Question is ⇒ In 8085 microprocessor, an active low signal INTA is not needed from up service which of the following interrupt requ, Options are ⇒ (A) TRAP, (B) INTR, (C) RST 7.5, (D) RST 5.5, (E) , Leave your comments or Download question paper.

Question is ⇒ In 8085 microprocessor, an active low signal INTA is not needed from up service which of the following interrupt requ, Options are ⇒ (A) TRAP, (B) INTR, (C) RST 7.5, (D) RST 5.5, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In 8085 microprocessor, an active low signal INTA is not needed from up service which of the following interrupt requ
A.	TRAP [Correct Answer]
B.	INTR [Wrong Answer]
C.	RST 7.5 [Wrong Answer]
D.	RST 5.5 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The impulse response of the DT - LTI system is given be
1 and 2
2 and 3
1 and 3
1, 2 and 3

⇒ A telephone user while talking to a person via a satellite has to wait for reply for about __________ millisecond.
100
270
470
540

⇒ Household tape recorders use
separate motor for each operation
only one motor for all operations
one motor for capstan and another for take up reel
a total of 3 motors

⇒ In a Darlington pair
the emitter of first transistor drives the base of the second
the base of the first transistor drives the emitter of the second
emitters of the two transistors are connected through a resistor
none of the above

⇒ A two branch tuned circuit has a coil of resistance R and inductance L in one branch and capacitance C in the second branch. If R is increased, the dynamic resistance
decreases
increases
remains constant
may increases or decreases

⇒ A flip flop is a
combinational circuit
memory element
arithmetic element
memory or arithmetic element

⇒ In a series resonant circuit, the resonant frequency is
geometric mean of half power frequencies
arithmetic mean of half power frequencies
difference of half power frequencies
none of the above

⇒ Frequency range for satellite communication is
1 kHz to 100 kHz
100 kHz to 10 MHz
10 MHz to 100 MHz
1 GHz to 30 GHz

⇒ If a driving point function N(s) = p(s)/q(s), then
the terms of lowest degree in p(s) and q(s) may differ in degree by zero only
the terms of lowest degree in p(s) and q(s) may differ by one at the most
the terms of lowest degree in p(s) and q(s) may differ in degree by two at the most
the terms of lowest degree in p(s) and q(s) may differ in degree by three at the most

⇒ The start of modern computer age was started by the event
development of disc drive
development of transistor
development of Hollerith code
design of EVIAC computer

⇒ For a quadratic factor in denominator of transfer function the phase angle at corner frequency (in Bode phase angle plot)
is -90°
is +90°
depends on the damping factor
none of the above

⇒ To turn off an SCR, it is necessary to reduce its current to less than :
trigger current
holding current
breakover current
none of the above

⇒ The maximum current and voltage ratings for a 0.5 W, 10 kW resistor are
7.07 mA and 70.7 V
70.7 mA and 70.7 V
0.707 mA and 70.7 V
7.07 mA and 70.7 x 10³ V

⇒ The value of the inductance of coil in which a current increases linearly from zero to 0.1A in 0.2 second producing a voltage of 5 volts is __________ .
2.5
5
10
20

⇒ Multiphase choppers are used in
low power circuits
high power circuit
both low and high power circuits
medium power circuits

⇒ In a flip-flop with RS latch a high S and a low R set the output to __________ and a low S and a high R set the output __________ .
low, low
high, high
low, high
high, low

⇒ Gauge factor of a strain gauge is
unit change in resistance per unit change in length
change in resistance per unit change in length
unit change in length per unit change in resistance
none of the above

⇒ Which of the following polynomials is not Hurwitz?
P₁ = s⁸ + 2s⁶ + 4s⁴
P₂ = s⁶ - 3s⁴ + 2s² + 1
P₃ = s⁴ + 3s³ + 3s² + 2s + 1
P₄ = s⁷ + 2s⁶ 2s⁴ + 4s³ + 8s² + 8s + 4

⇒ In a 3 phase system, the zero sequence component of line to line voltages is zero
if line to line voltages are balanced
if line to line voltages are unbalanced
if line to line voltages are balanced or unbalanced
if degree of unbalanced in line to line voltages is small

⇒ Consider the following statements associated with two port networks.

Z₁₂ = Z₂₁
Y₁₂ = Y₂₁
h₁₂ = h₂₁
AD - BC = 1

Which one of the statement given above are correct?
1, 2, 3
2, 3, 4
1, 3, 4
1, 2, 4

⇒ Consider the following statements about directional coupler shown in the fi
1 and 2 only
3 and 4 only
1, 2 and 3
2, 3 and 4

⇒ Giga watt is equal to
10¹² W
10⁹ W
10⁶ W
10³ W

⇒ The number of protons in a silicon atom is
32
28
14
4

⇒ Semiconductor ROM's are sometimes preferred to semiconductor RAM's because
ROM's are cheaper than RAMs
ROMs are faster
ROMs do not require power supply for their operations
Programs stored in ROMs cannot be altered either by the power failure or by the user

⇒ Curl of gradient A is
∇ x (∇A) = 1
∇ x (∇A) = ∞
∇ x (∇A) = 0
∇ x (∇A) = - ∞

⇒ If E_b is the potential of accelerating anode, the energy of electrons as they emerge from electron gun is proportional to
E_b
E_b
E_b^1.5
E_b²

⇒ The z-transform of a particular signal is gi
casual and stable
non-casual and stable
non-casual and unstable
casual and unstable

⇒ The access time of ROM using bipolar transistors is about
1 sec
1 mili sec
1 μ sec
1 n sec

⇒ When iron rod is magnetised by the flowing through its coil, the polarities of its different points wil
Pole A is N-pole, B is S-pole and C is neutral
A is N, B and C is S
A is N, C is S
A is S, C is neutral, B is N

⇒ Which of the following can be used as a buffer amplifier?
CE
CC
CB
Both (a) and (c)