Question is ⇒ In 8085 microprocessor, which of the following interrupts is unmaskable interrupts?, Options are ⇒ (A) RST 5.5, (B) RST 7.5, (C) TRAP, (D) INTR, (E) , Leave your comments or Download question paper.

Question is ⇒ In 8085 microprocessor, which of the following interrupts is unmaskable interrupts?, Options are ⇒ (A) RST 5.5, (B) RST 7.5, (C) TRAP, (D) INTR, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In 8085 microprocessor, which of the following interrupts is unmaskable interrupts?
A.	RST 5.5 [Wrong Answer]
B.	RST 7.5 [Wrong Answer]
C.	TRAP [Correct Answer]
D.	INTR [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a CE amplifier circuit the emitter by pass capacitor is remove. The ac output voltage
increases
remains the same
increases or decreases
decreases

⇒ If the ratio of ac to dc load impedance of a diode detector is low, the result will be
poor AGC operation
poor AF response
negative peak clipping
diagonal clipping

⇒

Assertion (A): Power transistors are more commonly of silicon npn type.

Reason (R): The fabrication of silicon npn transistors is easy.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ When determining Thevenin's resistance of a circuit
all sources must be open circuited
all sources must be short circuited
all voltages sources must be open circuited and all current sources must be short circuited
all sources must be replaced by their internal resistances

⇒ If Nyquist plot has a encirclement of (-1 + jo) point, the system is stable if
there are no poles of G(s) H(s) in right-half plane
there is one pole of G(s) H(s) in right-half plane
there is no zeros of G(s) H(s) in right-half plane
none of the above

⇒ In high power AM transmission, modulation is done at
IF stage
buffer stage
RF stage
oscillator stage

⇒ For 0 < M < 1, the centres of M circle lie to the right of origin.
TRUE
FALSE

⇒ The directive gain of a transmitting antenna is proportional to
its cross-sectional area
square of cross-sectional area
square root of cross-sectional area
cube root of cross-sectional area

⇒ The most commonly used moving iron instruments are
repulsion type
attraction type
a combination of attraction and repulsion type
none of the above

⇒

Assertion (A): Positive feedback is not used in any circuit.

Reason (R): Positive feedback leads to instability.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ Which of the following is multiband HF receiving antenna?
Square loop
Log-periodic
Conical horn
Folded dipole

⇒ A dc voltage source is connected across a series RLC circuit, Under steady state conditions, the applied dc voltage drops entirely across the
R only
C only
L only
R and L

⇒ The lowest frequency used in satellite communications is __________ GHz.
0.8
3
18
30

⇒ Fourier analysis indicate that a square wave can be represented as
a fundamental sine wave and odd harmonics
a fundamental sine wave and even harmonics
a fundamental sine wave and harmonics
fundamental and subharmonic sine waves

⇒ The abbreviation DTL stands for
Digital Timing Logic
Diode Transistor Logic
Dynamic Transient Logic
Delayed Tracking Logic

⇒ The circuit of the given figur
full adder
magnitude comparator
parity detector
none of the above

⇒ If operator 'a' = 1 ∠120° then (1 + a) =
-a
-a²
a
-1

⇒ A(A + B) =
A
A B
AB
AB

⇒ In a line VSWR of a load is 6 dB. The reflection coefficient will be
0.033
0.33
0.66
3.3

⇒ For the K map in the given figure, the simplified expressio
x_l x₂ x₄ + x₂ x₄ + x₁ x₃
x₂ x₄ + x₂ x₄ + x₁ x₃
x₁ x₂ x₄ + x_l x₂ + x₃ x₄ + x₂x₄
x₁ x₂ + x₂ x₃ + x₃x₄

⇒ BCD numbers are useful whenever
binary to hexadecimal conversion is desired
binary to BCD conversion is desired
decimal information is transferred into or out of a digital system
none of the above

⇒ When load is coupled to class A amplifier through transformer, efficiency decreases.
TRUE
FALSE

⇒ Resistivity of copper is lower than that of nickel. When a small percentage of copper is added to nickel, the resistivity
increases
decreases
may increase or decrease
remains the same

⇒ An antenna is 30 metre high. The frequency is 1 MHz. The radiation resistance is about
1500 Ω
150 Ω
15 Ω
1.5 Ω

⇒ In the circuit of figure, PIV can be u
E_m
2 E_m
0.5 E_m
2 E_m

⇒ Consider the following as regards cumulative disribution function F(x)

0 ≤ F(x) ≤ 1
F(- ∞) = 0
F(∞) = 1
F(x₁) ≤ F(x₂) If x₁ < x₂

Out of above which are correct?
1 and 2 only
1, 2 and 3 only
1, 2, 3 and 4
2 and 4

⇒ Which of the following is NOT associated with a p-n junction?
Junction capacitance
Charge Storage Capacitance
Depletion Capacitance
Channel Length Modulation

⇒ In which of these does thermionic emission occur?
LED
LCD
VF display
None

⇒ The current I flowing in the branc
-12 A
0
0.125
-3 A

⇒ Entropies associated with an extremely unlikely message and that with an extremely likely message are respectively
0 and 0
1 and 1
1 and 0
0 and 1