Question is ⇒ In 8085 microprocessor, in order to enable INTR interrupt, which of the following instruction are needed?, Options are ⇒ (A) EI only, (B) SIM only, (C) El and SIM both, (D) None, (E) , Leave your comments or Download question paper.

Question is ⇒ In 8085 microprocessor, in order to enable INTR interrupt, which of the following instruction are needed?, Options are ⇒ (A) EI only, (B) SIM only, (C) El and SIM both, (D) None, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In 8085 microprocessor, in order to enable INTR interrupt, which of the following instruction are needed?
A.	EI only [Correct Answer]
B.	SIM only [Wrong Answer]
C.	El and SIM both [Wrong Answer]
D.	None [Wrong Answer]
View Answer 3 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The load circuit of a single phase full bridge inverter
must be underdamped
must be overdamped
may be underdamped or overdamped
may be any type of load

⇒ A modem is connected to PC at
serial port
parallel port
SCSI port
input port

⇒ A signal f(t) = cos 10pt + 3 cos 4pt is instantaneously sampled. The maximum allowable value of sampling interval T_s in sec is
1 / 4 sec
1 / 8 sec
1 / 8p sec
1 / 10 sec

⇒ As per Euler's identity e^jωt = cos ωt + j sin ωt
TRUE
FALSE

⇒ A network is said to be two port network if there is

no independent source in the network
no dependent source in the network
non-linear component in the circuit
no external connection exist between I/P and 0/P

1, 2, 3
3, 4, 2
1, 3, 4
4, 3, 1, 2

⇒ Which dc servomotor requires strongest permanent magnet?
Slotted armature
Surface wound armature
Surface wound with stationary rotor
Either (a) or (b)

⇒ Calculate the directivity of a given linear end fire, uniform array of 20 element, each separated by λ/3
100
10
26.66
30

⇒ A TRIAC is a semiconductor device which acts as a
2 terminal unidirectional switch
2 terminal bidirectional switch
3 terminal bidirectional switch
4 terminal multidirectional switch

⇒ A . 0 =
1
A
0
A or 1

⇒ In a series RLC circuit, the value of resistance for critical damping is
L/C
(L/C)^0.5
1/LC
2/L/C

⇒ When two port networks are connected in cascade, it is more convenient to use hybrid parameters.
TRUE
FALSE

⇒ The modulation index of wideband FM signal is
less than unity
unity
greater than unity
nearly 0.67

⇒ Which component is allowed to pass through it by a choke filter?
Dc
Ac
Both dc and ac
Only high frequency ac

⇒ Nichrome is used for
overhead line wires
heater coils
lamp filaments
all of the above

⇒ A pulse transformer uses
ferrite core
air core
iron core
copper core

⇒ In a 3 phase semiconverter, the freewheeling diode comes into operation only if firing angle
is zero
is 60°
is more than 60°
is more than 90°

⇒ When a material is in superconducting state and a magnetic field is applied
the superconducting property is not affected
the superconducting property may be affected and resistivity may increase from zero to a low value
the superconducting property may be destroyed
the material may become an insulator

⇒ The number of accumulators in 6800 are
2
3
1
4

⇒ A transmission line is feeding 1 watt of power to a horn antenna having a gain of 10 dB. The antenna is matched to the transmission line. The total power radiated by the horn antenna into the free space is
10 watts
1 watt
0.1 watt
0.01 watt

⇒ The bridge is balanced when the value of R is
50 Ω
100 Ω
200 Ω
250 Ω

⇒ RECTIFIER : OSCILLATOR ::
Capacitance : Inductance
Series resonance : Parallel resonance
DC : AC
Regulation : Efficiency

⇒ The number of programmable 16 bit registers of 6800 are
2
3
4
5

⇒ A monostable multivibrator has
no stable state
one stable state
two stable state
none of the above

⇒ In a number system with radix r, the decimal value of 110 is equal to 4r. The decimal values of 111 and r respective are equal to
20, 5
16, 4
13, 3
8, 2

⇒ A fully controlled bridge converter can operate in quadrants
1
1 and 2
1 and 3
1 and 4

⇒ In LIFO
only the top of the stack is immediately accessible
only the top of the stack is never accessible
only the first-in is accessible
only the first-in is not accessible

⇒ Ferrites are
hard materials
brittle materials
not easily machinable
materials with all above properties

⇒ Hall effect is observed in a specimen when it is carrying current and is placed in a magnetic field. The resultant electric field inside the specimen is
normal to both current and magnetic field
in the direction of current
antiparallel to magnetic field
in arbitrary direction

⇒ The input impedance of a non-inverting amplifier is very low.
TRUE
FALSE

⇒ If an electron move through a potential difference of 500 V, the energy possesses by it will be
500 ergs
500 joules
500 eV
500 mV