Question is ⇒ In a 100% amplitude modulated signal, the power in the upper sideband when carrier power is to be 100 W and modulation system SSBSC, is, Options are ⇒ (A) 100 W, (B) 66 W, (C) 50 W, (D) 25 W, (E) , Leave your comments or Download question paper.

Question is ⇒ In a 100% amplitude modulated signal, the power in the upper sideband when carrier power is to be 100 W and modulation system SSBSC, is, Options are ⇒ (A) 100 W, (B) 66 W, (C) 50 W, (D) 25 W, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a 100% amplitude modulated signal, the power in the upper sideband when carrier power is to be 100 W and modulation system SSBSC, is
A.	100 W [Wrong Answer]
B.	66 W [Wrong Answer]
C.	50 W [Wrong Answer]
D.	25 W [Correct Answer]
View Answer 1 -2 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ If A = 7 ∠15, A² is
49 ∠225°
49 ∠30°
49 ∠15°
49 ∠7.5°

⇒ If ROC of x[n] is R₁ then ROC of aⁿ x[n] is
R₁a
R₁/a
a/R₁
R₁ + a

⇒ While selecting a memory chip the feature which should be examined is
capacity
ac characteristics
dc characteristics
all of the above

⇒ The logic operations of the two circuits given below
complementary
identical
entirely different
none of these

⇒ In a series R-L circuit when excited by a 1 volt battery the current is 1 - e^-t. If it is excited by a source 2 sin t, the current will be
2 sin (t - 45°) + e^-t
2 sin (t + 45°) + e^-t
sin (t - 45°) + e^-t
sin (t + 45°) + e^-t

⇒ In an AM transmitter after the modulation stage, class C amplifier
can be used
cannot be used
may be used, but it has no use
can't be determine to use

⇒ Following state diagram shows clocked sequential circ
6
7
5
4

⇒ The open loop gain of an amplifier is 50 but is likely to change by 20%. If negative feedback with β = 0.1 is used, the change in gain will be about
0.2
0.1
0.04
0.0005

⇒ The chip 8257 is a
programmable interrupt controller
programmable DMA controller
programmable peripheral interface
none of the above

⇒ Two resistances R₁ = 18.7 Ω. and R₂ = 3.624 Ω in series. The total resistance to the appropriate number of significant figures is
22.324 Ω
22.32 Ω
22.3 Ω
22 Ω

⇒ A magnetron has a cylindrical cathode surrounded by an anode structure having cavities opening into interaction space by means of slots
TRUE
FALSE

⇒

Assertion (A): At room temperature the fermi level in p type semiconductor lies nearer to the valence band and in n type semiconductor it lies nearer to the conduction band.

Reason (R): At room temperature, the p type semiconductor is rich in holes and n type semiconductor is rich in electrons.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ Radiation intensity in a given direction is the
energy radiated per square metre
power radiated per square metre
power radiated per unit solid angle in that direction
none of the above

⇒ In the circuit shown, in switch S is open for a long time and is closed at t = 0. The current i(t) for t ≥ 0^{+i(t) = 0.5 - 0.125e^-1000t A
i(t) = 1.5 - 0.125e^-1000t A
i(t) = 0.5 - 0.5e^-1000t A
i(t) = 0.375e^-1000t A}

⇒ Choose the correct option

Mesh is the smallest loop of circuit
Loop is smallest path of circuit
Loop does not contain any mesh
Loop may have one or more than one mesh

1, 2, 3, 4
3, 4, 2
1, 4
3, 2

⇒ A plane electromagnetic wave travels in dielectric medium of relative permittivity 9. Relative to free space, the velocity of propagation in the dielectric is
increased by a factor of 9
increased by a factor of 3
unchanged
reduced by a factor of 1/3

⇒ In a transmission line, losses due to dielectric heating are
proportional to voltage and inversely proportional to Z₀
proportional to voltage and proportional to Z₀
proportional to current and proportional to Z₀
proportional to current and inversely proportional to Z₀

⇒ Magnesium is alloyed with conducting materials for antenna primarily with the purpose of
increasing efficiency
improving radiative power
reducing weight
increasing density

⇒ A FET is a __________ controlled device whereas a bipolar transistor is a __________ controlled device.
gate, drain
drain, gate
current, voltage
voltage, current

⇒ The maximum forward current in case of signal diode is in the range of
1 A to 10 A
0.1 A to 1 A
few milli amperes
few nano amperes

⇒ A control system is as shown in given figure The maximum value of gain K for which the system is stable
more than 5
equal to 5
less than 1
less than 5

⇒ The output of basic DTL configuration is
low when one of the input is high
low when all inputs are high
high when all inputs are high
high when all inputs are low

⇒ The radio horizon for space waves is about three-fourth as for as the optical horizon.
TRUE
FALSE

⇒ If a sample of germanium and a sample of Si have the impurity density and are kept at room temperature then
both will have equal value of resistivity
both will have equal -ve resistivity
resistivity of germanium will be higher than that of silicon
resistivity of Si will be higher than of germanium

⇒

Assertion (A): A common collector amplifier is used for matching a high impedance source to a low impedance load

Reason (R): A common collector amplifier has a near unity voltage gain

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ In measurements using CRO, Lissajous patterns are used to
measure magnitude of peak voltage
measure frequency
measure impedance
measure current

⇒ How can the bandwidth of a control system be increased?
By the use of phase lead network
By the use of phase lag network
By the use of both phase-lag and phase-lead network
By the use of cascaded amplifiers in the system

⇒

Match the following:

	List I (BJT amplifier)		List II (Characteristics)
A.	CE	1.	good voltage gain, good current gain
B.	CC	2.	voltage gain less than 1, high current gain
C.	CB	3.	current gain less than 1, voltage gain high

A-1, B-2, C-3
A-1, B-2, C-3
A-3, B-1, C-2
A-3, B-2, C-1

⇒ For a 400 kHz transmission line having L = 0.5 mH/km, C = 0.08 mF and negligible R and G, the velocity propagation will be
15.8303 km/s
15.830 km/s
1.583 km/s
0.1583 km/s

⇒ Manganin, an alloy of copper and manganese, is used in
Soldering material
Heating elements
Ballast resistors
Standard resistances