Question is ⇒ In a bipolar junction transistor adc = 0.98, ICO= 2 μA and 1B = 15 μA. The collector current IC is, Options are ⇒ (A) 635 mA, (B) 735 mA, (C) 835 mA, (D) 935 mA, (E) , Leave your comments or Download question paper.

Question is ⇒ In a bipolar junction transistor adc = 0.98, ICO= 2 μA and 1B = 15 μA. The collector current IC is, Options are ⇒ (A) 635 mA, (B) 735 mA, (C) 835 mA, (D) 935 mA, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a bipolar junction transistor a_dc = 0.98, I_CO= 2 μA and 1_B = 15 μA. The collector current I_C is
A.	635 mA [Wrong Answer]
B.	735 mA [Correct Answer]
C.	835 mA [Wrong Answer]
D.	935 mA [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a lag network the input frequency is 100 f_c where f_c is critical frequency. The voltage gain is
0 dB
-20 dB
-40 dB
-60 dB

⇒ A periodic voltage has following value for equal time intervals changing suddenly from one value to next... 0, 5, 10, 20, 50, 60, 50, 20, 10, 5, 0, -5, -10 etc. Then rms value of the waveform is
31 V
32 V
insufficient data
none of these

⇒ Consider the following statements

Fading of signals is generally greatest near radio horizon.
Fading of signals is generally greatest in shadow zone.
Fading is small when a good optical path is present.

Which of the above statements are correct?
1, 2 and 3
1 and 2 only
1 and 3 only
2 and 3 only

⇒ The digit F in hexadecimal system is equivalent to number __________ in decimal system.
16
15
17
8

⇒ The number of possible colours with a 4 line digital input monitor are
4
16
64
2

⇒ Which of the following can be used as a tachogenerator in control systems?
Microsyn
DC servomotor
AC servomotor
Magnetic amplifier

⇒ In CE amplifier circuit, voltage gain is directly proportional to
β
collector supply voltage
base resistance
none of the above

⇒ The frequency at which the piezoelectric effect occurs is primarily determined by
the weight of the crystal
thickness of the crystal
length of the crystal
gain structure of the crystal

⇒ In an n type semiconductor
number of free electrons and holes are equal
number of free electrons is much greater than the number of holes
number of free electrons may be equal or less than the number of holes
number of holes is greater than the number of free electrons

⇒ In 8085 microprocessor, what is the length of temporary register?
6 bits
8 bits
12 bits
16 bits

⇒ A generator with an internal resistance of 600 Ω drives an amplifier whose input resistance is 400 Ω. The generator's open circuit voltages is 1 mV; the amplifier develops 100mV across an 8kΩ load. The input voltage to the amplifier is
0.1 m V
0.4 m V
1 m V
4 m V

⇒ A permanent magnet moving coil meter can be used as
ac only
dc only
both ac and dc
low frequency ac and dc

⇒

Assertion (A): In KVL equations involving mutually coupled circuits the sign of M terms can be positive or negative.

Reason (R): Dot convention helps in determining sign of M terms in KVL equations.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Ohm's law is valid for
dc voltage and current
ac voltage and current
all voltages and current
dc and ac voltages and currents

⇒ Three point tracking is achieved with
double conversion
padder capacitor
double spotting
variable selectivity

⇒ Radiation resistance of an antenna is a
dc resistance
ac resistance
either (a) or (b)
none of the above

⇒ In amplitude modulation
the amplitude of carrier varies in accordance with the amplitude of the modulating signal
the modulating frequency lies in the audio range
the amplitude of the carrier remains constant
the amplitude of the carrier varies in accordance with the frequency of the modulating signal

⇒

Assertion (A): Most of actual systems are non-linear.

Reason (R): Non linearity may be due to saturation, dead zone, square law etc.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒

Assertion (A): The unit of telephone traffic measurement is erlang.

Reason (R): International circuits for communication are fitted with echo suppressors.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Emitter follower is in which of following configuration.
common Base
common Emitter
common collector
common Base or common Emitter

⇒ In a discharging R-L circuit voltage across the resistor exhibits
a linear rise
a linear decay
an exponential growth function
an exponential decay function

⇒ For FM, which of the following statement is not true?
The bandwidth increases as modulation index is increased
The total power remains constant with respect to modulation index
The carrier never becomes zero
All of the above

⇒ In the circuit of figure the current through 3 Ω resistance at t = &infin
0.166666666666667
2.5 A
3.1 A
0

⇒ In a P type silicon sample, the hole concentration is 2.25 x 10¹⁵ / cm³. If the intrinsic carrier concentration is 1.5 x 10¹⁰/ cm³ the electron concentration is
zero
10¹⁰/cm³
10⁵/cm³
1.5 x 10²⁵/cm³

⇒ If the peak transmitted power in a radar is increased by a factor 81, the maximum range is increased by a factor of
3
9
27
81

⇒ Negative feedback in amplifier
reduces gain
increases frequency and phase distortion
reduces bandwidth
increases noise

⇒ Surface impedance at high frequencies is a consideration for
good conductors
semiconductors
dielectrics
ferrites

⇒ RF amplifiers are used in radio receivers for
improved image frequency rejection
improved rejection of adjacent unwanted signals
prevention of re-radiation of the local oscillator through the antenna of the receiver
all of the above

⇒ For F₂ layer the critical frequency is about
500 MHz
100 MHz
25 MHz
10 MHz

⇒ For the circuit shown in the following figure I₀-I₃ are inputs to the 4:1 multiplexer R(MSB) and S are control
PQ + PQ S + Q R S
P Q + PQ R + P Q S
P Q R + P QR + PQRS + Q R S
PQ R + PQR S + P Q R S + Q R S