Question is ⇒ In a 100 turn coil, if the flux through each turn is (t3 - 2t)mWb, the magnitude of the induced emf in the coil at a time of 4 sec is, Options are ⇒ (A) 46 mV, (B) 56 mV, (C) 4.6 V, (D) 5.6 V, (E) , Leave your comments or Download question paper.

Question is ⇒ In a 100 turn coil, if the flux through each turn is (t3 - 2t)mWb, the magnitude of the induced emf in the coil at a time of 4 sec is, Options are ⇒ (A) 46 mV, (B) 56 mV, (C) 4.6 V, (D) 5.6 V, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a 100 turn coil, if the flux through each turn is (t³ - 2t)mW_b, the magnitude of the induced emf in the coil at a time of 4 sec is
A.	46 mV [Wrong Answer]
B.	56 mV [Wrong Answer]
C.	4.6 V [Correct Answer]
D.	5.6 V [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In waveguide Degenerate modes are
two mode having same cut off frequency
two mode having same power
two mode having same phase velocity
it is a hypothetical mode

⇒ The units for transconductance are
ohms
amperes
volts
siemens

⇒ A FET has
very high input resistance
very low input resistance
high connection emitter junction
forward biased PN junction

⇒ The logic function f(A B, C) = Σm(0, 2, 4, 5, 6) represente
i
i, ii
i, iii
i, ii, iii

⇒ In steady state condition inductor behave as
open circuit
short circuit
current source
voltage source

⇒ In a dual converter operated in circulating current mode, the circulating current flows
when load current is zero
when load current is non-zero
even when load current is zero
none of the above

⇒ In a flip flop which input determines the state to which output will transistion?
Control input
Clock input
Both control and clock input
Either control or clock input

⇒ In 8085 microprocessor, what is the length of temporary register?
6 bits
8 bits
12 bits
16 bits

⇒ In the circuit shown in the figure, the approximate voltage at the transist
base and emitter respectively are -8 V and -7.3 V
base and collector respectively are -8 V and -5 V
Collector and emitter respectively are -5 V and -7.3
base, emitter and collector respectively are -8 V, 7.3 V and -5 V

⇒ The percentage limiting error in an instrument reading 8.3 V and having guaranteed accuracy of 1% of the full scale reading and range of 0-150 V is
0.0181
0.00181
0.181
0.000018

⇒ (100101)₂ is
(37)₁₀
(69)₁₀
(41)₁₀
(5)₁₀

⇒ If load impedance Z_L >> Z₀, then
Z₀ = Z_L (VSWR)
Z_L = Z₀ (VSWR)
Z_L = Z₀ (VSWR - 1)
Z_L = Z₀ VSWR

⇒ In CE amplifier the base current is very high.
TRUE
FALSE

⇒ The output voltage of a charger is
less than battery voltage
same as battery voltage
more than battery voltage
same or more than battery voltage

⇒ The attenuation characteristics of a loaded line is similar to that of
low pass filter
high pass filter
band pass filter
band stop filter

⇒

Assertion (A): For large signal variations an amplifier circuit has to be analysed graphically

Reason (R): The output characteristics of a transistor is nonlinear.

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ The PC contains 0450 H and SP contains 08D 6 H. What will be content of P and SP following a CALL to subroutine at location 02 AFH?
0453 H, 08 D 8 H
0453 H, 08 D 4 H
02 AFH, 08 D 8 H
02 AFH, 08 D 4 H

⇒ In which of the following frequency bands are the standard AM radio broadcast stations?
MF
HF
VHF
UHF

⇒ The relative permeability of an iron specimen is 400 when B = 0.2 T. If B = 0.4 T, μ_r will be
400
less than 400
more than 400
more or less than 400

⇒ If VSWR is infinite, the transmission line is terminated in
short circuit
complex impedance
open circuit
either (a) or (c)

⇒

Assertion (A): RF tuner is called front end of TV receiver

Reason (R): RF tuner receives the TV signal and selects the required channel.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In control systems the output of sensor usually, is
analog electrical signal
digital electrical signal
mechanical signal
analog or digital electrical signal

⇒ A periodic voltage has following values for equal time intervals changing suddenly from one value to next, 0, 5, 10, 20, 50, 60, 50, 20, 10, 5, 0, -5, -10 etc. then rms value of the waveform is
31 volt
32 volt
insufficient data
none

⇒ Study the circuit of figure and examine the following statem
1, 2 and 3
1 and 2
1 and 3
2 and 3

⇒ If input ac is 10 V_rms, then maximum voltage that will appear across the diode of a half wave rectifier with a capacitor I/P filter will be
10 V
14 V
20 V
28 V

⇒ Magnetic amplifier is used for
voltage amplification
power amplification
current amplification
frequency amplification

⇒ A half adder adds
2 bits
3 bits
4 bits
2 or 3 bits

⇒ How many cascaded stage of CE amplifiers will result in polarity inversion of the input signal?
Two
Three
Four
None

⇒ In all insulators the bonding is covalent.
TRUE
FALSE

⇒ Consider the differential amplifier shown in figure. (Assume β is very hi
2 mA
1 mA
0.5 mA
3 mA