Question is ⇒ In 8085 microprocessor, in order to enable RST 5.5, RST 6.5 and RST 7.5 interrupts, which of the following instruction are needed?, Options are ⇒ (A) EI only, (B) SIM only, (C) EI and SIM both, (D) None, (E) , Leave your comments or Download question paper.

Question is ⇒ In 8085 microprocessor, in order to enable RST 5.5, RST 6.5 and RST 7.5 interrupts, which of the following instruction are needed?, Options are ⇒ (A) EI only, (B) SIM only, (C) EI and SIM both, (D) None, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In 8085 microprocessor, in order to enable RST 5.5, RST 6.5 and RST 7.5 interrupts, which of the following instruction are needed?
A.	EI only [Wrong Answer]
B.	SIM only [Wrong Answer]
C.	EI and SIM both [Correct Answer]
D.	None [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ For a wave v = V _1m sin (ωt + θ₁ ) - V_3m sin (3ωt + θ₃), the rms value is (0.5 V²_1m + 0.5 V²_3m)^0.5
TRUE
FALSE

⇒ The range of visible light is
300 to 2000 Å
200 - 4000 Å
4000 to 7700 Å
more than 10000 Å

⇒ An 8 bit transistor register has output voltage of low-high-low-high-low-high-low-high. The decimal number stored is
105
95
85
75

⇒ In an SCR, the anode current consists of
only holes
only electrons
both electrons and holes
either electrons or holes

⇒ Using the same flip flops
a synchronous flip flop can operate at higher frequency than ripple counter
a ripple counter can operate at higher frequency than synchronous counter
both ripple and synchronous counter can operate at the same frequency
can not determine

⇒

Assertion (A): A sweep circuit operates by virtue of recurring transient phenomenon.

Reason (R): Transients are always undesirable.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ The forbidden energy gap for silicon is
0.12 eV
1.12 eV
0.72 eV
7.2 eV

⇒ In a two phasor servomotor, the direction of rotation of the rotating field depends on
magnitudes of voltages applied to the two stator windings
phase relation of voltages applied to the two stator windings
both magnitude and phase relationship of voltages applied to the two stator windings
none of the above

⇒ Which of the following power amplifiers has highest efficiency?
Class A
Class AB
Class B
Class C

⇒ In practical commercial FM system, channel bandwidth is
150 kHz
100 kHz
88 MHz
108 MHz

⇒ According to Barkhausen criteria in order to sustain the oscillations
loop gain of the circuit must be negligible
loop gain of the circuit must be equal to unity
the phase shift around the circuit must be 180°
none of the above

⇒ The current through a resistance R is shown in figure. The computed value of power
400 ± 0.42 W
400 ± 4.6 W
400 ± 8.85 W
400 ± 10.65 W

⇒ Schmitt trigger can be used as a
comparator
square-wave generator
flip-flop
all of these

⇒ 25 persons are in a room. 15 of them play hockey, 17 of them play football and 10 of them play both hockey and football. Then the number of persons playing neither hockey nor football is:
2
17
13
3

⇒ V-I relationship of a network N is given by, V = 8 -
0, 2
0, 4
2, 4
None of these

⇒

Assertion (A): The turn on time of SCR is about 1 to 4 ms.

Reason (R): The turn off time of SCR is about 10 to 300 ms.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Choose correct option for a stable system :

Roots of the characteristic equation of the system are real and negative
Area within the impulse response is finite

I is true, II is true
I is true, II is false
I is false, II is true
I is false, II is false

⇒

Match the following:

	List I (Modes)		List II (Characteristic)
A.	Evanescent	1.	Rectangular waveguide does not support
B.	Dominant mode	2.	No wave propagation
C.	TM₁₀ and TM₀₁	3.	Lowest cut-off frequency

A-1, B-2, C-3
A-2, B-3, C-1
A-1, B-3, C-2
A-2, B-1, C-3

⇒ Radiation resistance of half-wave dipole (λ/2) antenna is in free space
73 Ω
120 p
36.5 Ω
70 Ω

⇒ Photoconductive devices uses
metallic conductors
good quality insulators
semiconductors
either (a) or (c)

⇒ In the given figure the input is x(t) = A sin ωt. The steady state output y(tA sin (ωt + φ) where φ = tan^-1 |G(jω)|
|G(jω)| A sin [ωt + ∠G(jω)]
|G(jω)| A sin [2ωt + ∠G(jω)]
A G(jω) sin [ωt + ∠G(jω)]

⇒ A 4 bit ripple counter uses flip flops with propagation delay of 50 ns each. The maximum clock frequency which can be used is
5 MHz
10 MHz
20 MHz
25 MHz

⇒ The temperature below which certain materials are antiferromagnetic and above which they are paramagnetic is called
Weiss temperature
Curie temperature
Neel temperature
None of the above

⇒ In an RL series circuit the inductance is 1H and current at an instant is 0.6 A. The energy stored in magnetic field is
0.36 J
0.18 J
0.09 J
0.03 J

⇒
Match the following:
List I (Instrument) List II (Parameters)
A. Moving coil galvanometer 1. High inertia, soft spring control
B. Ballistic galvanometer 2. No control, high damping
C. Vibration galvanometer 3. Soft spring control, critical damping
D. Moving coil flux meter 4. Low inertia, tuned spring control

A-4, B-2, C-3, D-1
A-1, B-3, C-2, D-4
A-2, B-1, C-4, D-3
A-3, B-1, C-4, D-2

⇒ Transfer function of a linear system is 200 e^-j10ω The system is a
distortionless Attenuator
amplifier with Phase distortion
distortionless Amplifier
attenuator with Phase distortion

⇒ The phase difference (jω - p₁) means
phasor drawn from p₁ to jω
phasor drawn from origin to p₁
phasor directed from origin to jω point
phasor directed from jω to p₁

⇒
Assertion (A): When a square periodic wave is applied to an RC circuit, the voltage across capacitor is observed to be a triangular periodic wave.
Reason (R): The RC circuit works as integrator and its time constant is much larger than time period of input wave.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Consider the following statements in connection with CMOS inverter in figure where both the MOSFET are of enhancement type and both have a threshold voltage of
Only statement 1 is true
Only statement 2 is true
Both the statement are true
Both the statements are false

⇒ In AM, if modulation index is more than 100%, then
bandwidth increases
the wave gets distorted
power of the wave increases
efficiency of transmission increases

	List I (Instrument)		List II (Parameters)
A.	Moving coil galvanometer	1.	High inertia, soft spring control
B.	Ballistic galvanometer	2.	No control, high damping
C.	Vibration galvanometer	3.	Soft spring control, critical damping
D.	Moving coil flux meter	4.	Low inertia, tuned spring control

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math