz
10⁹ Hz
10¹⁰ Hz

⇒ When a line short circuited at far end, the minimum voltage occurs at
far end
source end
midway between source and far end
none of the above

⇒ When a vector has positive divergence, it indicates that the vector quantity has at that point and if the divergence is negative, it indicates __________ .
source, sink
sink, source
positive value, negative value
negative value, positive value

⇒ Is the interrupt-enable flag?
Low
High
Never
None

⇒ When a constant voltage source and constant current source are in series, the current source is ineffective.
TRUE
FALSE