Question is ⇒ In a 7 segment LED display, the minimum number of segments is activated when the input decimal number is, Options are ⇒ (A) 0, (B) 1, (C) 2, (D) 3, (E) , Leave your comments or Download question paper.

Question is ⇒ In a 7 segment LED display, the minimum number of segments is activated when the input decimal number is, Options are ⇒ (A) 0, (B) 1, (C) 2, (D) 3, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a 7 segment LED display, the minimum number of segments is activated when the input decimal number is
A.	0 [Wrong Answer]
B.	1 [Correct Answer]
C.	2 [Wrong Answer]
D.	3 [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ If transmitted power is 75 kW, the field strength at 30 km distance will be about
10 V/m
1 V/m
50 mV/m
2 mV/m

⇒ As access time is decreased, the cost of memory
remains the same
increases
decreases
may increase or decrease

⇒ Programmable logic array uses
RAM matrices
ROMs matrices
PROM matrices
Silo memory

⇒ The oscillator frequency is set for
best picture
max. sound
min. sound
sound in picture

⇒ A sequence x(n) with the z transform X(z) = z⁴ + z² - 2z + 2 - 3z - 4 is applied as an input to a linear, time invariant system with the impulse response h(n) = 2δ(n - 3) wh
-6
zero
2
-4

⇒ A ring counter with 5 flip flops will have
5 states
10 states
32 states
infinite states

⇒ Which one of the following is digital?
Pulse code modulation
Pulse width modulation
Pulse frequency modulation
Pulse position modulation

⇒

Assertion (A): In standing wave pattern, the nodes and anti nodes are separated by half wave-length

Reason (R): When line is terminated in resistance R_L, the standing wave ratio is SWR = Z₀/R_L or R_L/Z₀

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The numerical value of directive gain may lie between
1 and + 1
0 and 1
0 and ∞
1 and ∞

⇒ In the given figure shows a 3 bit shift register using TTL flip flops. Initially all the flip flops are set to 0 state. After 8 clock pul
A = 1, B = 1, C = 1
A = 1, B = 1, C = 0
A = 0, B = 1, C = 1
A = 0, B = 0, C = 1

⇒ If sound intensity is 8 W/m², the dB level of this sound is about
5 dB
50 dB
129 dB
1290 dB

⇒ A NOR gate is a combination of
OR gate and AND gate
AND gate and NOT gate
OR gate and NOT gate
two NOT gates

⇒ A single phase full bridge inverter for R-L loads needs
4 thyristors
4 thyristors and 4 diodes
4 thyristors and 2 diodes
8 thyristors

⇒ For frequency up to 1650 kHz, the transmitting antenna is used a
parabolic dish
vertical antenna
yagi antenna
turnstile antenna

⇒ The 8085 instruction LDA FFA is an example of
Direct addressing
Register addressing
Immediate addressing
Register indirect addressing

⇒ The directive gain of λ/2 resonant wire is 1.64.
TRUE
FALSE

⇒ The series element of a band stop filter is
capacitive
inductive
parallel combination of L and C
series combination of L and C

⇒ In the words Kb or Mb used describing memory capacity, the letter b denotes
bits
bytes
bits or bytes depending on type of memory
bubbles

⇒ A Charge Couple Device (CCD) is a
RAM
sequential accessed memory
content addressable memory
read only memory

⇒ A dc series motor is coupled to a load whose torque is proportional to speed. It is fed by a single phase ac supply through a full converter. When speed is 500 rpm, firing angle is 45°. It is desired to raise the speed. It will be necessary to
decrease the firing angle
increase the firing angle
either decrease or increase the firing angle depending on the required speed
decrease the load torque

⇒ Public address systems generally use electret microphones.
TRUE
FALSE

⇒ Space communication links are being increasingly moved into Ka-band (200-30 GHz) because it
offers a much wider available bandwidth
does not suffer from atmospheric at tenuation
permits the use of smaller antenna
does not suffer from rain attenuation

⇒ In the circuit of figure, the source supplies, 2.25 mA. The value of R mus
5 Ω
3 Ω
1.5 Ω
0.5 Ω

⇒ The minimal function that can detect a "divisible by 3" 8421 BCD code digit (representation D₈D₄D₂D₁) is given by
D₈D₁ + D₄D₂ + D₈D₂D₁
D₈D₁ + D₄D₂ D₁ + D₄D₂D₁ + D₈D₄D₂D₁
D₄D₁ + D₄D₂ + D₈D₄ D₂D₁
D₄D₂D₁ + D₄D₂D₁ + D₈D₄D₂D₁

⇒ For satellite transmission, analog signals may be converted into digital form with the help of
modem
transponder
codec
compandor

⇒

Assertion (A): A transistor requires a continuous base signal for conduction but a thyristor requires a gate pulse.

Reason (R): Transistor find widespread application in power electronic circuits.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The scale of hot wire ammeter is
linear
non-linear
cramped
absolute linear

⇒ When thyristors are connected in series and parallel, it may be necessary to have :
current derating
voltage derating
both current and voltage derating
none of the above

⇒ Consider the following statement in B
200, 250, 150 respectively
150, 200, 250 respectively
250, 200, 150 respectively
200, 150, 250 respectively

⇒ A complex wave is 5 + 5 sin ωt. Its rms value is
7.07 V
5 V
10 V
6.12 V