Question is ⇒ In 8085 microprocessor, what is the memory address stored on the stack, when the program is interrup, Options are ⇒ (A) 0210 H, (B) 0.211 H, (C) 0118 H, (D) 020 FH, (E) , Leave your comments or Download question paper.

Question is ⇒ In 8085 microprocessor, what is the memory address stored on the stack, when the program is interrup, Options are ⇒ (A) 0210 H, (B) 0.211 H, (C) 0118 H, (D) 020 FH, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In 8085 microprocessor, what is the memory address stored on the stack, when the program is interrup
A.	0210 H [Wrong Answer]
B.	0.211 H [Correct Answer]
C.	0118 H [Wrong Answer]
D.	020 FH [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In measuring a resistance by voltmeter-ammeter method, the voltmeter can be connected either across supply or across the resistance. If the resistance is low, the voltmeters should be connected
across the supply
across the resistance
either in two positions
preferably across the supply

⇒

Assertion (A): An op-amp has high voltage gain, high input impedance and low output impedance

Reason (R): Negative feedback increases output impedance

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ A transponder is a satellite equipment which
receives a signal from Earth station and amplifies
changes the frequency of the received signal
retransmits the received signal
does all of the above-mentioned functions

⇒ The impulse response h(t) of a linear invariant continuous time system is given by h(t) = exp (- 2t) u(t), where u(t) denotes the unit step function. The output of this system to the sinusoidal input x(t) = 2cos(2t) for all time t, is
0
2^-0.25 cos (2t - 0.125p)
2^-0.5 cos (2t - 0.125p)
2^-0.5 cos (2t - 0.25p)

⇒ In a CB amplifier the maximum efficiency could be
0.99
0.85
0.5
0.25

⇒ The input impedance of a non-inverting amplifier is very low.
TRUE
FALSE

⇒ Read the following statement

Multi-processing operation permits highly efficient parallel processing at several levels.
Multi processing involves use of several processing units jointly on a common program and severally on different programs.
In multi-processing the assignment of facilities to tasks, loading of programs and monitoring of I/O activity is taken care of by operating system.

Which of the above are correct?
All
1 and 2 only
1 and 3 only
2 and 3 only

⇒ The point P in the following figure is stock at 1. The output f wil
ABC
A
AB C
A

⇒ The correct sequence of parts in klystron amplifier are
anode, catcher cavity, cathode, buncher cavity
cathode, buncher cavity, catcher cavity, cavity
anode, buncher cavity, catcher cavity, cathode
cathode, catcher cavity, anode, buncher cavity

⇒ The directivity of 20 turn helix having a = 12° circumference equal to one wavelength, will be
1.8 dB
6 dB
12 dB
18 dB

⇒ Radiation intensity in a given direction is the
energy radiated per square metre
power radiated per square metre
power radiated per unit solid angle in that direction
none of the above

⇒ A moving coil meter has a resistance of 50 ohms and a full scale deflection current of 20 mA. To convert it into a voltmeter of 0-100 V range, the series resistance should be
5000 Ω
5050 Ω
4950 Ω
505 Ω

⇒

Match the following:

	List I (Transducer)		List II (Quantity measured)
A.	LVDT	1.	Pressure
B.	Bourden gauge	2.	Temperature
C.	Strain gauge	3.	Displacement
D.	Thermistor	4.	Stress

A-4, B-3, C-2, D-1
A-3, B-2, C-1, D-4
A-4, B-1, C-3, D-2
A-3, B-1, C-4, D-2

⇒ A bridge rectifier circuit has a dc load current of 10 mA and a filter capacitance of 1000 μF. The peak to peak ripple voltage is
0.01 V
0.05 V
0.1 V
0.5 V

⇒ The contents of stack location 2109 H after the call operation wil
1111
1010101
100000
100010

⇒ A class D chopper
can operate in first quadrant only
can operate in second quadrant only
can operate in either first or fourth quadrant
can operate in all the quadrants

⇒ In figure it is desired that output wave is symmetrical.
both diodes should be similar and |V₁| = |V₂|
both diodes should be similar
|V₁| = |V₂|
either (a) or (b)

⇒ Percentage increase in the reverse saturation current of a diode if the temperature is increased from 25°C to 50°C
0.5
5
5.657
5.756

⇒ Ripple factor RF and form factor FF are related as
RF = FF² - 1
RF = (FF² - 1)^0.5
RF = FF - 1
RF = (FF - 1)^0.5

⇒ Some words like READ, WRITE, STOP etc. cannot be used as variable names in Fortran 77.
TRUE
FALSE

⇒ If A = 20 and B = - 7 in PASCAL, A mod B =
6
2
-1
3

⇒ The JFET in the circuit shown in figure has an I_DSS = 10 mA and V_p = -5V. The value of the resistance R_s for a drain current I_DS = 6.4 m
156 Ω
470 Ω
560 Ω
1 kΩ

⇒

Assertion (A): When a wattmeter is used for low impedance loads, the pressure coil is connected across the load.

Reason (R): A wattmeter measures apparent power.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ For a second order system, damping ratio ζ is such that 0 < ζ <. Then the roots of characteristic equation are
real but not equal
real and equal
complex conjugate
imaginary

⇒

Assertion (A): FM requires more bandwidth than AM

Reason (R): Wide band FM is used for broadcast transmissions.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In the circuit of figure the d
will conduct as the whole cycle
will conduct in the positive half cycle
will not conduct
will conduct from 30° to 150° in the positive half cycle

⇒ Which of the following is not used as a microwave mixer or detector?
PIN diode
Crystal diode
Schottky barrier diode
Backward diode

⇒ Resistivity of semiconductors is around 100 Ω-m.
TRUE
FALSE

⇒

Assertion (A): Fourier series can also be written in exponential form.

Reason (R): sin (n ωt) and cos (n ωt) can be expressed as sum or difference of exponentials.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ In which of the transformer is the secondary nearly short circuited under normal operating conditions?
CT
PT
Distribution transformer
Power transformer