Question is ⇒ In 8086 the number of bytes which can be addressed directly is about, Options are ⇒ (A) 1000, (B) 10000, (C) 100000, (D) one million, (E) , Leave your comments or Download question paper.

Question is ⇒ In 8086 the number of bytes which can be addressed directly is about, Options are ⇒ (A) 1000, (B) 10000, (C) 100000, (D) one million, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In 8086 the number of bytes which can be addressed directly is about
A.	1000 [Wrong Answer]
B.	10000 [Wrong Answer]
C.	100000 [Wrong Answer]
D.	one million [Correct Answer]
View Answer 2 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ VTM stands for voltage tunable magnetron.
TRUE
FALSE

⇒ A UJT exhibits negative resistance characteristics when
Current is less than valley current
Current is less than peak current
Current is more than peak current but less than valley current
None of the above

⇒ A circuit using an op-amp is shown in the given figure. It
voltage series feedback
voltage shunt feedback
current shunt feedback
current series feedback

⇒ In a positive edge triggered JK flip flop
High J and High K produce inactive state
Low J and High K produce inactive state
Low J and Low K produce inactive state
High J and Low K produce inactive state

⇒ The real part of complex dielectric constant and tanδ for a dielectric are 2.1 and 5 x 10^-4 at 100 Hz respectively. The imaginary part of dielectric constant at 100 Hz is
1.05 x 10^-3
2.1 x 10^-3
5 x 10^-3
1.05 x 10^-2

⇒ Which of the following expressions is true for apparent power in an A.C. circuit?
VI cos Φ
V_av x I_av
V_r.m.s x I_r.m.s
V_peak x I_peak

⇒ Magnetic hysteresis phenomenon is explained by
motion of domain walls
motion of domain walls and domain rotation
domain rotation
none of the above

⇒ A Darlington emitter follower circuit is some times used in the output stage of a TTL gate in order to
increase its I_QL
reduce its I_0H
increase its speed of operation
reduce power dissipation

⇒ Two capacitors each of capacitance C and breakdown voltage V are joined in series. The capacitance and breakdown voltage of the combination is
0.5 C and 2 V
0.5 C and 0.5 V
C and V
2 C and 2 V

⇒ In a half bridge inverter, the freewheeling diodes are needed
even when load is resistive
only when load is inductive
only when load is inductive or capacitive
for all types of loads

⇒ What is the purpose of DMA facility in microprocessor based system?
To increase the speed of data transfer between the mP and the I/O devices
To increase the speed of data transfer between the mP and the memory
To increase the speed of data transfer between the memory and the I/O devices
To improve the reliability of the system

⇒ In radar system which of the following is called A scope
deflection modulation of CRT
intensity modulation of CRT
computer display
none of the above

⇒ In level clocking the output can change
on rising edge of clock cycle
on falling edge of clock cycle
during entire half cycle of the clock
none of the above

⇒ In a cellular communication system, path loss between transmitter and receiver is due to
scattering from building, trees, vehicles and other structure
reason at (a) above and due to reflections from ground only
reason at (a) and (b) above along with reflections from ionosphere only
reasons at (a), (b) and (c) above along with loss due to surface wave phenomenon

⇒ A transmission line has characteristics impedance of (75 + j 0.01) Ω and is terminated in a load impedance of (70 + j 50) Ω. The transmission coefficient will be
1.70 - j 2.97
0.08 + j 0.32
1.32 + j 1.38
1.08 + j 0.32

⇒ The binary sum of 111010₂ and 11011₂ is
1010101₂
1011001₂
1011101₂
1111111₂

⇒ The ASCII code is for information interchange by a binary code for
alphabet only
number only
alpha-numeric and other common symbols
none of these

⇒ A surge voltage
has very high magnitude and very long duration
has very high magnitude and very small duration
has very high magnitude and very small duration and can be positive or negative
can be only positive

⇒

Assertion (A): A high density IC has more diodes, transistors and resistors per unit surface area.

Reason (R): A high density IC can handle high voltages.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ Typical values of voltage gain for CE, CB and CC amplifiers are
100, 100 and 1 respectively
100, 1 and 100 respectively
100, 1 and 1 respectively
1, 100 and 100 respectively

⇒ A silicon wafer has 100 nm of oxide it and is inserted in a furnace at a temperature above 1000°C for further oxidation in dry oxygen. The oxidation rate
is independent of current oxide thickness and temperature
is independent of current oxide thickness but depends on temperature
slows down as the oxide grows
is zero as the existing oxide prevents further oxidation

⇒ In the op-amp circuit of figure, V_{0V_i
3 V_i
5 V_i
0.5 V_i}

⇒ Electrical contact materials used in switches, brushes and relays must possess
high thermal conductivity and high melting point
low thermal conductivity and low melting point
high thermal conductivity and low melting point
low thermal conductivity and high melting point

⇒ A certain sound has 10000 times more energy than another sound. The number of times it would sound stronger to a listener is
40
10000
100
10

⇒ All digital circuits can be realised using only
EX-OR gates
Multiplexers
Half adders
OR gates

⇒ A binary ladder network D/A converter requires
resistors of one value only
resistors of many different values
resistors of two different values
none of the above

⇒ Which of the following statements is incorrect regarding Balun transformer?
It changes impedance like current transformer
It changes balanced to unbalanced line
It is used to couple a co-axial line to a parallel line wire
Any of the above

⇒ Figure shows an R-L circuit. The current is i = 1 - e^-t. The rate of change of current at t = 1 secon
1 A/s
0.63 A/s
0.37 A/s
0

⇒ Between which points does UJT exhibit negative resistance characteristics
between peak and valley points
before peak point
after peak point
after valley point

⇒ The output y(t) of a continuous-time system S for the input x(t) is given
S is linear and time-invariant
S is linear and time-varying
S is non-linear and time-invariant
S is non-linear and time-varying