Question is ⇒ In 8085 microprocessor, how many I/O ports can be accessed by memory mapped method?, Options are ⇒ (A) 8, (B) 256, (C) 32 K, (D) 64 K, (E) , Leave your comments or Download question paper.

Question is ⇒ In 8085 microprocessor, how many I/O ports can be accessed by memory mapped method?, Options are ⇒ (A) 8, (B) 256, (C) 32 K, (D) 64 K, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In 8085 microprocessor, how many I/O ports can be accessed by memory mapped method?
A.	8 [Wrong Answer]
B.	256 [Wrong Answer]
C.	32 K [Correct Answer]
D.	64 K [Wrong Answer]
View Answer 2 -2 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Consider the following:

A TV receiver antenna should pick up the TV signal and develop maximum voltage from the available strength of signal
It should reject unwanted signals
It should not suffer from co-channel interference
It should have a very narrowband

The correct statements are
1 and 2 only
1, 2 and 3 only
1, 2, 3, 4
2, 3 only

⇒ The V_TH at terminals A and B is equal
0 V
5 V
- 5 V
None of these

⇒ Which of the following statement is correct?
FET and junction transistor both are unipolar
FET and junction transistor both are bipolar
The FET is bipolar, while junction transistor are unipolar
The FET is unipolar, while junction transistor are bipolar

⇒

Assertion (A): An electronic tuner uses varactor diode

Reason (R): The capacitance of a varactor diode depends on the magnitude of reverse bias.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ An SR flip flop can be built using NOR gates or NAND gates.
TRUE
FALSE

⇒ For oscillations to starts, the loop gain A β of the oscillator must be initially
less than unity
0.5
1
more than unity

⇒ A reactor is used in a dual converter operating in non-circulating current mode.
TRUE
FALSE

⇒ A resistance of 5 ohms is connected in one branch of a network. The current in this branch is 2.2. A. If the resistance is increased to 7.5 Ω, the remaining circuit being the same, the current in this branch will be
2.2 A
less than 2.2 A
2.2 A or less than 2.2 A
2.2 A or less or more than 2.2 A

⇒ The terminals of a power MOSFET are called
emitter, base, collector
source, gate, drain
source, base, drain
emitter, gate, drain

⇒ Which one of the following devices is not used as the controller in a stabilizer?
DIAC
TRIAC
SCR
Power transistor

⇒ The cut in voltages for germanium and silicon diodes respectively as
0.3 V and 0.7 V
0.7 V and 0.3 V
0.6 V and 0.9 V
0.5 V and 0.7 V

⇒ In case of synchro error detector the electrical zero position of control transformer is obtained when angular displacement between rotors is
zero
45°
90°
180°

⇒ As compared to TTL, ECL has
lower power dissipation
lower propagation delay
higher propagation delay
higher noise margin

⇒ The effect of a finite gain of operational amplifier used in an integrator is that
it would not integrator
slope of the O/P will varied with time
final value of the O/P
there will be instability in the cirucuit

⇒ In the circuit of figure the current through 3 Ω resistance at t = &infin
0.166666666666667
2.5 A
3.1 A
0

⇒ In the circuit of figure, the power consumed in resistance R is measured when one source is acting at one time. These values are 18 W, 50 W and 98 W. When all source act together the maximum and minimum power ca
98 W and 18 W
166 W and 18 W
450 W and 2 W
166 W and 2 W

⇒ As the temperature of an intrinsic semiconductor material is increased
additional holes are created in the conduction band
protons get excited
protons acquire charge
energy of the atom is increased

⇒ The initial state of MOD-16 down counter is 011. After 37 clock pulses, the state of the counter will be
1011
110
101
1

⇒ Consider the following statements

Fading of signals is generally greatest near radio horizon.
Fading of signals is generally greatest in shadow zone.
Fading is small when a good optical path is present.

Which of the above statements are correct?
1, 2 and 3
1 and 2 only
1 and 3 only
2 and 3 only

⇒ The value of the inductance of coil in which a current increases linearly from zero to 0.1A in 0.2 second producing a voltage of 5 volts is __________ .
2.5
5
10
20

⇒ For the K map in the given figure, the simplified expressio
x_l x₂ x₄ + x₂ x₄ + x₁ x₃
x₂ x₄ + x₂ x₄ + x₁ x₃
x₁ x₂ x₄ + x_l x₂ + x₃ x₄ + x₂x₄
x₁ x₂ + x₂ x₃ + x₃x₄

⇒ The correct sequence of subsystems in an FM receiver is
Mixer, RF amplifier, Limiter, IF amplifier. Discriminator, Audio amplifier
RF amplifier, Mixer, IF amplifier, Limiter, Discriminator, Audio amplifier
RF amplifier, Mixer, Limiter, Discriminator IF amplifier, Audio amplifier
Mixer, IF amplifier, RF amplifier, Audio amplifier, Discriminator

⇒ The number of channels available in MF band (300 kHz - 3 MHz) for AM modulating signal of 20 kHz is
70
67
100
150

⇒ The resistance values of a PIN diode under positive bias and negative bias respectively are about
a few ohms and a kilo ohms
about 100 ohms and 1000 ohms
about 0.1 ohm and 100 ohms
about 1000 ohms and 10000 ohms

⇒ In a 4 bit full adder how many half adders and OR gates are required
8 and 4
7 and 4
7 and 3
8 and 3

⇒ Audio amplifiers need
Bass control
Treble control
Both Bass and Treble control
Either Bass or Treble control

⇒ A logarithmic amplifier has diode in the feedback path.
TRUE
FALSE

⇒ The purpose of connecting a coupling capacitor in the output circuit of an amplifier is
to increase voltage gain
to increase collector current
to block dc collector voltage
all of the above

⇒ A 3 bit binary adder should use
3 full adders
2 full adders and 1 half adder
1 full adder and 2 half adders
3 half adders

⇒ Consider the following statement in B
200, 250, 150 respectively
150, 200, 250 respectively
250, 200, 150 respectively
200, 150, 250 respectively