Question is ⇒ In a 4-ary FSK, the frequencies are separated by fs. Then they are, Options are ⇒ (A) in phase, (B) in phase opposition, (C) orthogonal, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ In a 4-ary FSK, the frequencies are separated by fs. Then they are, Options are ⇒ (A) in phase, (B) in phase opposition, (C) orthogonal, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a 4-ary FSK, the frequencies are separated by f_s. Then they are
A.	in phase [Wrong Answer]
B.	in phase opposition [Wrong Answer]
C.	orthogonal [Correct Answer]
D.	none of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Assertion (A): A resistor is a passive load and a transistor is an active load

Reason (R): Op-amp is mostly used in feedback mode

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ In a class C operation V_CC = 40 V and V_CE(sat) = 0.4 V. The efficiency is
0.9
0.495
0.01
0.005

⇒ The material used for the magnet of moving coil cone type loudspeaker is
steel alloy
soft iron
hard steel
Alnico

⇒ IF V_CC = 15 V, V_CEQ = 5 V and I_CQ = 50 mA, the efficiency in class A operation is
1
0.5
0.25
0.167

⇒ In static RAM 6264 the number of address inputs are
10
12
13
15

⇒

Assertion (A): PIN diode can be used as attenuator and limiter.

Reason (R): PIN diode has a thin intrinsic layer.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Which materials find application in MASER?
Diamagnetic
Paramagnetic
Ferromagnetic
Ferrimagnetic

⇒ A Si sample is doped with a fixed number of group N impurities. The electron density n is measured from 4 K to 1200 k for the sample. Which one of the following is correct?
n remains constant over the temperature range
n increases monotonicaliy with increasing temp
n increases first remains constant over a range and again increases with increasing temperature
n increases show a peak and then decrease with temperature

⇒ If sound wave has an intensity of 10 Pa. The dB level is about
1.139 dB
11.39 dB
113.9 dB
1139 dB

⇒ PAM stands for
Pulse Analogue Modulation
Phase Analogue Modulation
Pulse Amplitude Modulation
Phase Amplitude Modulation

⇒ As temperature increases, the temperature coefficient of a metal
decreases
increases
remains unchanged
any of the above

⇒ A cascade amplifier stage is equivalent to
common emitter stage followed by a common base stage
common base stage followed by an emitter follower
an emitter follower stage followed by a common base stage
a common base stage followed by a common emitter stage

⇒ Slotted line can be used for measurement of high frequencies
TRUE
FALSE

⇒ The transient currents are due to
resistance of the circuit
impedance of the circuit
voltage applied to the circuit
changes in stored energy in inductors and capacitors

⇒ If the target area is small compared to wavelength of radar the situation is called
resonance region
Rayleigh region
optical region
binomial region

⇒ In body centred cubic structure, comers and centre of the cube are occupied by identical atoms.
TRUE
FALSE

⇒ Zoning is used with a dielectric antenna in order to
permit pin-point focusing
reduce the bulk of the lens
increase the bandwidth of the lens
correct the curvature of the wavefront from a horn that is too short

⇒ If a RAM has 34 bits in its MAR and 16 bits in its MDR, then its capacity will be
32 GB
16 GB
32 MB
16 MB

⇒ When a coil consisting of single turn rotates at a uniform speed in a magnetic field, the induced e.m.f. is
changing
reversing
steady
alternating

⇒ An op-amp is fed from a signal source through resistance R₁. If it is to work as sign changer, the feedback resistance R_f should be
equal to R₁
twice R₁
half R₁
either (b) or (c)

⇒ A negative feedback can be of
2 types
3 types
4 types
only 1 type

⇒ A D.C. amplifier amplify
D.C. only
A.C. only
both A.C. and D.C.
none of the above.

⇒ To prevent overloading in the last IF amplifier one should use
variable sensitivity
squelch
double conversion
variable selectivity

⇒ The carriers of n channel JFET are
free electrons and holes
holes
free electrons or holes
free electrons

⇒ Nyquist stability criterion is based on a theorem from the theory of complex variables.
TRUE
FALSE

⇒ A 300 MHz plane EM wave is propagating in free space. The wave is incident normally on an infinite copper slap. The antenuation constant for the wave is (σ_copper = 5.8 x 10⁷ mho/ m)
262 x 10³
254 x 10³
352 x 10³
354 x 10³

⇒

Assertion (A): The resolution of a DAC depends on the number of bits

Reason (R): Low resolution leads to fine control.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ Skin effect is more pronounced at high frequencies.
TRUE
FALSE

⇒

Match the following:

	List I (Symbol in Java comparison operator)		List II (Meaning)
A.	= =	1.	Greater than or equal to
B.	! =	2.	Equal
C.	> =	3.	Not equal

A-1, B-2, C-3
A-3, B-2, C-1
A-1, B-3, C-2
A-2, B-3, C-1

⇒ Laplacian of a scalar function v is
gradient of v
divergence of v
gradient of the gradient of v
divergence of the gradient of v